Polarization dependence of excess loss of amorphous coating supermirror in optical region for cavity ringdown spectroscopy
Source abstract
Abstract
A long optical path length is critical in achieving sensitive spectroscopy. For cavity ringdown spectroscopy, a cavity consisting of two supermirrors provides a long path length, where high reflectance of the supermirrors results from their slight excess loss. In the case of a crystal coating supermirror, the excess loss has been suggested to depend on polarization. On the other hand, an amorphous coating supermirror was expected to have a negligible polarization dependence. In this work, we measured the excess loss as a function of mirror rotation around its optical axis in the optical region at 681.2 nm for the three amorphous coating supermirrors produced simultaneously by vapor deposition in the same furnace. The back mirror of the cavity was rotated, and the ringdown time as a function of rotational angle was measured every 10 degrees. As a result, sinusoidal variations in excess loss were observed depending on the rotation. The difference in excess loss between the best and worst rotational angles during the rotation of the back mirror reached a maximum of 5.8 +- 1.2 ppm. This difference demonstrates the importance of optimizing the rotational angle alignment of supermirrors to achieve high sensitivity via a long path length in cavity ringdown spectroscopy.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Atomic and Subatomic Physics Research · Mechanical and Optical Resonators · Advanced Fiber Laser Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (17)
Show source-provided references
1. Macleod · 2005 · 587504
2. Polarization dependent scattering in cavity optomagnonics10.1103/PhysRevLett.127.143601 ↗
3. Optomechanics of deformable optical cavities10.1038/nphoton.2009.42 ↗
4. Design of all-optical logic half-adder based on photonic crystal multi-ring resonator10.3390/sym15051063 ↗
5. Design of a four channel green-wavelength multiplexer based on multicore polymer optical fiber10.1016/j.optlastec.2025.113635 ↗
6. Integrated cavity output analysis of ultra-weak absorption10.1016/S0009-2614(98)00785-4 ↗
7. Laboratory optical spectroscopy of the thiophenoxy radical and its profile simulation as a diffuse interstellar band based on rotational distribution by radiation and collisions10.1088/0004-6256/148/5/87 ↗
8. Experimental demonstration of back-linked fabry-perot interferometer for a space gravitational wave antenna10.1103/PhysRevD.109.022003 ↗
9. Amorphous optical coatings of present gravitational-wave interferometers∗, class10.1088/1361-6382/ab77e9 ↗
10. Advanced virgo: a second-generation interferometric gravitational wave detector, class10.1088/0264-9381/32/2/024001 ↗
11. Mirror coating research and developments for current and future gravitational‐wave detectors10.1002/adpr.202400117 ↗
12. Measurement of ultralow supermirror birefringence by use of the polarimetric differential cavity ringdown technique10.1364/AO.39.001941 ↗
13. Birefringence-induced frequency beating in high-finesse cavities by continuous-wave cavity ring-down spectroscopy10.1103/PhysRevA.92.053817 ↗
14. Precision interferometric measurements of mirror birefringence in high-finesse optical resonators10.1103/PhysRevA.93.013833 ↗
15. Residual stress birefringence of highly reflective mirrors with different numbers of layers10.1364/AO.59.000A99 ↗
16. Effects of linear birefringence and polarization-dependent loss of supermirrors in cavity ring-down spectroscopy10.1364/AO.47.003817 ↗
17. Mid-infrared interference coatings with excess optical loss below 10 ppm10.1364/OPTICA.405938 ↗