journal article·2015-01

Refinement of Eutectic Si in High Purity Al-5Si Alloys with Combined Ca and P Additions

Thomas Hartmut Ludwig, Jiehua Li, Paul Louis Schaffer, Peter Schumacher, Lars Arnberg

Publisher page

Abstract

The effects of combined additions of Ca and P on the eutectic Si in a series of high purity Al-5 wt pct Si alloys have been investigated with the entrained droplet technique and complementary sets of conventional castings. Differential scanning calorimetry (DSC) and thermal analysis were used to investigate the eutectic droplet undercooling and the recalescence undercooling, respectively. Optical microscopy, SEM, EPMA, and TEM were employed to characterize the resultant microstructures. It was found that 250 ppm Ca addition to Al-5Si wt pct alloys with higher P contents leads to a significant increase of the eutectic droplet undercooling. For low or moderate cooling rates, the TEM results underline that Ca additions do not promote Si twinning. Thus, a higher twin density cannot be expected in Ca containing Al-Si alloys after, e.g., sand casting. Consequently, a refinement of the eutectic Si from coarse flake-like to fine plate-like structure, rather than a modification of the eutectic Si to a fibrous morphology, was achieved. This strongly indicates that the main purpose of Ca additions is to counteract the coarsening effect of the eutectic Si imposed by higher P concentrations. Significant multiple Si twinning was observed in melt-spun condition; however, this can be attributed to the higher cooling rate. After DSC heating (slow cooling), most of Si twins disappeared. Thus, the well-accepted impurity-induced twinning mechanism may be not valid in the case of Ca addition. The possible refinement mechanisms were discussed in terms of nucleation and growth of eutectic Si. We propose that the pre-eutectic Al2Si2Ca phase and preferential formation of Ca3P2 deactivate impurity particles, most likely AlP, poisoning the nucleation sites for eutectic Si.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Aluminum Alloy Microstructure Properties · Aluminum Alloys Composites Properties · Solidification and crystal growth phenomena

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (48)

