journal article·2022-11Open access

Development of Cr and Al Pack Cementation Coatings on Co-Based γ/γ′ Superalloys

Till König, S. P. Hagen, S. Virtanen, M. C. Galetz

Abstract

Abstract Co-based superalloys have been developed as candidate materials to replace Ni-based superalloys in hot sections of turbine engines, however, their oxidation resistance is limited. Therefore, in this work chromium and aluminum diffusion coatings were developedviathe pack cementation process for novelγ/γ′-strengthened superalloys of the Co–Ni–Al–W system. This alloy system also offers the opportunity to vary the cobalt-to-nickel ratio and the tungsten content systematically to investigate their influence on the coating process. The coating process was shown to successfully enrich the surfaces of such alloys either in aluminum or chromium. For Al, the result was the formation of (Co, Ni)Al on top of an interdiffusion zone, while for chromium a Cr-rich layer in solid solution with the substrate along with the formation ofσ-phase were observed. The coating formation mechanisms are discussed for both coatings in the light of activities and phase formation.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: High-Temperature Coating Behaviors · High Temperature Alloys and Creep · Advanced materials and composites

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (32)

Show source-provided references
1. N. Volz, C.H. Zenk, R. Cherukuri, T. Kalfhaus, M. Weiser, S.K. Makineni, C. Betzing, M. Lenz, B. Gault, S.G. Fries, J. Schreuer, R. Vaßen, S. Virtanen, D. Raabe, E. Spiecker, S. Neumeier, and M. Göken: Metall. Mater. Trans. A, 2018, vol. 49A, pp. 4099–4109.10.1007/s11661-018-4705-1 ↗
2. A. Bauer, S. Neumeier, F. Pyczak, and M. Göken: Scripta Mater., 2010, vol. 63, pp. 1197–1200.10.1016/j.scriptamat.2010.08.036 ↗
3. E.T. McDevitt: Mater. Sci. Forum, 2014, vol. 783–786, pp. 1159–64.10.4028/www.scientific.net/MSF.783-786.1159 ↗
4. J. Sato, T. Omori, K. Oikawa, I. Ohnuma, R. Kainuma, and K. Ishida: Science, 2006, vol. 312, pp. 90–91.10.1126/science.1121738 ↗
5. M. Weiser, M.C. Galetz, R.J. Chater, and S. Virtanen: J. Electrochem. Soc., 2020, vol. 167, p. 21504.10.1149/1945-7111/ab69f7 ↗
6. M.C. Galetz: Coatings for Superalloys, IntechOpen, 2015. https://www.intechopen.com/citation-pdf-url/49100.10.5772/61141 ↗
7. R. Darolia: Int. Mater. Rev., 2013, vol. 58, pp. 315–48.10.1179/1743280413Y.0000000019 ↗
8. G.W. Goward and L.W. Cannon: J. Eng. Gas Turbines Power, 1988, vol. 110, pp. 150–54.10.1115/1.3240078 ↗
9. R. Bianco and R.A. Rapp: in Metallurgical and Ceramic Protective Coatings. K.H. Stern, ed., Chapman & Hall, London, 1996, pp. 236–60.10.1007/978-94-009-1501-5_9 ↗
10. G.W. Goward and D.H. Boone: Oxid. Met., 1971, vol. 3, pp. 475–95.10.1007/BF00604047 ↗
11. C. Duret, R. Mevrel, and R. Pichoir: in Surface Engineering: Surface Modification of Materials. R. Kossowsky and S.C. Singhal, eds., Springer, Dordrecht, 1984, pp. 452–68.10.1007/978-94-009-6216-3_30 ↗
