journal article·2003-03

Spark plasma sintering of Al-Si-Cu-Fe quasi-crystalline powder

E. Fleury, J. H. Lee, S. H. Kim, W. T. Kim, J. S. Kim, D. H. Kim

Publisher page

Abstract

This article presents the results of a study on the microstructure and mechanical properties of Al−Si−Cu−Fe specimens produced by the spark plasma sintering (SPS) technique. The microstructure of the starting powder and bulk specimens was analyzed by means of X-ray diffraction (XRD), scanning electron microscopy (SEM), and transmission electron microscopy (TEM). The formation of the icosahedral and decagonal quasi-crystalline phases in the as-gas-atomized powders is described for the first time. It is then shown that these metastable phases transformed into the 1/1 cubicapproximant phase upon heating at about 600°C. Second, the effects of SPS process parameters such as the temperature and time have been investigated. Owing to the generation of a spark discharge neighboring powder particles, dense cylindrical samples were obtained after a short sintering time of 30 minutes at the temperature of 650°C. The highest values of the Vickers microhardness, about 8.9 GPa, were obtained when the powders were sintered in the temperature range of 600°C to 650°C for a holding time of 30 minutes, while the fracture toughness was found to be inversely proportional to the sintering temperature. However, at the sintering temperature of 650°C, the fracture toughness increased from about 1.40 to 1.52 MPa √m as the holding time increased from 10 to 60 minutes. As compared to cast specimens, the enhanced mechanical properties are explained by the refined microstructure resulting from the low temperature and short sintering time applied during SPS processing
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Quasicrystal Structures and Properties · Aluminum Alloys Composites Properties · Metallic Glasses and Amorphous Alloys

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (39)