Show source-provided references
1. J.E. Gruzleski and B.M. Closset: The Treatment of Liquid Aluminum-Silicon Alloys, American Foundrymen´s Society, 1990.
2. S.Z. Lu and A. Hellawell: Metall. Trans. A, 1987, vol. 18, pp. 1721-1733.10.1007/BF02646204 ↗
3. S.Z. Lu and A. Hellawell: J. Cryst. Growth, 1985, vol. 73, pp. 316-328.10.1016/0022-0248(85)90308-2 ↗
4. K. Nogita, H. Yasuda, M. Yoshiya, S.D. McDonald, K. Uesugi, A. Takeuchi, and Y. Suzuki: J. Alloys Compd., 2010, vol. 489, pp. 415-420.10.1016/j.jallcom.2009.09.138 ↗
5. A. Knuutinen, K. Nogita, S. McDonald, and A. Dahle: J. Light Met., 2001, vol. 1, pp. 229-240.10.1016/S1471-5317(02)00004-4 ↗
6. Y.H. Cho and A.K. Dahle: Materials and AustCeram 2009 Conference, Gold Coast, Australia, 2009.
7. S.S.S. Kumari, R.M. Pillai, and B.C. Pai: J. Alloys Compd., 2008, vol. 460, pp. 472-477.10.1016/j.jallcom.2007.05.085 ↗
8. S. Kumari, R. Pillai, B. Pai, K. Nogita, and A. Dahle: Metall. Mater. Trans. A, 2006, vol. 37, pp. 2581-2587.10.1007/BF02586230 ↗
9. S.S.S. Kumari, R.M. Pillai, and B.C. Pai: Int. Mater. Rev., 2005, vol. 50, pp. 216-238.10.1179/174328005X14366 ↗
10. C.R. Loper and J.I. Cho: AFS Trans., 2000, vol. 108, pp. 585-592.
11. L.F. Mondolfo, Aluminum alloys: structure and properties. 1976, London: Butterworths. IX, 971 s.
12. A. Abdollahi and J. Gruzleski: Int. J. Cast Met. Res., 1998, vol. 11, pp. 145-156.10.1080/13640461.1998.11819269 ↗
13. J.H. Li, S. Suetsugu, Y. Tsunekawa, and P. Schumacher: Metall. Mater. Trans. A, 2013, vol. 44, pp. 669-681.10.1007/s11661-012-1410-3 ↗
14. J.H. Li and P. Schumacher: Int. J. Cast Met. Res., 2012, vol. 25, pp. 347-357.10.1179/1743133612Y.0000000039 ↗
15. S. Khan and R. Elliott: J. Mater. Sci., 1994, vol. 29, pp. 736-741.10.1007/BF00445987 ↗
16. C.J. Simensen, Ø. Nielsen, F. Hillion, and J. Voje: Metall. Mater. Trans. A, 2007, vol. 38, pp. 1448-1451.10.1007/s11661-007-9165-y ↗
17. V.D. Belov, A.V. Kurdyumov, and S.V. Inkin: The Soviet Journal of non-ferrous metals, 1981, vol. 9, pp. 497.
18. M.B. Gokhshtein and L.S. Vasil’eva: Met. Sci. Heat Treat., 1970, vol. 12, pp. 591-593.10.1007/BF00664955 ↗
19. H. Lescuyer, M. Allibert, and G. Laslaz: J. Alloys Compd., 1998, vol. 279, pp. 237-244.10.1016/S0925-8388(98)00686-0 ↗
20. S.Z. Beer: J. Electrochem. Soc., 1969, vol. 116, pp. 263-265.10.1149/1.2411811 ↗
21. S.-M. Liang and R. Schmid-Fetzer: CALPHAD, 2013, vol. 42, pp. 76–85.10.1016/j.calphad.2013.07.001 ↗
22. K. Nogita, S.D. McDonald, K. Tsujimoto, K. Yasuda, and A.K. Dahle: J. Electron Microsc., 2004, vol. 53, pp. 361-369.10.1093/jmicro/dfh048 ↗
23. S.C. Flood and J.D. Hunt: Met. Sci., 1981, vol. 15, pp. 287-294.10.1179/030634581790426813 ↗
24. P.B. Crosley and L.F. Mondolfo: AFS Trans., 1966, vol. 74, pp. 53-64.
25. Y.H. Cho, H.C. Lee, K.H. Oh, and A.K. Dahle: Metall. Mater. Trans. A, 2008, vol. 39, pp. 2435-2448.10.1007/s11661-008-9580-8 ↗
26. W. Jie, Z. Chen, W. Reif, and K. Müller: Metall. Mater. Trans. A, 2003, vol. 34, pp. 799-806.10.1007/s11661-003-1008-x ↗
27. M. Calvo-Dahlborg, P.S. Popel, M.J. Kramer, M. Besser, J.R. Morris, and U. Dahlborg: J. Alloys Compd., 2013, vol. 550, pp. 9-22.10.1016/j.jallcom.2012.09.086 ↗
28. C.C. Wang and C.S. Smith: TMS-AIME, 1950, vol. 188, pp. 136-138.
29. K.I. Moore, D.L. Zhang, and B. Cantor: Acta Metall. Mater., 1990, vol. 38, pp. 1327-1342.10.1016/0956-7151(90)90205-U ↗
30. M. Zarif, B. McKay, J. Li, and P. Schumacher: BHM, 2010, vol. 155, pp. 506-511.
31. J.H. Li, M.Z. Zarif, G. Dehm, and P. Schumacher: Philos. Mag., 2012, vol. 92, pp. 3789-3805.10.1080/14786435.2012.687840 ↗
32. A. Dahle, K. Nogita, S. McDonald, J. Zindel, and L. Hogan: Metall. Mater. Trans. A, 2001, vol. 32, pp. 949-960.10.1007/s11661-001-0352-y ↗
33. A.K. Dahle, K. Nogita, S.D. McDonald, C. Dinnis, and L. Lu: Mater. Sci. Eng., A, 2005, vol. 413-414, pp. 243-248.10.1016/j.msea.2005.09.055 ↗
34. T.H. Ludwig, P.L. Schaffer, and L. Arnberg: Metall. Mater. Trans. A, 2013, 44, 5796–5805.10.1007/s11661-013-1945-y ↗
35. C.R. Ho and B. Cantor: Acta Metall. Mater., 1995, vol. 43, pp. 3231-3246.10.1016/0956-7151(94)00480-6 ↗
36. T.H. Ludwig, E. Schonhovd Dæhlen, P.L. Schaffer, and L. Arnberg: J. Alloys Compd., 2014, vol. 586, pp. 180-190.10.1016/j.jallcom.2013.09.127 ↗
37. K. Nogita, A. Knuutinen, S. McDonald, and A. Dahle: J. Light Met., 2001, vol. 1, pp. 219-228.10.1016/S1471-5317(02)00005-6 ↗
38. D. Zhang and B. Cantor: Metall. Trans. A, 1993, vol. 24, pp. 1195-1204.10.1007/BF02657251 ↗
39. C.R. Ho and B. Cantor: J. Mater. Sci., 1995, vol. 30, pp. 1912-1920.10.1007/BF00353013 ↗
40. W.T. Kim, D.L. Zhang, and B. Cantor: Metall. Trans. A, 1991, vol. 22, pp. 2487-2501.10.1007/BF02665015 ↗
41. M. Zarif, B. McKay, and P. Schumacher: Metall. Mater. Trans. A, 2011, vol. 42, pp. 1684-1691.10.1007/s11661-010-0553-3 ↗
42. C.Y. Yeh, Z.W. Lu, S. Froyen, and A. Zunger: Phys. Rev. B: Condens. Matter, 1992, vol. 46, pp. 10086-10097.10.1103/PhysRevB.46.10086 ↗
43. M.E. Straumanis and E.Z. Aka: J. Appl. Phys., 1952, vol. 23, pp. 330-334.10.1063/1.1702202 ↗
44. M.E. Schlesinger: Chem. Rev., 2002, vol. 102, pp. 4267-4302.10.1021/cr000039m ↗
45. D. Turnbull and B. Vonnegut: Ind. Eng. Chem., 1952, vol. 44, pp. 1292-1298.10.1021/ie50510a031 ↗
46. B. Aronsson, T. Lundström, and S. Rundqvist, Borides, Silicides, and Phosphides: A Critical Review of Their Preparation, Properties and Crystal Chemistry. 1965: Wiley; Methuen.
47. K. Al-Helal, Y. Wang, I. Stone, and Z. Fan: Mater. Sci. Forum, 2013, vol. 765, pp. 117-122.10.4028/www.scientific.net/MSF.765.117 ↗
48. S.D. McDonald, A.K. Dahle, J.A. Taylor, and D.H. StJohn: Metall. Mater. Trans. A, 2004, vol. 35, pp. 1829-1837.10.1007/s11661-004-0091-y ↗