journal article·2014-08Open access

Thick Low-Friction nc-MeC/a-C Nanocomposite Coatings on Ti-6Al-4V Alloy: Microstructure and Tribological Properties in Sliding Contact with a Ball

Sławomir Zimowski, Tomasz Moskalewicz, Bogdan Wendler, Marcin Kot, Aleksandra Czyrska-Filemonowicz

Abstract

Abstract In this paper, we show that duplex surface treatment, combining oxygen diffusion hardening with the subsequent deposition of thick, low-friction nanocomposite nc-MeC/a-C coatings to improve the tribological properties of the Ti-6Al-4V alloy. We have synthesized, in a magnetron sputtering process, the nanocomposite nc-MeC/a-C coatings (where Me denotes W or Ti transition metal) consisting of two dissimilar materials (nanocrystallites of transition metal carbides MeC and an amorphous carbon matrix a-C). The nano and microstructure of the substrate material and coatings were examined with the use of scanning and transmission electron microscopy as well as by X-ray diffractometry. It was found that different carbide nanocrystals of the same transition metal were embedded in an amorphous carbon matrix of both coatings. The HRTEM analysis indicated that the volume fraction of tungsten carbides in the nc-WC/a-C coating was equal to 13 pct, whereas in the nc-TiC/a-C one the volume fraction of the titanium carbides was equal to just 3 pct. The tribological properties, hardness, and scratch resistance of the coatings were investigated as well. The coefficient of friction (COF) of the coatings during dry sliding against 6 mm diameter alumina ball reached very low value, 0.05, in comparison with an oxygen-hardened alloy, whose COF was equal to 0.8. This low-friction effect of the coatings has been attributed to the formation of a self-lubricating film in sliding contact. The coatings exhibited similar failure morphology in the scratch tests. Even though the hardness was rather low, the coatings exhibited a very good wear resistance during sliding friction. The wear rate of the nc-WC/a-C coating was equal to 0.08 × 10−6 mm3 N−1 m−1 and for the nc-TiC/a-C one it was 0.28 × 10−6 mm3 N−1 m−1.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Metal and Thin Film Mechanics · Diamond and Carbon-based Materials Research · Advanced materials and composites

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (41)