Show source-provided references
1. C. Janot: Quasicrystals: a Primer, 2nd ed., Clarendon Press, Oxford, UK, 1994, pp. 1–52
2. D. Shechtman, I. Blech, D. Gratias, and J.W. Cahn: Phys. Rev. Lett. 1984, vol. 53, pp. 1951–53.10.1103/PhysRevLett.53.1951 ↗
3. J.M. Dubois and P. Weinland: French Patent No. 2635117, 1988.
4. P. Liu, A. Hultin Stigenberg, and J.O. Nilsson: Acta Metall., 1995, vol. 7, pp. 2881–90.10.1016/0956-7151(94)00461-P ↗
5. F. Gahler, P. Kramer, H.R. Trebin, and K. Urban: Mater. Sci. Eng. A, 2000, vols. A294–A296, pp. 1–3.10.1016/S0921-5093(00)01332-0 ↗
6. J.M. Dubois: Mater. Sci. Eng. A, 2000, vols. A294–A296, pp. 4–9.10.1016/S0921-5093(00)01305-8 ↗
7. P. Archambault and C. Janot: MRS Bull., 1997, vol. 22 (11), pp. 48–51.10.1557/S0883769400034436 ↗
8. S.S. Kang, J.M. Dubois, and J. von Stebut: J. Mater. Res., 1993, vol. 8 (10), pp. 2471–81.10.1557/JMR.1993.2471 ↗
9. S.M. Lee, E. Fleury, J.S. Kim, Y.c. Kim, W.T. Kim and D.H. Kim: Quasicrystals, MRS Proc. Series, A.P. Tsai, E. Belin-Ferre, P. Thiel, and K. Urban, eds., MRS, Warrendale, PA, vol. 643, 2001, pp. K15.2.1-k15.2.12.
10. C.L. Henley and V. Elser: Phil. Mag. B, 1986, vol. 53, pp. L59-L66.10.1080/13642818608240638 ↗
11. A.P. Tsai, A. Inoue, and T. Masumoto: Jpn. J. Appl. Phys., 1987, vol. 26, pp. L1505-L1507.10.1143/JJAP.26.L1505 ↗
12. M. Quiquandon, A. Quivy, J. Devaud, F. Faudot, S. Lefebvre, M. Bessiere, and Y. Calvayrac: J. Phys.: Condens. Matter, 1996, vol. 8, pp. 2487–512.10.1088/0953-8984/8/15/002 ↗
13. A. Quivy, V. Quiquandon, Y. Calvayrac, F. Faudot, D. Gratias, C. Berger, R.A. Brand, V. Simonet, and F. Hippert: J. Phys.: Condens. Matter, 1996, vol. 8, pp. 4223–34.10.1088/0953-8984/8/23/014 ↗
14. L. Bresson, A. Quivy, F. Faudot, M. Quiquandon, and Y. Calvayrac: Ouasicrystals, Proc. 6th Int. conf., S. Takeuchi and T. Fujiwara, eds., World Scientific Publishing, Singapore, 1998, pp. 211–14.
15. S.M. Lee, B.H. Kim, S.H. Kim, E. Fleury, W.T. Kim, and D.H. Kim: Mater. Sci. Engr. A., 2000, vols. 294–296, pp. 93–98.10.1016/S0921-5093(00)01206-5 ↗
16. T. Takeuchi, H. Yamada, M. Takata, T. Nakata, N. Tanaka, and U. Mizutani: Mater. Sci. Eng. A, 2000, vols. 294–296, pp. 340–44.10.1016/S0921-5093(00)01198-9 ↗
17. J.L. Jouland, J. Bemardini, P. Gas, C. Bergman, J.M. Dubois, Y. Calvayrac and D. Gratias: Phil. Mag. A, 1997, vol. 75, pp. 1287–97.10.1080/01418619708209857 ↗
18. J.E. Shield and M.J. Kramer: J. Mater. Res, 1997, vol. 12, pp. 2043–47.10.1557/JMR.1997.0274 ↗
19. G.S. Song, K.B. Kim, E. Fleury, W.T. Kim, and D.H. Kim: J. Mater. Sci. Lett., 2001, vol. 20, pp. 1293–96.10.1023/A:1010934114319 ↗
20. M. Tokita: J. Soc. Powder Technol., 1993, vol. 30 (11), pp. 790–804.10.4164/sptj.30.11_790 ↗
21. H. Gleiter: Acta Mater., 2000, vol. 48 (1), pp. 1–29.10.1016/S1359-6454(99)00285-2 ↗
22. T. Murakami, M. Komatsu, A. Kitahara, M. Kawahara, Y. Takahashi, and Y. Ono: Intermetallics, 1999, vol. 7, pp. 731–39.10.1016/S0966-9795(98)00090-9 ↗
23. T. Takeuchi, M. Tabuchi, I. Kondoh, N. Tamari, and H. Kageyama: J. Am. Soc., 2000, vol. 8 (3), pp. 541–44.
24. K. Niihara, R. Morena, and D.P.H. Hasselman: J. Mater. Sci. Lett., 1982, vol. 1, pp. 13–16.10.1007/BF00724706 ↗
25. M.F. Doerner and W.D. Nix: J. Mater. Res., 1986, vol. 1, pp. 601–09.10.1557/JMR.1986.0601 ↗
26. L.X. He, Y.K. Wu, and K.H. Kuo: J. Mater. Sci., 1988, vol. 7, pp. 1284–86.
27. V. Elser: Phys. Rev. B, 1985, vol. 32 (8), pp. 4892–98.10.1103/PhysRevB.32.4892 ↗
28. B.D. Cullity: Elements of X-ray Diffraction, 2nd ed., Addison-Wesley Publishing Co., New York, NY, 1978, p. 356.
29. M.A. Montealegre, M.A. Munos-Morris, J.L. Gonzales-Carrasco, and D.G. Morris: Scripta Mater., 2001, vol. 44 (11), pp. 2673–79.10.1016/S1359-6462(01)00945-9 ↗
30. R. Bohn, T. Klassen, and R. Bormann: Acta Mater., 2001, vol. 49 (2), pp. 299–311.10.1016/S1359-6454(00)00312-8 ↗
31. K. Suzuki, H. Hosoda, and S. Hanada: High-Temperature-Ordered Intermetallic Alloys, MRS Proc. Series, E.P. George, M.J. Mills and M. Yamaguchi, eds., MRS, Warrendale, PA, 1999, vol. 552, pp. 8.32.1–8.32.7.
32. E. Fleury, J.H. Lee, S.H. Kim, J.S. Kim, D.H. Kim, and W.T. Kim: Quasicrystals, MRS Proc. Series, MRS, Warrendale, PA, vol. 643, 2001, pp. K2.1.1-K2.1.6
33. K. Tanaka, Y. Mitarai, and M. Koiwa: Phil. Mag. A, 1996, vol. 73 (6), pp. 1715–23.10.1080/01418619608243008 ↗
34. P. Saintfort and B. Dubost, Quasi-crystalline Materials, C. Janot and J.M. Dubois, eds. World Scientific Publishing, Singapore, 1998, pp. 361–71.
35. M. Wollgarten and H. Saka: New Horizons in Quasicrystals: Research and Applications, A. Golman, D.J. Sordelet, P.A. Thiel, and J.M. Dubois, eds. World Scientific Publishing, Singapore, 1997, pp. 320–27.
36. S.S. Kang and J.M. Dubois: Phil. Mag. A, 1992, vol. 66, pp. 151–63.10.1080/01418619208201520 ↗
37. S.M. Lee, J.H. Jung, E. Fleury, W.T. Kim, and D.H. Kim: Mater. Sci. Eng. A, 2000, vols. 294–296, pp.99–103.10.1016/S0921-5093(00)01223-5 ↗
38. H. Zhang, D.H. Wang, and K.H. Kuo: J. Mater. Sci., 1989, vol. 24, pp. 2981–86.10.1007/BF02385657 ↗
39. D. Gratias, A. Katz, and M. Quiquandon: J. Phys. Condens. Matter, 1995, vol. 7, pp. 9101–25.10.1088/0953-8984/7/48/004 ↗