Making the Most of a Scarce Platinum-Group Metal: Conductive Ruthenia Nanoskins on Insulating Silica Paper
Source abstract
Abstract
Subambient thermal decomposition of ruthenium tetroxide from nonaqueous solution onto porous SiO(2) substrates creates 2-3 nm thick coatings of RuO(2) that cover the convex silica walls comprising the open, porous structure. The physical properties of the resultant self-wired nanoscale ruthenia significantly differ depending on the nature of the porous support. Previously reported RuO(2)-modified SiO(2) aerogels display electron conductivity of 5 x 10(-4) S cm(-1) (as normalized to the geometric factor of the insulating substrate, not the conducting ruthenia phase), whereas RuO(2)-modified silica filter paper at approximately 5 wt % RuO(2) exhibits approximately 0.5 S cm(-1). Electron conduction through the ruthenia phase as examined from -160 to 260 degrees C requires minimal activation energy, only 8 meV, from 20 to 260 degrees C. The RuO(2)(SiO(2)) fiber membranes are electrically addressable, capable of supporting fast electron-transfer reactions, express an electrochemical surface area of approximately 90 m(2) g(-1) RuO(2), and exhibit energy storage in which 90% of the total electron-proton charge is stored at the outer surface of the ruthenia phase. The electrochemical capacitive response indicates that the nanocrystalline RuO(2) coating can be considered to be a single-unit-thick layer of the conductive oxide, as physically stabilized by the supporting silica fiber.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Supercapacitor Materials and Fabrication · Transition Metal Oxide Nanomaterials · Electrocatalysts for Energy Conversion
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Surface Chemistry Branch, Code 6170, Naval Research Laboratory, Washington, D.C. 20375, and Physics Department, Stop 9c, 572c Holloway Road, U.S. Naval Academy, Annapolis, Maryland 21402
References (31)
Show source-provided references
1. Emsley J. · 1989
2. Adams D. · J. Phys. Chem. B · 2003 · 107 · 666810.1021/jp0268462 ↗
3. Schafer H. · Anorg. Allg. Chem. · 1963 · 319 · 372
4. Dmowski W. · J. Phys. Chem. B · 2002 · 106 · 1267710.1021/jp026228l ↗
5. Rolison D. R. · Langmuir · 1999 · 15 · 77410.1021/la9807863 ↗
6. Zheng J. P. · J. Electrochem. Soc. · 1995 · 142 · 269910.1149/1.2050077 ↗
7. Jow T. R. · J. Electrochem. Soc. · 1998 · 145 · 4910.1149/1.1838209 ↗
8. Lytle J. C. · J. Mater. Chem. · 2007 · 17 · 129210.1039/b614433k ↗
9. Ryan J. V. · Nature · 2000 · 406 · 16910.1038/35018040 ↗
10. The SiO2fiber membranes are equilibrated at either −78 °C (dry ice/acetone) or 0 °C (aqueous ice bath) with a chilled petroleum ether solution of RuO4previously extracted from aqueous RuO4(Strem Chemicals). Upon warming to room temperature, RuO4decomposes to O2and RuO2, the latter of which deposits as ∼2 nm particles onto the SiO2surfaces, turning the initially white SiO2membrane black (Figure1a). A fine black powder also forms in the reaction vessel as disordered ruthenia aggregates to ∼30 nm in size and precipitates. This byproduct can be reclaimed and ultimately recycled back to RuO4for subsequent depositions. Materials and methods are available asSupporting Information.
11. The weight loading of RuO2in the calcined composite was determined for all samples using a microbalance and verified for selected samples by commercial elemental analysis by ICP-AES.
12. Because SEM analyzes only a small portion of the sample, we imaged numerous RuO2(SiO2) composites prepared under nominally similar conditions, confirming the reproducibility of the synthesis.
13. To determine the volume fraction of RuO2that coats the silica paper, we divide the mass of RuO2in the sample (determined after calcination to 200 °C) by the bulk density of rutile RuO2(6.97 g cm−3) and divide by the geometric volume of the RuO2(SiO2) paper. The primary measurement uncertainty lies in determining the thickness of the silica paper. We use a micrometer to determine thickness, which can compress the paper to yield a lower calculated object volume; this uncertainty would yield an underestimation of actual volume by no more than 15%.
14. The nanoscopic 200 °C calcined RuO2was pressed into a 1 cm × 0.16 cm × 0.17 cm pellet with a mass of 70.3 mg; the conductivity (four-terminal measurement) was divided by the geometric pellet density to obtain the density-normalized conductivity. For bulk RuO2, we divide the known intrinsic conductivity of polycrystalline RuO2(∼100 S cm−1) by the theoretical density. For the RuO2(SiO2) composite, we divide the measured conductivity (four-terminal measurement) by the density of RuO2in the composite.
15. Sze, S. M.Semiconductor Devices: Physics and Technology;Wiley:New York, 2000; p53.
16. Wang H. · Acc. Chem. Res. · 2007 · 40 · 5310.1021/ar0401045 ↗
17. Cox P. A. · J. Solid State Chem. · 1986 · 62 · 36010.1016/0022-4596(86)90251-3 ↗
18. Hones P. · Appl. Phys. Lett. · 1995 · 67 · 307810.1063/1.114870 ↗
19. Glassford K. M. · Phys. Rev. B · 2004 · 49 · 710710.1103/PhysRevB.49.7107 ↗
20. Sahul R. · Sens. Actuators, A · 2006 · 125 · 35810.1016/j.sna.2005.08.008 ↗
21. Lodi G. · Surf. Technol. · 1981 · 14 · 33510.1016/0376-4583(81)90039-X ↗
22. Iles G. S. · Platinum Met. Rev. · 1967 · 11 · 12610.1595/003214067X114126129 ↗
23. Trasatti S. · Electrochim. Acta · 1991 · 36 · 22510.1016/0013-4686(91)85244-2 ↗
24. Zheng J. P. · J. Electrochem. Soc. · 1995 · 142 · L610.1149/1.2043984 ↗
25. Rolison D. R. · J. Electrochem. Soc. · 1979 · 126 · 40710.1149/1.2129053 ↗
26. Conway B. E. · 199910.1007/978-1-4757-3058-6 ↗
27. Ardizzone S. · Electrochim. Acta · 1990 · 35 · 26310.1016/0013-4686(90)85068-X ↗
28. Long J. W. · Prepr. Pap.—Am. Chem. Soc., Div. Fuel Chem. · 2006 · 51 · 41
29. The percentage of RuO2formula units that are surface-sited for a given particle size was calculated assuming the RuO2particles have the theoretical density of 6.97 g cm−3and the RuO2unit cell parameters area=b= 0.451 nm andc= 0.311 nm. For a 3 nm spherical particle the volume and surface area are 14.14 nm3and 28.27 nm2, respectively. This volume equates to 9.8 × 10−20g of RuO2or 446 RuO2formula units per particle. If one assumes that the larger unit cell faces (a×b= 0.203 nm2) are expressed on the surfaces of the particle, then 140 unit cells will be surface-sited on the 3 nm particle. Each unit cell contains 2 RuO2formula units equating to 280 RuO2units at the surface, which is 63% of the total RuO2units in the 3 nm particle.
30. Yang Q.-H. · New Carbon Mater. · 2008 · 23 · 97
31. The thickness was calculated by dividing the bulk density of rutile RuO2(6.97 g cm−3) by the electrochemically measured specific surface area (90 × 104cm2g−1) and multiplied by 2 to compensate for the half of the RuO2shell hidden by the silica substrate.