Investigation on the Microstructure and Mechanical Properties of Ti-1.0Fe Alloy with Equiaxed α + β Microstructures
Source abstract
Abstract
In this study, the microstructural characteristics and mechanical properties of Ti-1.0Fe alloy with equiaxed α + β microstructures were investigated in detail. Four different equiaxed α + β microstructures with β phase fraction ranging from 3 to 26 pct were obtained by hot deforming the martensite initial microstructure in α + β two-phase region with different deformation temperatures and cooling rates. The average nano-hardness of β grains was found to be much larger than that of α grains, which was attributed to the higher Fe concentration as well as nano-sized athermal ω precipitates inside the β grains. As a result, plastic strain partitioning occurred between the two phases during the tensile deformation, where the plastic strain within the soft α grains was much larger. With the increase of the β phase fraction, both yield and tensile strength of the samples increased, while at the same time, the total elongation gradually decreased. Most of the micro-cracks formed at the α/β interphase boundaries and propagated across the narrowest part of β phase. In the sample with the largest β phase fraction (26 pct), strain-induced β to α′ phase transformation occurred at the expense of initial athermal ω precipitates during the tensile deformation. This resulted into local nano-hardness variations between transformed and un-transformed β areas. Consequently, much more micro-cracks formed in this sample either at the boundaries between transformed and un-transformed β areas, or around the strain-induced α′ phase with a plate-like morphology. This explained the premature fracture shortly after necking in the sample with the largest β phase fraction.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Titanium Alloys Microstructure and Properties · Intermetallics and Advanced Alloy Properties · Advanced materials and composites
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (26)
Show source-provided references
1. [1] D. Banerjee and J.C. Williams: Acta Mater, 2013, vol. 61, pp. 844-879.10.1016/j.actamat.2012.10.043 ↗
2. G. Lutjering and J.C. Williams, Titanium, 2nd edition, Springer, Berlin, 2005.
3. [3] L.A. Maltakhova, A.N. Maltakhov, S.N. Monteiro, S.G. Fedotov, B.A. Goncharenko, Mater Sci Eng A, 2005, vol. 393, pp. 320-326.10.1016/j.msea.2004.11.021 ↗
4. [4] V. Lyasotskaya, S. Fedotov, S. Knyazeva, A. Dmitriev, Metal Sci Heat Treat, 1993, vol. 35, pp. 242-246.10.1007/BF00775145 ↗
5. [5] A.R. Kilmametov, Yu. Ivanisenko, A.A. Mazilkin, B.B. Straumal, A.S. Gornakova, O.B. Fabrichnaya, M.J. Kriegel, D. Rafaja and H. Hahn: Acta Mater, 2018, vol. 144, pp. 337-351.10.1016/j.actamat.2017.10.051 ↗
6. [6] B.B. Straumal, A.R. Kilmametov, Yu. Ivanisenko, A.S. Gornakova, A.A. Mazilkin, M.J. Kriegel, O.B. Fabrichnaya, B. Baretzky and H. Hahn, Adv Eng Mater, 2015, vol. 17, pp. 1835-1841.10.1002/adem.201500143 ↗
7. A. Kilmametov, Y. Ivanisenko, B. Straumal, A.A. Mazilkin, A.S. Gornakova, M.J. Kriegel, O.B. Fabrichnaya, D. Rafaja and H. Hahn, Scr. Mater., 2017, vol. 136, pp. 46-4910.1016/j.scriptamat.2017.04.010 ↗
8. [8] Yu. Ivanisenko, A. Kilmametov, H. Rosner and R.Z. Valiev, Int J Mater Res, 2018, vol. 99, pp. 36-41.10.3139/146.101606 ↗
9. [9] Y. Chong, G.Y. Deng, A. Shibata, N. Tsuji, Adv Eng Mater, 2019, vol. 21, pp. 1900607.10.1002/adem.201900607 ↗
10. [10] G.Y. Deng, T. Bhattacharjee, Y. Chong, R.X. Zheng, Y. Bai, A. Shibata, N. Tsuji, J All Comp, 2020, vol. 822, pp. 153604.10.1016/j.jallcom.2019.153604 ↗
11. [11] M.J. Kriegel, A.R. Kilmametov, M. Rudolph, B.B. Straumal, A.S. Gornakova, H. Stocker, Yu. Ivanisenko, O.B. Fabrichnaya, H. Hahn and D. Rafaja, Adv Eng Mater, 2018, vol. 20, pp. 170093.10.1002/adem.201700933 ↗
12. [12] S.L Semiatin, V. Seetharaman and I. Weiss, JOM, 1997, vol. 49, pp. 33-40.10.1007/BF02914711 ↗
13. [13] S.L. Semiatin, V. Seetharaman and I. Weiss, Mater Sci Eng A, 1999, vol. 263, pp. 257-271.10.1016/S0921-5093(98)01156-3 ↗
14. [14] T. Furuhara, B. Poorganji, H. Abe and T. Maki, JOM, 2007, vol. 59, pp. 64-67.10.1007/s11837-007-0013-8 ↗
15. [15] S.L. Semiatin and T.R. Bieler, Acta Mater, 2001, vol. 49, pp. 3565-3573.10.1016/S1359-6454(01)00236-1 ↗
16. [16] Y. Chong and N. Tsuji, Mater Sci Forum, 2016, vol. 879, pp. 344-349.10.4028/www.scientific.net/MSF.879.344 ↗
17. [17] S. Mironov, M. Murzinova, S. Zherebtsov, G.A. Salishchev and S.L. Semiatin, Acta Mater, 2009, vol. 57, pp. 2470-2481.10.1016/j.actamat.2009.02.016 ↗
18. [18] Y. Chong, T. Bhattacharjee, M-H. Park, A. Shibata and N. Tsuji, Mater Sci Eng A, 2018, vol. 730, pp. 217-222.10.1016/j.msea.2018.06.019 ↗
19. [19] H.H. Liu, M. Niinomi, M. Nakai, and K. Cho, Acta Mater, 2016, vol. 106, pp. 162-170.10.1016/j.actamat.2016.01.008 ↗
20. [20] H.H. Liu, M. Niinomi, M. Nakai, K. Cho and H. Fujii, Scripta Mater, 2017, vol. 130, pp. 27-31.10.1016/j.scriptamat.2016.10.036 ↗
21. [21] S.K. Sikka, K. Vohra and R. Chidambaram, Prog Mater Sci, 1982, vol. 27, pp. 245-310.10.1016/0079-6425(82)90002-0 ↗
22. [22] N. Tsuji, Y. Ito, Y. Saito and Y. Minamino, Scripta Mater, 2002, vol. 47, pp. 893-899.10.1016/S1359-6462(02)00282-8 ↗
23. [23] N. Tsuji, Y. Saito, H. Utsunomiya and S. Tanigawa, Scripta Mater, 1999, vol. 40, pp. 795-800.10.1016/S1359-6462(99)00015-9 ↗
24. [24] P.J. Jacques, Q. Furnemont, F. Lani, T. Pardoen and F. Delannay, Acta Mater, 2007, vol. 55, pp. 3681-3693.10.1016/j.actamat.2007.02.029 ↗
25. [25] S. Zaefferer, J. Ohlert and W. Bleck, Acta Mater, 2004, vol. 52, pp. 2765-2778.10.1016/j.actamat.2004.02.044 ↗
26. [26] F.D. Fischer, G. Reisner, E. Werner, K. Tanaka, G. Cailletaud and T. Antretter, Int J Plasticity, 2000, vol. 16, pp. 723-748.10.1016/S0749-6419(99)00078-9 ↗