Show source-provided references
1. S. Zhang, D. Sun, and X.L. Bui: in Nanocomposite Thin Films and Coatings, S. Zhang and N. Ali, eds. Imperial College Press, London, 2007, pp. 1–110.10.1142/9781860949975_0001 ↗
2. T. Moskalewicz, B. Wendler, S. Zimowski, B. Dubiel and A. Czyrska-Filemonowicz: Surf. Coat. Technol., 2010, vol. 205, pp. 2668-2677.10.1016/j.surfcoat.2010.10.039 ↗
3. T. Moskalewicz, B. Wendler and A. Czyrska-Filemonowicz: Mater. Charact., 2010, vol. 61, pp. 959-968.10.1016/j.matchar.2010.06.005 ↗
4. A.A. Voevodin, J.P. O’Neill and J.S. Zabinski: Thin Solid Films, 1999, vol. 342, pp. 194-200.10.1016/S0040-6090(98)01456-4 ↗
5. J.L. Mo and M.H. Zhu: Wear, 2011, vol. 271, pp. 1998-2005.10.1016/j.wear.2010.12.016 ↗
6. K. Włodarczyk, M. Makówka, P. Nolbrzak and B. Wendler: J. Achiev. Mater. Manuf. Eng., 2009, vol. 37, pp. 354-360.
7. J.C. Sánchez-López, D. Martínez-Martínez, C. López-Cartes and A. Fernández: Surf. Coat. Technol., 2008, vol. 202, pp. 4011-4018.10.1016/j.surfcoat.2008.02.012 ↗
8. D. Martínez-Martínez, C. López-Cartes, A. Fernández and J.C. Sánchez-López: Thin Solid Films, 2009, vol. 517, pp. 1662-1671.10.1016/j.tsf.2008.09.091 ↗
9. A. Czyrska-Filemonowicz, P.A. Buffat, M. Łucki, T. Moskalewicz, W. Rakowski, J. Lekki and T. Wierzchoń: Acta Mater., 2005, vol. 53, pp. 4367-4377.10.1016/j.actamat.2005.05.035 ↗
10. T. Moskalewicz, W. Grogger and A. Czyrska-Filemonowicz: J. Microsc., 2006, vol. 223, no. 3, pp. 195-199.10.1111/j.1365-2818.2006.01618.x ↗
11. T. Bell and H. Dong: Proceedings of the 12th International Federation Heat Treatment and Surface Engineering Congress Melbourne, Australia, 2000, vol. 2, pp. 1–6.
12. B. Wendler, T. Liśkiewicz, Ł. Kaczmarek, B. Januszewicz, D. Rylska, S. Fouvry, A. Rylski and M. Jachowicz: in: G. Luetjering and J. Albrecht (Eds.): Ti-2003 Science and Technology, Wiley-VCH, Weinheim, 2004, pp. 905-912.
13. T. Moskalewicz, S. Zimowski, B. Wendler, P. Nolbrzak and A. Czyrska-Filemonowicz: Met. Mater. Int., 2014, vol. 20, pp. 269-276.10.1007/s12540-014-2009-6 ↗
14. B. Wendler, T. Moskalewicz, I. Progalskiy, W. Pawlak, M. Makówka, K. Włodarczyk, P. Nolbrzak, A. Czyrska-Filemonowicz and A. Rylski: J. Achiev. Mater. Manuf. Eng., 2010, vol. 43, pp. 455-462.
15. P. Stadelmann: JEMS Java Electron Microscopy Software, version 3.6907U2011, 1999–2011, http://cime.epfl.ch/research/jems (visited on 1/05/2013).
16. AnalySIS 3.1: Software CD-ROM, Soft Imaging System GmbH, 2001.
17. W.C. Oliver and G.M. Pharr: J. Mater. Res., 2004, vol. 19, pp. 3-20.10.1557/jmr.2004.19.1.3 ↗
18. Z.-H. Xu and X. Li: Acta Materialia, 2008, vol. 56, pp. 1399–1405.10.1016/j.actamat.2007.11.030 ↗
19. J.A. Thornton: J. Vac. Sci. Technol. A, 1986, vol. 4(6), pp. 3059–65.10.1116/1.573628 ↗
20. J.A. Thornton: Annu. Rev. Mater. Sci., 1977, vol. 7, pp. 239-260.10.1146/annurev.ms.07.080177.001323 ↗
21. T. Moskalewicz, B. Schaffer, A. Manescu, F. Rustichelli and A. Czyrska-Filemonowicz: Surf. Coat. Technol., 2007, vol. 201, pp. 7635-7640.10.1016/j.surfcoat.2007.02.035 ↗
22. T. Moskalewicz, B. Wendler, F. Smeacetto, M. Salvo, A. Manescu and A. Czyrska-Filemonowicz: Surf. Coat. Technol., 2008, vol. 202, pp. 5876-5881.10.1016/j.surfcoat.2008.06.111 ↗
23. D. Galvan, Y.T. Pei and J.Th.M. De Hosson: Acta Mater., 2005, vol. 53, pp. 3925-3934.10.1016/j.actamat.2005.04.040 ↗
24. Y.T. Pei, D. Galvan and J.Th.M. De Hosson: Acta Mater., 2005, vol. 53, pp. 4505-4521.10.1016/j.actamat.2005.05.045 ↗
25. K.P. Shaha: Ph.D. Thesis, University of Groningen, The Netherlands, 2011.
26. Y.T. Pei, C.Q. Chen, K.P. Shaha, J.Th.M. De Hosson, J.W. Bradley, S.A. Voronin and M.Cada: Acta Mater., 2008, vol. 56, pp. 696-709.10.1016/j.actamat.2007.10.025 ↗
27. J. Wosik, B. Dubiel, A. Kruk, H-J. Penkalla, F. Schubert and A. Czyrska-Filemonowicz: Mater. Charact., 2001, vol. 46, pp. 119-123.10.1016/S1044-5803(01)00112-7 ↗
28. S.B. Liu, A. Peyronnel, Q.J. Wang and L.M. Keer: Tribol. Lett., 2005, vol. 18, pp. 303-314.10.1007/s11249-004-2757-4 ↗
29. M. Kot, J.M. Lackner, Ł. Major and W. Rakowski: Mater. Des., 2013, vol. 43, pp. 99-111.10.1016/j.matdes.2012.06.040 ↗
30. K.L. Johnson: Contact Mechanics, Cambridge University Press, Cambridge, 1985.10.1017/CBO9781139171731 ↗
31. E. Martínez, J. Romero, A. Lousa and J. Esteve: Appl. Phys. A, 2003, vol. 77, pp. 419-426.10.1007/s00339-002-1669-0 ↗
32. J. Mencík: Meccanica, 2007, vol. 42, pp. 19-29.10.1007/s11012-006-9018-6 ↗
33. M. Kot, W. Rakowski, J. Lackner and Ł. Major: Mater. Des., 2013, vol. 46, 751-757.10.1016/j.matdes.2012.11.026 ↗
34. I.L. Singer, R.N. Bolster, J. Wegand, S. Fayeulle and B.C. Stupp: Appl. Phys. Lett., 1990, vol. 57, pp. 995-997.10.1063/1.104276 ↗
35. T.W. Scharf, J.A. Ohlhausen, D.R. Tallant and S.V. Prasad : J. Appl. Phys., 2007, vol. 101, pp. 063521-11.10.1063/1.2711147 ↗
36. Y. Liu, A. Erdemir and E.I. Meletis: Surf. Coat. Technol., 1996, vol. 82, pp. 48-56.10.1016/0257-8972(95)02623-1 ↗
37. S. El Mrabet, M.D. Abad and J.C. Sánchez-López: Surf. Coat. Technol., 2011, vol. 206, pp. 1913-1920.10.1016/j.surfcoat.2011.07.059 ↗
38. S. Zimowski, W. Rakowski and J. Grzonka: Surf. Interface Anal., 2010, vol. 42, pp. 1364-1367.10.1002/sia.3463 ↗
39. A. Leyland and A. Matthews: Wear, 2000, vol. 246, pp. 1-11.10.1016/S0043-1648(00)00488-9 ↗
40. J. Musil, F. Kunc, H. Zeman and H. Polakova: Surf. Coat. Technol., 2002, vol. 154, pp. 304-313.10.1016/S0257-8972(01)01714-5 ↗
41. Y.T. Pei, D. Galvan, J.Th.M. De Hosson and A. Cavaleiro: Surf. Coat. Technol., 2005, vol. 198, pp. 44-50.10.1016/j.surfcoat.2004.10.106 ↗