Retardation of Small Creep–Fatigue Crack in Gr. 91 Steel Through the Combined Effects of Stress Relaxation, Microstructural Evolution, and Oxidation
Source abstract
Abstract
This investigation reports an unusual effect of hold time (up to 10 seconds) on retardation in the growth of creep–fatigue small cracks at 550 °C in Grade 91 steel. The observed phenomenon was interpreted by elucidating multiple processes that are active in the plastic zone at the crack tip. To this effect, microstructural and mechanical responses of the crack tip plastic zone were compared with the mechanical and microstructural responses during low cycle fatigue/creep–fatigue. It is proposed that the stress relaxation that occurs during the hold time can reduce the stress intensity in the plastic zone of crack tip thus, contributing to retardation in the small crack growth rate. Aside from stress relaxation, stress intensity in the crack tip can be further reduced by the phenomenon of cyclic softening that occurs because of plasticity-induced microstructural coarsening. Separately, the contribution of oxidation-induced crack tip shielding is also considered to explain the observed effects of hold time on crack growth rates. Taken together, a combination of stress relaxation, enhanced rate of cyclic softening, and higher degree of oxidation with the introduction of a hold time is demonstrated to be responsible for reduction in the crack growth under creep–fatigue conditions.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: High Temperature Alloys and Creep · Fatigue and fracture mechanics · Fire effects on concrete materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (38)
Show source-provided references
1. R. L. Klueh and A. T. Nelson, J. Nucl. Mater. 2007, vol. 371, pp. 37–52.10.1016/j.jnucmat.2007.05.005 ↗
2. R. L. Klueh, D. S. Gelles, S. Jitsukawa, A. Kimura, G. R. Odette, B. Van der Schaaf and M. Victoria, J. Nucl. Mater. 2002, vol. 307, pp. 455–65.10.1016/S0022-3115(02)01082-6 ↗
3. F. Abe, Sci. Technol. Adv. Mater. 2008, vol. 9, p. 013002.10.1088/1468-6996/9/1/013002 ↗
4. S. B. Narasimhachary and A. Saxena, Int. J. Fatigue 2013, vol. 56, pp. 106–13.10.1016/j.ijfatigue.2013.07.006 ↗
5. A. Stoppato, A. Mirandola, G. Meneghetti and E. L. Casto, Energy 2012, vol. 37, pp. 228–36.10.1016/j.energy.2011.11.042 ↗
6. T. P. Farragher, S. Scully, N. P. O’Dowd and S. B. Leen, Int. J. Fatigue 2013, vol. 49, pp. 50–61.10.1016/j.ijfatigue.2012.12.007 ↗
7. L. Cui and P. Wang, Int. J. Fatigue 2014, vol. 59, pp. 129–36.10.1016/j.ijfatigue.2013.09.007 ↗
8. B. Fournier, F. Dalle, M. Sauzay, J. Longour, M. Salvi, C. Caës, I. Tournié, P.-F. Giroux and S.-H. Kim, Mater. Sci. Eng. A 2011, vol. 528, pp. 6934–45.10.1016/j.msea.2011.05.046 ↗
9. B. Fournier, M. Sauzay, C. Caës, M. Noblecourt, M. Mottot, L. Allais, I. Tournie and A. Pineau, Metall. Mater. Trans. A 2009, vol. 40A, pp. 321–29.10.1007/s11661-008-9686-z ↗
10. B. Fournier, M. Sauzay, F. Barcelo, E. Rauch, A. Renault, T. Cozzika, L. Dupuy and A. Pineau, Metall. Mater. Trans. A 2009, vol. 40A, pp. 330–41.10.1007/s11661-008-9687-y ↗
11. B. Fournier, M. Sauzay, C. Caës, M. Noblecourt, M. Mottot, A. Bougault, V. Rabeau and A. Pineau, Int. J. Fatigue 2008, vol. 30, pp. 649–62.10.1016/j.ijfatigue.2007.05.007 ↗
12. R. P. Skelton and D. Gandy, Mater. High Temp. 2008, vol. 25, pp. 27–54.10.3184/096034007X300494 ↗
