Effect of impurity type on boundary sliding behavior in the superplastic Zn-22 pct Al alloy
Source abstract
Abstract
The effect of impurity type on boundary sliding behavior in the superplastic Zn-22 pct Al alloy was investigated using two grades of the alloy: Zn-22 pct Al-0.13 pct Cu (grade Cu) and Zn-22 pct Al-0.14 pct Fe (grade Fe). In the investigation, boundary sliding offset measurements in both grades were made at strain rates ranging from 5×10−7/s to 10−1/s. This range of strain rate covered region I (the low strain rate region), region II (the intermediate strain rate region), and region III (the high strain rate region) of the sigmoidal plot between stress and strain rate that was previously reported for grade Fe. The experimental results show that the contributions of boundary sliding to the total strain, ξ, in the two grades of Zn-22 pct Al are about 20 and 52 pct at high (region III) and intermediate (region II) strain rates, respectively. By contrast, the experimental data reveal that ξ in grade Cu at low strain rates (52 pct) is essentially equal to that at intermediate strain rates (region II), while ξ in grade Fe at low strain rates (24 pct) is considerably lower than that at intermediate strain rates (56 pct). It is demonstrated that the difference in sliding behavior between grade Fe and grade Cu at low strain rates corresponds well with the difference in superplastic behavior between the two grades. In addition, consideration of the present and earlier data on sliding behavior in Zn-22 pct Al provides a correlation between two roles played by boundaries during superplastic deformation: the ability of boundaries to contribute to deformation through the process of boundary sliding and their ability to serve as favorable sites for the accumulation of impurities, i.e., boundary segregation.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Aluminum Alloys Composites Properties · Microstructure and mechanical properties · Aluminum Alloy Microstructure Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (42)
Show source-provided references
1. F.A. Mohamed and T.G. Langdon: Acta Metall., 1975, vol. 23, pp. 117–24.10.1016/0001-6160(75)90076-0 ↗
2. F.A. Mohamed, S.-A. Shei, and T.G. Langdon: Acta Metall., 1975, vol. 23, pp. 1443–50.10.1016/0001-6160(75)90153-4 ↗
3. F.A. Mohamed and T.G. Langdon: Phil. Mag., 1975, vol. 32, pp. 697–709.10.1080/14786437508221614 ↗
4. S.H. Vale, D.J. Eastgate, and P.M. Hazzledine: Scripta Metall., 1979, vol. 13, pp. 1157–62.10.1016/0036-9748(79)90274-6 ↗
5. R.C. Gifkins: in Superplastic Forming of Structural Alloys, N.E. Paton and C.H. Hamilton, eds., TMS-AIME, San Diego, CA, 1982, pp. 2–26.
