journal article·2006-06

Effect of cyclic plasticity on internal stresses in a metal matrix composite

M. R. Daymond, M. E. Fitzpatrick

Publisher page

Abstract

Neutron diffraction has been used to measure the elastic strains in a silicon carbide particle-reinforced aluminum alloy during cyclic plasticity. Strains were recorded in both phases of the material, in sufficient directions to allow for calculation of the internal stresses. The shape misfit stress in the composite was calculated from the macroscopic stress data using an Eshelby-based model. Changes in the misfit stress caused by plastic deformation can be clearly observed. Local plastic anisotropy of the matrix material is also seen and was monitored by comparing results from the two diffraction planes, {111} and {200}, that were measured. The results have been compared to those obtained using an elasto-plastic self-consistent modeling approach, which shows the evolution of load sharing between the matrix and reinforcement, as well as the origin of the plastic anisotropy strains in the aluminum.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Aluminum Alloys Composites Properties · Microstructure and mechanical properties · Metal Forming Simulation Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (29)

Show source-provided references
1. B.D. Cullity: Adv. X-Ray Anal., 1977, vol. 20, pp. 259–71.
2. P.J. Withers, W.M. Stobbs, and O.B. Pedersen: Acta Metall. Mater., 1989, vol. 37, pp. 3061–84.10.1016/0001-6160(89)90341-6 ↗
3. A.J. Allen, M. Bourke, S. Dawes, M.T. Hutchings, and P.J. Withers: Acta Metall. Mater., 1992, vol. 40 (9), pp. 2361–73.10.1016/0956-7151(92)90155-8 ↗
4. M.A.M. Bourke, J.A. Goldstone, N. Shi, J.E. Allison, M.G. Stout, and A.C. Lawson: Scripta Mater., 1993, vol. 29, pp. 771–76.10.1016/0956-716X(93)90224-G ↗
5. P.J. Withers and A.P. Clarke: Acta Mat., 1998, vol. 46 (18), pp. 6585–98.10.1016/S1359-6454(98)00297-3 ↗
6. S.R. MacEwen, J. Faber, and A.P.L. Turner: Acta Metall., 1983, vol. 31 (5), pp. 657–76.10.1016/0001-6160(83)90082-2 ↗
7. M.E. Fitzpatrick, M.T. Hutchings, and P.J. Withers: Acta Mat., 1997, vol. 45 (12), pp. 4867–76.10.1016/S1359-6454(97)00209-7 ↗
8. M.E. Fitzpatrick: in Analysis of Residual Stress using Neutron and Synchrotron Radiation, M.E. Fitzpatrick and A. Lodini, eds., 2003, Taylor & Francis, London, pp. 263–78.10.1201/9780203608999 ↗
9. R.A. Winholtz: in Measurement of Residual and Applied Stress Using Neutron Diffraction, M.T. Hutchings and A.D. Krawitz, eds., 1992, Kluwer Academic, London, pp. 131–45.10.1007/978-94-011-2797-4_8 ↗
10. T.W. Clyne and P.J. Withers: An Introduction to Metal Matrix Composites. Cambridge Solid State Science Series, E.A. Davis and I.M. Ward, eds., 1993, Cambridge University Press, p. 509.
11. T.W. Clyne: www.msm.cam.ac.uk/mmc/publications/soft.html.
12. O.B. Pedersen and P.J. Withers: Philos. Mag., 1992, vol. 65, pp. 1217–33.10.1080/01418619208201506 ↗
13. R. Hill: J. Mech. Phys. Sol., 1965, vol. 13, pp. 89–101.10.1016/0022-5096(65)90023-2 ↗
14. J.W. Hutchinson: Proc. R. Soc. Lond. A, 1970, vol. 319, pp. 247–72.10.1098/rspa.1970.0177 ↗
15. P.A. Turner, N. Christodoulou, and C.N. Tomé: Int. J. Plast., 1995, vol. 11 (3), pp. 251–65.10.1016/0749-6419(94)00048-4 ↗
16. B. Clausen: Characterisation of Polycrystal Deformation by Numerical Modelling and Neutron Diffraction Experiments, 1997, Risø National Laboratory, Roskilde, Denmark.
17. M.R. Daymond and H.G. Priesmeyer: Acta Mater., 2002, vol. 50 (6), pp. 1613–26.10.1016/S1359-6454(02)00026-5 ↗
18. M.R. Daymond, C. Lund, M.A.M. Bourke, and D.C. Dunand: Metall. Mater. Trans., 1999, vol. 30A, pp. 2989–97.10.1007/s11661-999-0136-3 ↗
19. J.W.L. Pang, T.M. Holden, and T.E. Mason: Acta Mater., 1998, vol. 46, pp. 1503–18.10.1016/S1359-6454(97)00369-8 ↗
20. A.J. Allen, M.T. Hutchings, C.G. Windsor, and A. Andreani: Adv. Phys., 1985, vol. 34 (4), pp. 445–73.10.1080/00018738500101791 ↗
21. Metals Handbook, 10th ed., 1990, ASM International, Ohio.
22. Engineered Materials Handbook, Volume 4: Ceramics and Glasses, 1991, ASM International.
23. G.A. Webster, ed.: Neutron Diffraction Measurements of Residual Stress in a Shrink-fit Ring and Plug. 2000, VAMAS Report No. 38.
24. M.R. Daymond, M.A.M. Bourke, R.B. Von Dreele, B. Clausen, and T. Lorentzen: J. Appl. Phys., 1997, vol. 82 (4), pp. 1554–62.10.1063/1.365956 ↗
25. B. Clausen, T. Lorentzen, M.A.M. Bourke, and M.R. Daymond: Mater. Sci. Eng., 1999, vol. 259 (1), pp. 17–24.10.1016/S0921-5093(98)00878-8 ↗
26. M.R. Daymond: J. Appl. Phys., 2004, vol. 96 (8), pp. 4263–72.10.1063/1.1794896 ↗
27. T. Lorentzen: in Analysis of Residual Stress Using Neutron and Synchrontron Radiation, M.E. Fitzpatrick and A. Lodini, eds., 2003, Taylor & Francis, London, pp. 114–30.
28. M.E. Fitzpatrick, P.J. Withers, A. Baczmanski, M.T. Hutchings, R. Levy, M. Ceretti, and A. Lodini: Acta Mater., 2002, vol. 50 (5), pp. 1031–40.10.1016/S1359-6454(01)00401-3 ↗
29. B. Clausen, T. Lorentzen, and T. Leffers: Acta Mater., 1998, vol. 46 (9), pp. 3087–98.10.1016/S1359-6454(98)00014-7 ↗