journal article·2006-09

Influence of the second phase on the room-temperature tensile and creep deformation mechanisms of α-β titanium alloys: Part I. Tensile deformation

A. Jaworski, S. Ankem

Publisher page

Abstract

The effects of α and β phase interactions on the room-temperature tensile and creep deformation behavior of α + β titanium alloys with Widmanstatten microstructures were studied using Ti-6.0 wt pct Mn and Ti-8.1 wt pct V as the model two-phase alloy systems. This article, Part I, deals with tensile deformation. It was found that when the α phase is present as thin (<10-µm) plates in the α + β alloys, significant twinning occurs. No significant twinning was observed in single-phase alloys with the same chemistry and similar grain size. Additionally, the β phase of Ti-8.1 V deforms by stress-induced hexagonal martensite (α′), while only twinning occurs in the single-phase β alloy with the same chemistry. Twinning in the α phase in association with stress-induced martensite (SIM) in the β phase was observed for the first time in a two-phase titanium alloy. This behavior is explained in terms of a number of factors including elastic interaction stresses between the α and β phases, coherency between the α phase and hexagonal martensite, and β phase stability.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Titanium Alloys Microstructure and Properties · Intermetallics and Advanced Alloy Properties · Advanced materials and composites

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (39)

Show source-provided references
1. P.G. Partridge:Metall. Rev, 1967, vol. 12, pp. 169–94.10.1179/imr.1967.12.1.169 ↗
2. T.S. Kuan, R.R. Ahrens, and S.L. Sass:Metall. Trans. A, 1975, vol. 6A, pp. 1767–74.10.1007/BF02642306 ↗
3. S. Ankem and H. Margolin:Metall. Trans. A, 1983, vol. 14A, pp. 500–03.10.1007/BF02644228 ↗
4. W.G. Burgers:Physics, 1934, vol. 1, pp. 561–86.
5. E.W. Collings:The Physical Metallurgy of Titanium Alloys, ASM, Metals Park, OH, 1984, p. 53.
6. K.M. Knowles:Proc. R. Soc. London A, 1982, vol. 380, pp. 187–200.10.1098/rspa.1982.0036 ↗
7. S. Ankem and H. Margolin:Metall. Trans. A, 1986, vol. 17A, pp. 2209–26.10.1007/BF02645919 ↗
8. D. Bhattacharyya, G.B. Viswanathan, R. Denkenberger, D. Furrer, and H.L. Fraser:Acta Mater., 2003, vol. 51, pp. 4679–91.10.1016/S1359-6454(03)00179-4 ↗
9. S. Ankem and H. Margolin:Metall. Trans. A, 1980, vol. 11A, pp. 963–72.10.1007/BF02654710 ↗
10. H.M. Otte:Proc. 1st Int. Conf. on Titanium, London—Titanium Science and Technology, T.I. Jaffee and H.M. Burte, eds., Pergamon Press, New York, NY, 1970, pp. 645–51.
11. S. Suri, G.B. Viswanathan, T. Neeraj, D.H. Hou, and M.J. Mills:Acta Mater., 1999, vol. 47, pp. 1019–64.10.1016/S1359-6454(98)00364-4 ↗
12. A. Ramesh and S. Ankem:Metall. Trans. A, 1999, vol. 30A, pp. 2249–51.10.1007/s11661-999-0037-5 ↗
13. C.A. Greene: Ph.D. Dissertation, University of Maryland, College Park, MD, 1994.
14. A. Ramesh: Master’s Thesis, University of Maryland, College Park, MD, 1998.