6. B.P. Kashyap, A. Arieli, and A.K. Mukherjee: J. Mater. Sci., 1985, vol. 28, pp. 2661–86.10.1007/BF00553028 ↗
7. O.D. Sherby and J. Wadsworth: Progr. Mater. Sci., 1989, vol. 33, pp. 169–221.10.1016/0079-6425(89)90004-2 ↗
8. A. Vevecka and T.G. Langdon: Mater. Sci., 1994, vol. A187, pp. 161–65.
9. R.B. Vastava and T.G. Langdon: Acta Metall., 1979, vol. 27, pp. 251–57.10.1016/0001-6160(79)90103-2 ↗
10. K.T. Park, S. Yan, and F.A. Mohamed: Phil. Mag., 1995, vol. 72, pp. 891–903.10.1080/01418619508239942 ↗
11. K. Duong and F.A. Mohamed: Acta Mater., 1998, vol. 46, pp. 4571–86.10.1016/S1359-6454(98)00128-1 ↗
12. Z.-R. Lin, A.H. Chokshi, and T.G. Langdon: J. Mater. Sci., 1988, vol. 23, pp. 2712–22.10.1007/BF00547441 ↗
13. P.K. Chaudhury and F.A. Mohamed: Acta Metall., 1988, vol. 36, pp. 1099–1110.10.1016/0001-6160(88)90163-0 ↗
14. K.T. Park and F.A. Mohamed: Metall. Trans. A, 1990, vol. A21, pp. 2605–08.10.1007/BF02647008 ↗
15. P.K. Chaudhury, K.T. Park, and F.A. Mohamed: Metall. Mater. Trans. A, 1994, vol. 25A, pp. 2391–2401.10.1007/BF02648859 ↗
16. S. Yan, J.C. Earthman, and F.A. Mohamed: Phil. Mag. A, 1994, vol. 69, pp. 1017–38.10.1080/01418619408242236 ↗
17. S.T. Yang and F.A. Mohamed: Metall. Mater. Trans. A, 1995, vol. A26, pp. 493–95.10.1007/BF02664685 ↗
18. X.G. Jiang, S.T. Yang, J.C. Earthman, and F.A. Mohamed: Metall. Mater. Trans. A, 1996, vol. 27A, pp. 863–72.10.1007/BF02649753 ↗
19. A. Yousefiani and F.A. Mohamed: Metall. Mater. Trans. A, 1998, vol. 29A, pp. 1653–63.10.1007/s11661-998-0088-z ↗
20. M.J. Mayo and W.D. Nix: Acta Metall., 1989, vol. 37, pp. 1121–34.10.1016/0001-6160(89)90108-9 ↗
21. R.C. Gifkins: Scripta. Metall., 1991, vol. 25, pp. 1397–1400.10.1016/0956-716X(91)90421-V ↗
22. R.C. Gifkins: Metal Forum, 1991, vol. 15, pp. 82–94.
23. R.L. Bell, C. Graeme-Barber, and T.G. Langdon: Trans. Am. Inst. Min. Eng., 1967, vol. 239, pp. 1821.
24. A. Ball and M.M. Hutchinson: Met. Sci. J., 1969, vol. 3, pp. 1–7.10.1016/0036-9748(69)90167-7 ↗
25. A.K. Mukherjee: Mater. Sci. Eng., 1971, vol. 8, pp. 83–89.10.1016/0025-5416(71)90085-1 ↗
26. R.C. Gifkins: Metall. Trans. A, 1976, vol. 7A, pp. 1225–32.10.1007/BF02656607 ↗
27. J.H. Gittus: J. Eng. Mater. Technol., 1977, vol. 99, pp. 244–51.10.1115/1.3443527 ↗
28. V. Paidar and S. Takeuchi: Acta Metall. Mater., 1992, vol. 40, pp. 1773–82.10.1016/0956-7151(92)90120-4 ↗
29. F.A. Mohamed: J. Mater. Sci., 1983, vol. 18, pp. 582–92.10.1007/BF00560647 ↗
30. H. Gleiter and B. Chalmers: Progr. Mater. Sci., 1972, vol. 16.
31. H. Riedel: in Fracture at High Temperatures, B. Ilschner and N. Grant, eds., MRE Springer-Verlag, New York, NY, 1986, p. 116.
32. D. McLean: Met. Forum, 1981, vol. 4, pp. 44–47.
33. M.P. Seah and C. Lea: Phil. Mag., 1975, vol. 31, pp. 627–45.10.1080/14786437508226543 ↗
34. E.A. Grey and G.T. Higgins: Acta Metall., 1973, vol. 21, pp. 309–21.10.1016/0001-6160(73)90186-7 ↗
35. R.C. Gifkins: in Strength of Metals and Alloys, R.G. Gifkins, ed., Pergamon Press, Oxford, United Kingdom, 1982, p. 1.
36. R.C. Gifkins: J. Mater. Sci., 1978, vol. 13, pp. 1926–36.10.1007/BF00552899 ↗
37. A. Yousefiani and F.A. Mohamed: Metall. Mater. Trans. A, 2000, vol. 31A, pp. 163–72.10.1007/s11661-000-0062-x ↗
38. P. Shariat, R.B. Vastava, and T.G. Langdon: Acta Metall., 1982, vol. 30, pp. 285–96.10.1016/0001-6160(82)90068-2 ↗
39. M.F. Ashby: Surf. Sci., 1972, vol. 31, pp. 498–542.10.1016/0039-6028(72)90273-7 ↗
40. A. Eberhardt and B. Baudelet: Phil. Mag., 1980, vol. 41, pp. 843–69.10.1080/01418618008243892 ↗
41. Tadao Watanabe, Shin-Ichoro Kimura, and Seiichi Karashima: Phil. Mag., 1984, vol. 49, pp. 845–64.10.1080/01418618408236566 ↗
42. K.-I. Hirano, R.P. Agarwala, and M. Cohen: Acta Metall., 1962, vol. 10, pp. 857–63.10.1016/0001-6160(62)90100-1 ↗