In Situ Synchrotron Studies of Reversible and Irreversible Non-elastic Strain in a Two-Phase TiAl Alloy
Source abstract
Abstract
This paper contrasts the cyclic tensile loading of two-phase titanium aluminide Ti-44Al-8Nb-1B microstructures, namely fully lamellar (FL) and duplex (DP). The former, in contrast to the latter, shows premature yielding and hysteresis loops on cycling. These phenomena were studied by in situ cyclic loading of these specimens using high energy synchrotron X-ray diffraction. The results show significant differences in the micromechanics of deformation. Load transfer between the c and a2 phases has been identified at stresses below the macroscopic yield point in the FL microstructure, while the DP microstructure showed no signs of such load transfer before its well-defined macroscopic yield point. A partially reversible pseudo-plastic deformation mechanism seems to be operating at relatively low stresses in the FL specimen. This mechanism is believed to be twinning/partial reversible twinning of the c phase. The presence of twins at relatively low applied stresses has been confirmed for the FL microstructure by electron channeling contrast imaging. Further support of twinning/partial reversible twinning in FL but not DP microstructures below the macroscopic yield point was obtained by following the evolution of the integrated intensity of particular diffraction peaks measured during the in situ synchrotron X-ray experiments. © The Minerals, Metals & Materials Society and ASM International 2013.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Intermetallics and Advanced Alloy Properties · MXene and MAX Phase Materials · Inorganic Chemistry and Materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (38)
Show source-provided references
1. Dimiduk D: Mater. Sci Eng A, 1999, vol. 263, pp. 281-288.10.1016/S0921-5093(98)01158-7 ↗
2. F. Appel and M. Oehring: in Titanium and Titanium Alloys, ch. γ-Titanium Aluminide Alloys: Alloy Design and Properties Chapter 1, Wiley-VCH, New York, 2003.
3. E.A. Loria: Intermetallics, 2001, vol. 9, pp. 997-1001.10.1016/S0966-9795(01)00064-4 ↗
4. C. Liu, J. Stringer, J.N. Mundi, L. Horton, and P. Angelini: Intermetallics, 1997, vol. 5, pp. 579-596.10.1016/S0966-9795(97)00045-9 ↗
5. A. Lasalmonie: Intermetallics, 2006, vol. 14, pp. 1123-29.10.1016/j.intermet.2006.01.064 ↗
6. D. Hu, A. Huang, H. Jiang, N. Mota-Solis and X. Wu: Intermetallics, 2006, vol. 14, pp. 82–90.10.1016/j.intermet.2005.04.016 ↗
7. M. Werwer and A. Cornec: Int. J. Plast., 2006, vol. 22, pp. 1683–98.10.1016/j.ijplas.2006.02.005 ↗
8. M.J. Blackburn: in The Science, Technology and Application of Titanium, Pergamon Press, London, 1970.
9. M. Yamaguchi and Y. Umakoshi: Prog. Mater. Sci., 1990, vol. 34, pp. 1–148.10.1016/0079-6425(90)90002-Q ↗
10. W.T. Marketz, F.D. Fischer, and H. Clemens: Int. J. Plast., 2003, vol. 19, pp. 281–321.10.1016/S0749-6419(01)00036-5 ↗
11. H. Inui, M. Oh, A. Nakamura, and M. Yamaguchi: Acta Metall. Mater., 1992, vol. 40, pp. 3095–3104.10.1016/0956-7151(92)90472-Q ↗
12. F. Appel and R. Wagner: Mater. Sci. Eng. R, 1998, vol. 22, pp. 187–268.10.1016/S0927-796X(97)00018-1 ↗
13. R. Botten, X. Wu, D. Hu and M. Loretto: Acta Mater., 2001, vol. 49, pp. 1687–91.10.1016/S1359-6454(01)00091-X ↗