12. C.-L. Li, Y.-T. Lin, and J.-W. Lee: Surf. Coat. Technol., 2009, vol. 204, pp. 1106–1111.10.1016/j.surfcoat.2009.07.035 ↗
13. C.H. Zenk, N. Volz, C. Zenk, P.J. Felfer, and S. Neumeier: Curr. Comput. Aided Drug Des., 2020, vol. 10, p. 1058.
14. Y. Chen, Z. Liu, S.P. Ringer, Z. Tong, X. Cui, and Y. Chen: Cryst. Growth Des., 2007, vol. 7, pp. 2279–81.10.1021/cg070514a ↗
15. X.L. Liu, G. Lindwall, T. Gheno, and Z.-K. Liu: CALPHAD, 2016, vol. 52, pp. 125–42.10.1016/j.calphad.2015.12.007 ↗
16. T. Omori, J. Sato, K. Shinagawa, I. Ohnuma, K. Oikawa, R. Kainuma, and K. Ishida: J. Phase Equilib. Diffus., 2014, vol. 35, pp. 178–85.10.1007/s11669-014-0292-z ↗
17. S. Shankar and L.L. Seigle: Metall. Trans. A, 1978, vol. 9, pp. 1467–76.10.1007/BF02661819 ↗
18. M. Karunaratne, D.C. Cox, P. Carter, and R.C. Reed: in Superalloys 2000: Proceedings of the Ninth International Symposium on Superalloys, September 17–21, 2000, Seven Springs, PA, T.M. Pollock, ed., The Minerals Metals & Materials Society TMS, Warrendale, PA, 2000, pp. 263–72.10.7449/2000/Superalloys_2000_263_272 ↗
19. M. Karunaratne and R.C. Reed: Acta Mater., 2003, vol. 51, pp. 2905–19.10.1016/S1359-6454(03)00105-8 ↗
20. Y.M. Youssef, P.D. Lee, K.C. Mills, and R.C. Reed: Mater. Sci. Technol., 2010, vol. 26, pp. 1173–76.10.1179/026708310X12701095964720 ↗
21. R. Pichoir and J.M. Hauser: Environmental Degradation of High Temperature Materials: Spring Residential Conference, Douglas, Isle of Man, 1980, 6/1–6/21.
22. C.C. Jia, K. Ishida, and T. Nishizawa: Metall. Mater. Trans. A, 1994, vol. 25A, pp. 473–85.10.1007/BF02651589 ↗
23. V. Raghavan: J. Phase. Equilib. Diffus., 2009, vol. 30, pp. 281–82.10.1007/s11669-009-9523-0 ↗
24. D. Kubacka, M. Weiser, and E. Spiecker: Corros. Sci., 2021, vol. 191, p. 109744.10.1016/j.corsci.2021.109744 ↗
25. T. Galiullin, A. Chyrkin, R. Pillai, R. Vassen, and W.J. Quadakkers: Surf. Coat. Technol., 2018, vol. 350, pp. 359–68.10.1016/j.surfcoat.2018.07.020 ↗
26. G.H. Meier, F.S. Pettit, and A.S. Khan: Rapid Solidification Processing, Principles and Technologies, III, R. Mehrabian, ed., 1982, pp. 348–59.
27. A.R. Castle and D.R. Gabe: Int. Mater. Rev., 1999, vol. 44, pp. 37–58.10.1179/095066099101528216 ↗
28. H.M. Mazille: Thin Solid Films, 1980, vol. 65, pp. 67–74.10.1016/0040-6090(80)90058-9 ↗
29. B. Gaillard-Allemand, M. Vilasi, T. Belmonte, C. Rives, T. Czerwiec, F. Belnet, O. Kerrec, and H. Michel: MSF, 2001, vol. 369–372, pp. 735–42.10.4028/www.scientific.net/MSF.369-372.735 ↗
30. J. Chang, Y. Li, H. Shi, L. Sun, and Y. Cui: Proceedings of the 5th China Aeronautical Science and Technology Conference, 1st ed., Springer, Singapore, 2022, pp. 861–70.10.1007/978-981-16-7423-5_86 ↗
31. N. Zhao, W. Liu, J.-J. Wang, X.-G. Lu, and L. Zhang: CALPHAD, 2020, vol. 71, p. 101996.10.1016/j.calphad.2020.101996 ↗
32. P. Wang, B. Hu, X. Huang, and C. Zheng: CALPHAD, 2021, vol. 73, p. 102252.10.1016/j.calphad.2021.102252 ↗