Coefficient of Friction Measured from Nano- to Macro-Normal Loads on Plasma Sprayed Nanostructured Cermet Coatings
Source abstract
Abstract
Alumina dispersed FeCuAl-based nanostructured cermet coatings were deposited from nanostructured powders by atmospheric plasma spraying on low carbon steel substrates. Nanostructuring was retained in the deposited coatings which exhibit up to four distinctive phases as revealed by electron microscopy. In this study, the friction behavior of the distinctive phases at nano-normal load scale was investigated alongside their contribution to the overall friction behavior at macro-normal load scale. Friction behavior at nano-normal load scale was investigated by lateral force microscopy, whereas conventional tribometers were used for investigations at micro and macro-normal loads. It appeared that, the friction measured at nano-normal loads on individual phases is dictated by both composition and hardness of the corresponding phases, and thus influences the overall friction behavior of the coatings at macro-normal loads. Moreover, the coefficient of friction at macro-normal loads differs from the one at nano-normal loads, and deviates from Amonton’s friction law.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Tribology and Wear Analysis · Adhesion, Friction, and Surface Interactions · Metal and Thin Film Mechanics
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (29)
Show source-provided references
1. J. Karthikeyan, C.C. Berndt, J. Tikkanen, J.Y. Wang and H. Herman: Nanostruct. Mater., 1997, vol. 8(1), pp. 61-74.10.1016/S0965-9773(97)00066-4 ↗
2. V.L. Tellkamp, M.L. Lau, A. Fabel and E.J. Lavernia: Nanostruct. Mater., 1997, vol. 9, pp. 489-92.10.1016/S0965-9773(97)00107-4 ↗
3. C.C. Berndt and E.J. Lavernia: J. Therm. Spray Technol., 1998, vol. 7(3), pp. 411–41.10.1007/s11666-998-0058-4 ↗
4. A.K. Basak, S. Achanta, J.P. Celis, M. Vardavoulias and P. Matteazzi: Surf. Coat. Technol., 2008, vol. 202 (11), pp. 2368-73.10.1016/j.surfcoat.2007.08.053 ↗
5. A.K. Basak, W. Zein Eddine, J.P. Celis and P. Matteazzi: J. Nanosci. Nanotechnol., 2010, vol. 10 (2), pp. 1179-84.10.1166/jnn.2010.1827 ↗
6. B. Bhushan, J. Israelachvili and U. Landman: Nature, 1995, vol. 374, pp. 607-16.10.1038/374607a0 ↗
7. S. Achanta, D. Drees, J.P. Celis, O. Mollenhauer and F. Spiller (2004) Tribotest, 11(2), 137–49.10.1002/tt.3020110206 ↗
8. H. Mohrbacher, J.P. Celis and J.R. Roos: Tribol. Int., 1995, vol. 28 (5), pp. 269–78.10.1016/0301-679X(95)00005-O ↗
9. P. Matteazzi and M. Alcala, Mater. Sci. Eng. A: 1997, vol. 230, pp. 161–66.10.1016/S0921-5093(97)00022-1 ↗
10. A. K. Basak: PhD Thesis, Katholieke Universeteit Leuven, Belgium, 2009.
11. Digital Instruments Nanoscope III, AFM/LFM Instruction Manual, Section 10.1–10.6.
12. J.A. Ruan and B. Bhushan: Trans. ASME, 1994, vol. 116, pp. 378-88.10.1115/1.2927240 ↗
13. S. Fujisawa, E. Kishi, Y. Sugawara and S. Morita (1995) Appl. Phys. Lett., 66(4), pp. 526–29.10.1063/1.114078 ↗
14. H. Butt, B. Cappella and M. Kappl: Surf. Sci. Rep., 2005, vol. 59, pp. 1–152.10.1016/j.surfrep.2005.08.003 ↗
15. H. Hertz: J. Reine Angew. Math. 1881, vol. 92, pp. 156–71.
16. Z. Huq and J.-P. Celis: Wear, 2002, vol. 252, pp. 375–83.10.1016/S0043-1648(01)00867-5 ↗
17. S. Sundararajan and B. Bhushan: J. Appl. Phys. 2000, vol. 88, pp. 4825-31.10.1063/1.1310187 ↗
18. R.M. Overney, E. Meyer, J. Frommer, D. Brodbeck, R. Luthi, L. Howald, H.-J. Guntherodt, M. Fujihira, H. Takano and Y. Gotoh: Nature, 1992, vol. 359, pp. 133–35.10.1038/359133a0 ↗
19. E. Gnecco, R. Bennewitz, A. Socoliuc and E. Meyer: Wear, 2003, vol. 254, pp. 859–62.10.1016/S0043-1648(03)00236-9 ↗
20. J.A.Greenwood: Contact of Rough Surfaces, Fundamentals of Friction: Macroscopic and Microscopic Processes, I.L. Singer and H.M. Pollock, eds., Kluwer, Dordrecht, 1992, pp. 37–56.10.1007/978-94-011-2811-7_3 ↗
21. A. Berman, C. Drummond and J. Israelachvili: Tribo. Lett., 1998, vol. 4, pp. 95-101.10.1023/A:1019103205079 ↗
22. L. Wenning and M.H. Muser: Europhys. Lett., 2001, vol. 54 (5), pp. 693-99.10.1209/epl/i2001-00371-6 ↗
23. S. Sundararajan and B.Bhushan: J. Vac. Sci. Technol. A, 2001, vol. 19, pp. 1777-85.10.1116/1.1353539 ↗
24. B.V.Z. Derjaguin: Physica, 1934, vol. 88, pp. 661-75.
25. Y.I. Rabonivich, J.J. Adler, M.S. Esayanur, A. Ata, R.K.Singh and B.M. Moudgil: Adv. Colloid Interface. Sci. Sci., 2002, vol. 96, pp. 213-30.10.1016/S0001-8686(01)00082-3 ↗
26. X. Zhang and J.P. Celis: Appl. Surf. Sci. 2003, vol. 206, pp. 110-18.10.1016/S0169-4332(02)01192-3 ↗
27. S. Achanta and J.-P. Celis: Wear, 2010, vol. 269, pp. 435–42.10.1016/j.wear.2010.04.029 ↗
28. D.H. Buckley, Surface Effects in Adhesion, Friction, Wear and Lubrication, Elsevier, New York, 1981.
29. I.M. Hutchings, Tribology: Friction and Wear of Engineering Materials, Edward Arnold, London, 1992.