14. F. Kauffman, T. Bidlingmaier, G. Dehm, A. Wanner, and H. Clemens: Intermetallics, 2000, vol. 8, pp. 823–30.10.1016/S0966-9795(00)00025-X ↗
15. C.H. Caceres, T. Sumitomo, and M. Veidt: Acta Mater., 2003, vol. 51, pp. 6211–18.10.1016/S1359-6454(03)00444-0 ↗
16. G. Mann, T. Sumitomo, C.H. Caceres, and J. Griffiths: Mater. Sci. Eng. A, 2007, vol. 456, pp. 138–46.10.1016/j.msea.2006.11.160 ↗
17. Wu, X., Hu, D., Preuss, M., Withers, P. J., & Loretto, M. H. Intermetallics 2004 12(3), 281–287.10.1016/j.intermet.2003.10.006 ↗
18. D. Dye, H.J. Stone, and R.C. Reed: Curr. Opin. Solid State Mater. Sci., 2001, vol. 5, pp. 31–37.10.1016/S1359-0286(00)00019-X ↗
19. A.M. Korsunsky, K.E. Wells, and P. Withers: Scripta Mater., 1998, vol. 39, pp. 1705–12.10.1016/S1359-6462(98)00385-6 ↗
20. T. Ungar, S. Ott, P.G. Sanders, A. Borbely, and J.R. Weertman: Acta Mater., 1998, vol. 46, pp. 3693–99.10.1016/S1359-6454(98)00001-9 ↗
21. T. Novoselova, S. Malinov, W. Sha, and A. Zhecheva: Mater. Sci. Eng. A, 2004, vol 371, pp. 103–12.10.1016/j.msea.2003.12.015 ↗
22. K.-D. Liss, A. Bartels, A. Scheyer, and H. Clemens: Textures Microstruct., 2003, vol. 35, pp. 219–52.10.1080/07303300310001634952 ↗
23. H. Clemens, H.F. Chladil, W. Wallgram, G.A. Zickler, R. Gerling, K.-D. Liss, S. Kremmer, V. Guther, and W. Smarsly: Intermetallics, 2008, vol. 16(6), pp. 827–33.10.1016/j.intermet.2008.03.008 ↗
24. Liss, K.-D., & Yan, K. Mat Sci Eng A 2010, 528(1), 11–27.10.1016/j.msea.2010.06.017 ↗
25. O. Shuleshova, D. Holland-Moritz, W. Löser, A. Voss, H. Hartmann, U. Hecht, V.T. Witusiewicz, D.M. Herlach, B. Büchner: Acta Mater., 2010, vol. 58(7), pp. 2408–18.10.1016/j.actamat.2009.12.027 ↗
26. S.L. Raghunathan, A.M. Stapleton, R.J. Dashwood, M. Jackson, and D. Dye: Acta Mater., 2007, vol. 55, pp. 6861–72.10.1016/j.actamat.2007.08.049 ↗
27. J. Daniels, and M. Drakopoulos: J. Synchrotron Radiat., 2009, vol. 16, pp. 463–68.10.1107/S0909049509015519 ↗
28. A. Hammersley, S. Svenson, M. Hanfland, A. Fitch, and D. Hausserman: High Press. Res., 1996, vol. 14, pp. 235–48.10.1080/08957959608201408 ↗
29. Krawitz A.D. Introduction to diffraction in materials science and engineering. New York:John Wiley and Sons LTD. 2001.
30. M.A. Crimp: Microsc. Res. Tech., 2006, vol. 69, pp. 374–81.10.1002/jemt.20293 ↗
31. B. Simkin, B. Ng, T. Bieler, M. Crimp, and D. Mason: Intermetallics, 2003, vol. 49, pp. 149–54.
32. P. Prangnell, T. Downes, W. Stobbs, and P.J. Withers: Acta Metall. Mater., 1994, vol. 42, pp. 3425–36.10.1016/0956-7151(94)90475-8 ↗
33. P. Prangnell, T. Downes, P.J. Withers, and W. Stobbs: Acta Metall. Mater., 1994, vol. 42, pp. 3437–42.10.1016/0956-7151(94)90476-6 ↗
34. E. Goo, T. Duerig, K. Melton, and R. Sinclair: Acta Metall., 1985, vol. 33, pp. 1725–33.10.1016/0001-6160(85)90167-1 ↗
35. J. Bohm, A. Wanner, R. Kampmann, H. Franz, K.-D. Liss, A. Schreyer, and H. Clemens: Nucl. Instrum. Methods B, 2003, vol. 200, pp. 315-22.10.1016/S0168-583X(02)01694-4 ↗
36. H. Jiang, F.A. Garcia-Pastor, D. Hu, X. Wu, M. Loretto, M. Preuss, and P.J. Withers: Acta Mater., 2009, vol. 57, pp. 1357–66.10.1016/j.actamat.2008.11.029 ↗
37. K. Kishida, H. Inui, and M. Yamaguchi: Philos. Mag. A, 1998, vol. 78, pp. 1–28.10.1080/014186198253660 ↗
38. B. Skrotski: Acta Mater., 2000, vol. 48, pp. 851–62.10.1016/S1359-6454(99)00385-7 ↗