13. B. Fournier, M. Sauzay, C. Caës, M. Noblecourt, M. Mottot, A. Bougault, V. Rabeau, J. Man, O. Gillia and P. Lemoine, Int. J. Fatigue 2008, vol. 30, pp. 1797–1812.10.1016/j.ijfatigue.2008.02.006 ↗
14. T. Ogata and M. Yamamoto, JSME Int. J. Ser. A 1997, vol. 40, pp. 283–89.10.1299/jsmea.40.283 ↗
15. N. Ab Razak, C. M. Davies and K. M. Nikbin, Eng. Fail. Anal. 2018, vol. 84, pp. 320–30.10.1016/j.engfailanal.2017.08.007 ↗
16. M. Jono and A. Sugeta, Fatigue Fract. Eng. Mater. Struct. 1996, vol. 19, pp. 165–74.10.1111/j.1460-2695.1996.tb00956.x ↗
17. Y. Uematsu, M. Akita, M. Nakajima and K. Tokaji, Int. J. Fatigue 2008, vol. 30, pp. 642–48.10.1016/j.ijfatigue.2007.05.004 ↗
18. A. Shyam, J. E. Allison and J. W. Jones, Acta Mater. 2005, vol. 53, pp. 1499–1509.10.1016/j.actamat.2004.12.004 ↗
19. A. Shyam, J. E. Allison, C. J. Szczepanski, T. M. Pollock and J. W. Jones, Acta Mater. 2007, vol. 55, pp. 6606–16.10.1016/j.actamat.2007.08.022 ↗
20. A. Shyam, P. Blau, T. Jordan and N. Yang, Fatigue Fract. Eng. Mater. Struct. 2014, vol. 37, pp. 368–79.10.1111/ffe.12119 ↗
21. M. J. Caton and S. K. Jha, Int. J. Fatigue 2010, vol. 32, pp. 1461–72.10.1016/j.ijfatigue.2010.01.015 ↗
22. Z. Chen, A. Shyam, J. Huang, R. F. Decker, S. E. LeBeau and C. J. Boehlert, Metall. Mater. Trans. A 2013, vol. 44A, pp. 1045–58.10.1007/s11661-012-1449-1 ↗
23. J. C. Newman and I. S. Raju, Eng. Fract. Mech. 1981, vol. 15, pp. 185–92.10.1016/0013-7944(81)90116-8 ↗
24. P. Paris and F. Erdogan, J. Basic Eng. 1963, vol. 85, pp. 528–33.10.1115/1.3656900 ↗
25. S. I. Wright, M. M. Nowell and D. P. Field, Microsc. Microanal. 2011, vol. 17, pp. 316–29.10.1017/S1431927611000055 ↗
26. K. Sadananda and P. Shahinian, J. Mater. Sci. 1978, vol. 13, pp. 2347–57.10.1007/BF00808048 ↗
27. N. Adefris, A. Saxena and D. L. McDowell, Fatigue Fract. Eng. Mater. Struct. 1996, vol. 19, pp. 401–11.10.1111/j.1460-2695.1996.tb00977.x ↗
28. X. Liu, B. Kang and K.-M. Chang, Mater. Sci. Eng. A 2003, vol. 340, pp. 8–14.10.1016/S0921-5093(02)00074-6 ↗
29. K. V. Jata, D. Maxwell and T. Nicholas, J. Eng. Mater. Technol. 1994, vol. 116, pp. 45–53.10.1115/1.2904254 ↗
30. T. Fischer and B. Kuhn, Int. J. Fatigue 2018, vol. 112, pp. 165–72.10.1016/j.ijfatigue.2018.03.012 ↗
31. N. S. Shah, S. Sunil and A. Sarkar, Metall. Mater. Trans. A 2018, vol. 49A, pp. 2644–53.10.1007/s11661-018-4641-0 ↗
32. M. Sauzay, H. Brillet, I. Monnet, M. Mottot, F. Barcelo, B. Fournier and A. Pineau, Mater. Sci. Eng. A 2005, vol. 400, pp. 241–44.10.1016/j.msea.2005.02.092 ↗
33. C. G. Panait, A. Zielińska-Lipiec, T. Koziel, A. Czyrska-Filemonowicz, A.-F. Gourgues-Lorenzon and W. Bendick, Mater. Sci. Eng. A 2010, vol. 527, pp. 4062–69.10.1016/j.msea.2010.03.010 ↗
34. M. Sauzay, B. Fournier, M. Mottot, A. Pineau and I. Monnet, Mater. Sci. Eng. A 2008, vol. 483, pp. 410–14.10.1016/j.msea.2006.12.183 ↗
35. B. Fournier, M. Sauzay, C. Caës, M. Mottot, M. Noblecourt and A. Pineau, Mater. Sci. Eng. A 2006, vol. 437, pp. 197–211.10.1016/j.msea.2006.08.087 ↗
36. A. Shyam and W. W. Milligan, Acta Mater. 2004, vol. 52, pp. 1503–13.10.1016/j.actamat.2003.11.032 ↗
37. S. Suresh, G. F. Zamiski and R. O. Ritchie, Metall. Trans. A 1981, vol. 12, pp. 1435–43.10.1007/BF02643688 ↗
38. W.-G. Kim, J.-Y. Park, S.-J. Kim and J. Jang, Mater. Des. 2013, vol. 51, pp. 1045–51.10.1016/j.matdes.2013.05.013 ↗