An Abrupt Transition to an Intergranular Failure Mode in the Near-Threshold Fatigue Crack Growth Regime in Ni-Based Superalloys
Source abstract
Abstract
Cyclic near-threshold fatigue crack growth (FCG) behavior of two disk superalloys was evaluated and was shown to exhibit an unexpected sudden failure mode transition from a mostly transgranular failure mode at higher stress intensity factor ranges to an almost completely intergranular failure mode in the threshold regime. The change in failure modes was associated with a crossover of FCG resistance curves in which the conditions that produced higher FCG rates in the Paris regime resulted in lower FCG rates and increased ∆Kth values in the threshold region. High-resolution scanning and transmission electron microscopy were used to carefully characterize the crack tips at these near-threshold conditions. Formation of stable Al-oxide followed by Cr-oxide and Ti-oxides was found to occur at the crack tip prior to formation of unstable oxides. To contrast with the threshold failure mode regime, a quantitative assessment of the role that the intergranular failure mode has on cyclic FCG behavior in the Paris regime was also performed. It was demonstrated that even a very limited intergranular failure content dominates the FCG response under mixed mode failure conditions.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: High Temperature Alloys and Creep · Fatigue and fracture mechanics · Microstructure and Mechanical Properties of Steels
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (17)
Show source-provided references
1. J. Telesman, T.M. Smith, T.P. Gabb, and A.J. Ring: Mater. Sci. Eng. A, 2017, vol. 798, pp. 336–50.10.1016/j.msea.2017.10.003 ↗
2. J.L. Yuen, P. Roy, and W.D. Nix: Metall. Trans. A, 1984, vol. 15A, pp. 1769–75.10.1007/BF02666360 ↗
3. M.A. Hicks and J.E. King: Int. J. Fatigue, 1983, 5, 67–74.10.1016/0142-1123(83)90056-7 ↗
4. A. Shyam, S. Padula, S. Marras, and W. Milligan: Metall. Mater. Trans. A, 2002, vol. 33A, pp. 1949–62.10.1007/s11661-002-0028-2 ↗
5. H.Y. Li, J.F. Sun, M.C. Hardy, H.E. Evans, S.J. Williams, T.J.A. Doel, and P. Bowen: Acta Mater., 2015, vol. 90, pp. 355–69.10.1016/j.actamat.2015.02.023 ↗
6. S. Suresh, G.F. Zamiski, and R.O. Ritchie: Metall. Trans. A, 1981, vol. 12A, pp. 1435–43.10.1007/BF02643688 ↗
7. R. Molins, G. Hochstetter, J.C. Chassaigne, and E. Andrieu: Acta Mater., 1997, vol. 45, pp. 663–74.10.1016/S1359-6454(96)00192-9 ↗
8. R. Molins, J.C. Chassaigne, and E. Andrieu: Mater. Sci. Forum, 1997, vols. 251–254, pp. 445–52.10.4028/www.scientific.net/MSF.251-254.445 ↗
9. E. Andrieu, G. Hochstetter, R. Molins, and A. Pineau: Proceeding of the Superalloys 718, 625, 706 and Various Derivatives, E.A. Loria, ed., TMS, Warrendale, PA, 1994, pp. 619–31.10.7449/1994/Superalloys_1994_619_631 ↗
10. L. Viskari, M. Hornqvist, K.L. Moore, Y. Cao, and K. Stiller: Acta Mater., 2013, vol. 61, pp. 3630–39.10.1016/j.actamat.2013.02.050 ↗
11. P.F. Browning: Ph.D. Thesis, Rensselaer Polytechnic Institute, Troy, NY, 1998.
12. N. Birks, G.H. Meier, and F.S. Pettit: Introduction to the High-Temperature Oxidation of Metals, 2nd ed., Cambridge University Press, Cambridge, 2006.10.1017/CBO9781139163903 ↗
13. J.L. Smialek and G.H. Meier: in Superalloys II, C.T. Sims et al., Wiley-Interscience, 1987, pp. 293–326.
14. T. Mura: Mater. Sci. Eng. A, 1994, vol. 176, pp. 61–70.10.1016/0921-5093(94)90959-8 ↗
15. K.S. Chan: Metall. Mater. Trans. A, 2014, vol. 45 (8), pp. 3454–66.10.1007/s11661-014-2271-8 ↗
16. R.O. Ritchie: Int. J. Fract., 1999, vol. 100, pp. 55–83.10.1023/A:1018655917051 ↗
17. J. Telesman, T.P. Gabb, and L.J. Ghosn: in Superalloys 2016, M. Hardy et al., eds., TMS, Warrendale, PA, 2016, pp. 551–60.