journal article·2011-11Open access

Shear Behavior of AA6061 Aluminum in the Semisolid State Under Isothermal and Nonisothermal Conditions

E. Giraud, M. Suery, M. Coret

Abstract

The shear behavior of a 6061 aluminum alloy was studied in the semisolid state at large solid fractions. The tests were carried out either at constant temperature after partial solidification (i.e., isothermal shear tests) or during solidification at low cooling rate (i.e., nonisothermal shear tests). In isothermal conditions, results show that (1) the mechanical behavior depends on the volume fraction of the solid phase present in the sample at the temperature of the test, (2) there is a critical solid fraction corresponding to the coalescence of the solid grains beyond which shear stress increases very sharply with increasing solid fraction, and (3) the mushy alloy exhibits viscoplastic behavior with a strain-rate-sensitivity parameter close to about 0.17. In nonisothermal conditions, results show that stress increases continuously with decreasing temperature whatever the strain rate. However, at high strain rate, it was observed that cracks developed when the solid fraction approaches 1, leading to a slower stress increase compared to that observed at low strain rate. Finally, modeling of this behavior is carried out by considering a cohesion parameter of the solid phase, which depends on solid fraction and strain rate.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Aluminum Alloy Microstructure Properties · Aluminum Alloys Composites Properties · Microstructure and mechanical properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (27)

Show source-provided references
1. D.G. Eskin, Suyitno, and L. Katgerman: Progr. Mater. Sci., 2004, vol. 49, pp. 629–711.10.1016/S0079-6425(03)00037-9 ↗
2. A.K. Dahle and L. Arnberg: JOM, 1996, vol. 48, pp. 34–37.10.1007/BF03222888 ↗
3. M. Rappaz, J.M. Drezet, and M. Gremaud: Metall. Mater. Trans. A, 1999, vol. 30A, pp. 449–55.10.1007/s11661-999-0334-z ↗
4. E. Giraud, M. Suéry, J. Adrien, E. Maire, and M. Coret: in Hot Cracking Phenomena in Welds III, 1st ed., T. Böllinghaus, C. Lippold, and C.E. Cross, eds., Springer, 2011, pp. 87–101.10.1007/978-3-642-16864-2_6 ↗
5. E. Giraud, M. Suéry, and M. Coret: Metall. Mater. Trans. A, 2010, vol. 41A, pp. 2257–68.10.1007/s11661-010-0268-5 ↗
6. D. Fabrègue, A. Deschamps, M. Suéry, and W.J. Poole: Metall. Mater. Trans. A, 2006, vol. 37A, pp. 1459–67.10.1007/s11661-006-0090-2 ↗
7. O. Ludwig, J.M. Drezet, C.L. Martin, and M. Suéry: Metall. Mater. Trans. A, 2005, vol. 36A, pp. 1525–35.10.1007/s11661-005-0244-7 ↗
8. B. Magnin, L. Maenner, L. Katgerman, and S. Engler: Mater. Sci. Forum, 1996, vols. 217–222, pp. 1209–14.10.4028/www.scientific.net/MSF.217-222.1209 ↗
9. W.M. van Haaften, W.H. Kool, and L. Katgerman: Mater. Sci. Forum, 2000, vols. 331–337, pp. 265–70.10.4028/www.scientific.net/MSF.331-337.265 ↗
10. C.E. Cross: in Hot Cracking Phenomena in Welds, T. Bollinghaus and H. Herold, eds., 2005, pp. 3–18.
11. S. Terzi, L. Salvo, M. Suéry, N. Limodin, J. Adrien, E. Maire, Y. Pannier, M. Bornert, D. Bernard, M. Felberbaum, M. Rappaz, and E. Boller: Scripta Mater., 2009, vol. 61, pp. 449–52.10.1016/j.scriptamat.2009.04.041 ↗
12. D. Fabrègue, A. Deschamps, M. Suéry, and W.J. Poole: Mater. Sci. Forum, 2006, vols. 519–521, pp. 1877–82.10.4028/www.scientific.net/MSF.519-521.1877 ↗
13. M.G. Chu and A. Granger: Mater. Sci. Forum, 1996, vols. 217–222, pp. 1505–10.10.4028/www.scientific.net/MSF.217-222.1505 ↗
14. A.K. Dahle, S. Instone, and T. Sumitomo: Metall. Mater. Trans. A, 2003, vol. 34A, pp. 105–13.10.1007/s11661-003-0212-z ↗
15. M.R. Twite, J.A. Spittle, and S.G.R. Brown: Int. J. Form. Processes, 2004, vol. 7, pp. 233–60.10.3166/ijfp.7.233-260 ↗
16. E. Giraud, M. Suéry, and M. Coret: Proc. 12th Int. Conf. on Aluminum Alloys, The Japan Institute of Light Metals, Tokyo, 2010, pp. 167–72.
17. O. Ludwig, C.L. Martin, and M. Suéry: Mater. Sci. Forum, 2002, vols. 396–402, pp. 265–70.10.4028/www.scientific.net/MSF.396-402.265 ↗
18. O. Ludwig, J.M. Drezet, P. Ménésès, C.L. Martin, and M. Suéry: Mater. Sci. Eng. A, 2005, vols. 413–414, pp. 174–79.10.1016/j.msea.2005.09.087 ↗
19. C.L. Martin, S.B. Brown, D. Favier, and M. Suéry: Acta Mater., 2006, vol. 54, pp. 5209–20.10.1016/j.actamat.2006.06.027 ↗
20. A.K. Dahle and L. Arnberg: Acta Mater., 1997, vol. 45, pp. 547–59.10.1016/S1359-6454(96)00203-0 ↗
21. B.S. Bokstein: Mater. Sci. Forum, 1996, vols. 217–222, pp. 685–88.10.4028/www.scientific.net/MSF.217-222.685 ↗
22. X. Doré, H. Combeau, and M. Rappaz: Acta Mater., 2000, vol. 48, pp. 3951–62.10.1016/S1359-6454(00)00177-4 ↗
23. F.R.N. Nabarro: Acta Mater., 2006, vol. 54, pp. 263–95.10.1016/j.actamat.2005.08.021 ↗
24. H.J. McQueen, E. Fry, and J. Belling: JMEPEG, 2001, vol. 10, pp. 179–83.10.1361/105994901770345178 ↗
25. M.S. Soliman: J. Mater. Sci., 1987, vol. 22, pp. 3529–32.10.1007/BF01161453 ↗
26. S. Spigarelli, E. Evangelista, and H.J. McQueen: Scripta Mater., 2003, vol. 49, pp. 179–83.10.1016/S1359-6462(03)00206-9 ↗
27. E.A. El-Danaf, A.A. Almajid, and M.S. Soliman: JMEPEG, 2008, vol. 17, pp. 572–79.10.1007/s11665-007-9173-5 ↗