15. A.K. Aiyangar, B.W. Neuberger, P.G. Oberson, and S. Ankem:Metall. Mater. Trans. A, 2005, vol. 36A, pp. 637–44.10.1007/s11661-005-0179-z ↗
16. C.A. Greene:Science and Technology, Proc. 9th Int. Conf. on Titanium—99, I.V. Gorynin and S.S. Ushkov, eds., CRISM “Prometey,” 1999, pp. 585–90.
17. G. Grewal and S. Ankem:Metall. Trans. A, 1989, vol. 20A, pp. 39–54.10.1007/BF02647492 ↗
18. S. Ankem, J.G. Shyue, M.N. Vijayshankar, and R.J. Arsenault:Mater. Sci. Eng., A, 1989, vol. A111, pp. 51–60.10.1016/0921-5093(89)90197-4 ↗
19. D.G. Attwood and P.M. Hazzledine:Metallography, 1976, vol. 9, pp. 483–501.10.1016/0026-0800(76)90016-1 ↗
20. H. Li and L. Salamanca-Riba:Ultramicroscopy, 2001, vol. 88, pp. 171–78.10.1016/S0304-3991(01)00079-1 ↗
21. P.J. Bania: inBeta Titanium Alloys in the 1990’s, D. Eylon, R.R. Boyer, and D.A Koss, eds., TMS, Warrendale, PA, 1993, p. 3.
22. D. Doraiswamy and S. Ankem:Acta Mater., 2003, vol. 51, pp. 1607–19.10.1016/S1359-6454(02)00561-X ↗
23. C. Hammond and P.M. Kelly:Acta Metall., 1969, vol. 17, pp. 869–82.10.1016/0001-6160(69)90107-2 ↗
24. Y.A. Bagariatskii, G.I. Nosova, and T.V. Tagunova:Sov. Phys. Dokl., 1959, vol. 3, pp. 1014–20.
25. M.K. Koul and J.F. Breedis:Acta Metall., 1970, vol. 18, pp. 579–88.10.1016/0001-6160(70)90087-8 ↗
26. M.A. Meyers, O. Vöhringer, and V.A. Lubarda:Acta Mater., 2001, vol. 49, pp. 4025–39.10.1016/S1359-6454(01)00300-7 ↗
27. C.A. Greene and S. Ankem:Mater. Sci. Eng., A, 1995, vol. 202, pp. 103–11.10.1016/0921-5093(95)09786-4 ↗
28. S. Neti, M.N. Vijayshankar, and S. Ankem:Mater. Sci. Eng., A, 1991, vol. A145, pp. 47–54.10.1016/0921-5093(91)90294-W ↗
29. S. Neti, M.N. Vijayshankar, and S. Ankem:Mater. Sci. Eng., A, 1991, vol. A145, pp. 55–63.10.1016/0921-5093(91)90295-X ↗
30. R.E. Lewis, W.C. Coons, J.C. Williams, and G.K. Scarr:Proc. Int. Conf. on Solid to Solid Phase Transformations, H.I. Aaronson, D.E. Laughlin, R.F. Sekerka, and C.M. Wayman, eds., TMS-AIME, Warrendale, PA, 1982, pp. 1499–1503.
31. D.A. Porter and K.E. Easterling:Phase Transformations in Metals and Alloys, 2nd ed., Chapman & Hall, London, 1997.
32. B. Li, X.M. Zhang, P.C. Clapp, and J.A. Rifkin:J. Appl. Phys., 2004, vol. 95 (4), pp. 1698–1705.10.1063/1.1638609 ↗
33. T. Grosdidier, Y. Combres, E. Gautier, and M.J. Philippe:Metall. Mater. Trans. A, 2000, vol. 31A, pp. 1095–1106.10.1007/s11661-000-0105-3 ↗
34. J.R. Patel and M. Cohen:Acta Metall., 1953, vol. 1, pp. 531–40.10.1016/0001-6160(53)90083-2 ↗
35. S. Hanada and O. Izumi:J. Mater. Sci., 1986, vol. 21, pp. 4131–39.10.1007/BF01106518 ↗
36. M. Oka and Y. Taniguchi:Metall. Trans. A, 1979, vol. 10A, pp. 651–53.10.1007/BF02658330 ↗
37. E.S.K. Menon and R. Krishnan:J. Mater. Sci., 1983, vol. 18, pp. 365–74.10.1007/BF00560624 ↗
38. F. Ling, E.A. Starke, Jr., and B.G. LeFevre:Metall. Trans., 1974, vol. 5, pp. 179–87.10.1007/BF02642942 ↗
39. J.L. Murray:Phase Diagrams of Binary Titanium Alloys, ASM INTERNATIONAL, Warrendale, PA, 1987.