Frequency Stabilization of Nanomechanical Resonators Using Thermally Invariant Strain Engineering
Source abstract
Abstract
Microfabricated mechanical resonators enable precision measurement techniques from atomic force microscopy to emerging quantum applications. The resonance frequency-based physical sensing combines high precision with long-term stability. However, widely used Si3N4 resonators suffer from frequency sensitivity to temperature due to the differential thermal expansion vs the Si substrates. Here we experimentally demonstrate temperature- and residual stress-insensitive 16.51 MHz tuning fork nanobeam resonators with nonlinear clamps defining the stress and frequency by design, achieving a low fractional frequency sensitivity of (2.5 ± 0.8) × 10–6 K–1, a 72× reduction. On-chip optical readout of resonator thermomechanical fluctuations allows precision frequency measurement without any external excitation at the thermodynamically limited frequency Allan deviation of ≈7 Hz/Hz1/2 and (relative) bias stability of ≈10 Hz (≈ 0.6 × 10–6) above 1 s averaging, remarkably, on par with state-of-the-art driven devices of similar mass. Both the resonator stabilization and the passive frequency readout can benefit a wide variety of micromechanical sensors.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Mechanical and Optical Resonators · Advanced MEMS and NEMS Technologies · Force Microscopy Techniques and Applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Microsystems and Nanotechnology Division, National Institute of Standards and Technology, Gaithersburg, Maryland 20899 United States
Institute for Research in Electronics and Applied Physics, University of Maryland, College Park, Maryland 20742, United States
Department of Mechanical Engineering, Worcester Polytechnic Institute, Worcester, Massachusetts 01609 United States
Funding
Center for Nanoscale Science and Technology · University of Maryland
References (23)
Show source-provided references
1. 10.1103/PhysRevB.61.996810.1103/PhysRevB.61.9968 ↗
2. 10.1103/PhysRevLett.81.454910.1103/PhysRevLett.81.4549 ↗
3. 10.1038/1992410.1038/19924 ↗
4. 10.1103/PhysRevA.100.02250810.1103/PhysRevA.100.022508 ↗
5. 10.1016/j.chemphys.2013.02.02110.1016/j.chemphys.2013.02.021 ↗
6. 10.1063/1.470491410.1063/1.4704914 ↗
7. 10.1063/1.493220110.1063/1.4932201 ↗
8. 10.1038/nnano.2017.10110.1038/nnano.2017.101 ↗
9. 10.1126/science.aar693910.1126/science.aar6939 ↗
10. 10.1116/1.58130210.1116/1.581302 ↗
11. 10.1088/0960-1317/26/4/04501210.1088/0960-1317/26/4/045012 ↗
12. 10.1063/1.356701210.1063/1.3567012 ↗
13. 10.1109/JMEMS.2012.220590310.1109/JMEMS.2012.2205903 ↗
14. 10.1109/JMEMS.2009.203593210.1109/JMEMS.2009.2035932 ↗
15. 10.1038/nnano.2011.18010.1038/nnano.2011.180 ↗
16. 10.1364/OE.20.01826810.1364/OE.20.018268 ↗
17. 10.1021/acs.nanolett.7b0240410.1021/acs.nanolett.7b02404 ↗
18. 10.1364/OPTICA.3.00120510.1364/OPTICA.3.001205 ↗
19. 10.1038/nnano.2016.1910.1038/nnano.2016.19 ↗
20. 10.1038/ncomms386010.1038/ncomms3860 ↗
21. Wang, M.; Aksyuk, V. Thermodynamic Limit for Linear Harmonic Oscillator Resonance Frequency Measurement. arXiv (Applied Physics), 2001.10612, ver. 1, submitted on 11/20/2019, accessible on 01/29/2020. https://arxiv.org/abs/2001.10612.
22. 10.1109/29.4554710.1109/29.45547 ↗
23. Howe, D. A.; Allan, D. W.; Barnes, J. A. Properties of Signal Sources and Measurement Methods. Proceedings of the Thirty Fifth Annual Frequency Control Symposium, May 27–29, 1981, Philadelphia, PA; IEEE: New York, 1981; pp 1–47.10.1109/FREQ.1981.200541 ↗