journal article·2021-07

Load Partitioning Between Mg17Al12 Precipitates and Mg Phase in the AZ91 Alloy Using In-Situ Synchrotron Radiation Diffraction Experiments

G. Garces, J. Medina, B. Chávez, P. Perez, R. Barea, A. Stark, N. Schell, P. Adeva

Publisher page

Abstract

Load partitioning between Mg17Al12 precipitates and the magnesium matrix was examined from room temperature to 200 °C using in-situ synchrotron radiation diffraction during uniaxial compressive tests of AZ91 alloy. Precipitation of the Mg17Al12 phase during aging increases the yield stress of the alloy compared to the solutionized state. In addition to the increase in critical resolved shear stress for the activation of the deformation system, the magnesium matrix transfers some of its internal load to the harder Mg17Al12 intermetallic phase. Load transfer is carried out by the accumulation of dislocations at the Mg-Mg17Al12 interface. The increase in the local stress induces a widening of diffraction peaks of the Mg17Al12 phase. At 200 °C, dislocations can easily shear through or climb around Mg17Al12 precipitates reducing dramatically their reinforcing capacity and, therefore, the magnesium matrix must bear a higher fraction of the applied load.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Magnesium Alloys: Properties and Applications · Aluminum Alloys Composites Properties · Hydrogen Storage and Materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (48)

Show source-provided references
1. A.F. Crawley and K.S. Milliken: Acta Metall., 1974, Vol. 22, pp. 557-62.10.1016/0001-6160(74)90152-7 ↗
2. D. Duly, J.P. Simon and Y. Brechet: Acta Metall. Mater., 1995, Vol 43, pp. 101-06.
3. M.X. Zhang and P.M. Kelly: Scr. Mater., 2003, Vol. 48, pp. 647-652.10.1016/S1359-6462(02)00555-9 ↗
4. D. Bradai, P. Zieba, E. Bischoff and W. Gust: Mater. Chem. Phys., 2003, Vol 78, pp. 222-226.10.1016/S0254-0584(02)00227-4 ↗
5. S. Celotto: Acta Mater., 2000, Vol. 48, pp. 1775-87.10.1016/S1359-6454(00)00004-5 ↗
6. S. Celotto and T.J. Bastow: Acta Mater., 2001, Vol. 49, pp. 41-51.10.1016/S1359-6454(00)00305-0 ↗
7. J.D. Robson: Acta Mater., 2013, Vol. 61, pp. 7781-7790.10.1016/j.actamat.2013.09.017 ↗
8. K.N. Braszcynska-Malik: J. Alloys Comp., 2009, Vol. 477, pp. 870-876.10.1016/j.jallcom.2008.11.008 ↗
9. J.F. Nie: Metal. Mater. Trans. A, 2013, Vol. 43, pp. 3891-3939.10.1007/s11661-012-1217-2 ↗
10. N. Stanford, J. Geng, Y.B. Chun, C.H.J. Davies, J.F. Nie and M.R. Barnett: Acta Mater., 2012, Vol. 60, pp. 218-228.10.1016/j.actamat.2011.10.001 ↗
11. N. Stanford, A.S. Taylor, P. Cizek, F. Siska, M. Ramajayam and M.R. Barnett: Scr. Mater., 2012, Vol. 67, pp. 704-07.10.1016/j.scriptamat.2012.06.035 ↗
12. J.H. Jun: J. Alloys Comp., 2017, Vol. 725, pp. 237-241.10.1016/j.jallcom.2017.07.147 ↗
13. A. Vaid, J. Guénolé, A. Prakash, S. Korte-Kerzel and E. Bitzek: Materialia, 2019, Vol. 7, 100355.10.1016/j.mtla.2019.100355 ↗
14. M. Liao, B. Li and M.F. Horstemeyer: Comp. Mater. Sci., 2013, Vol. 79, pp. 534-539.10.1016/j.commatsci.2013.07.016 ↗
15. M. Liao, B. Li and M. F Horstemeyer: Metal. Mater. Trans. A, 2014, Vol. 45, pp. 3661-3669.10.1007/s11661-014-2284-3 ↗
16. C. M. Cepeda-Jiménez, M. Castillo-Rodríguez and M. T. Pérez-Prado: Acta Mater., 2019, Vol. 165, pp. 164-76.10.1016/j.actamat.2018.11.044 ↗
17. J. Ragani, P. Donnadieu, C. Tassin and J.J. Blandin: Scr. Mater, 2011, Vol. 65, pp. 253-256.10.1016/j.scriptamat.2011.04.022 ↗
18. K. Hagihara and K. Hayakawa: Mater. Sci. Eng. A, 2018, Vol. 737, pp. 393-400.10.1016/j.msea.2018.09.056 ↗
19. H.N. Mathus, V. Maier-Kiener and S. Korte-Kerzel: Acta Mater., 2016, Vol. 113, pp. 221-229.10.1016/j.actamat.2016.05.001 ↗
20. M.A. Gharghouri, G.C. Weatherly, J.D. Embury and J. Root, Phil. Mag. A, 1999, Vol. 79, pp. 1671-95.10.1080/01418619908210386 ↗
21. S.R. Kada, P.A. Lynch, J.A. Kimpton and M.R. Barnett: Acta Mater., 2016, Vol. 119, pp. 145-156.10.1016/j.actamat.2016.08.022 ↗
22. J. J. Bhattacharyya, S. R. Kada, M. R. Barnett and S. R. Agnew: Materialia, 2019, Vol. 6, 100308.10.1016/j.mtla.2019.100308 ↗
23. H. Zhang, S.L. Shang, Y. Wang, A. Saengdeejing, L.Q. Chen and Z.K. Liu: Acta Mater., 2010, Vol. 58, pp. 4012-4018.10.1016/j.actamat.2010.03.020 ↗
24. H.-W. Chang, M.-X. Zhang, A. Atrens and H. Huang: J. Alloys Comp., 2014, Vol. 587, pp. 527-532.10.1016/j.jallcom.2013.10.235 ↗
25. A.P. Hammersley: ESRF Internal Report, ESRF97HA02T, ``FIT2D: An Introduction and Overview’’, 1997.
26. L. Lutterotti, M. Bortolotti, G. Ischia, I. Lonardelli and H.R. Wenk, Z. Krist. Suppl., 2007. Vol. 1, pp. 125–30.
27. J. Schindelin, C.T. Rueden, M.C. Hiner, and K.W. Eliceiri: Mol. Reprod. Dev., 2015, Vol. 82, pp. 518–529.10.1002/mrd.22489 ↗
28. L. Lutterotti, S. Matthies, H.-R. Wenk, A. S. Schultz, and J. W. Richardson: J. Appl. Phys., 1997, Vol. 81, pp. 594–600.10.1063/1.364220 ↗
29. S.R. Agnew, R.P. Mulay, F.J. Polesak III, C.A. Calhoun, J.J. Bhattacharyya and B. Clausen: Acta Mater., 2013, Vol. 61, pp. 3769-80.10.1016/j.actamat.2013.03.010 ↗
30. D. W. Brown, S.R. Agnew, M.A.M Bourke, T.M. Holden, S.C. Vogel and C.N. Tome (2005) Mater. Sci. Eng. A Vol. 399, pp. 1-12.10.1016/j.msea.2005.02.016 ↗
31. S.R. Agnew, D.W. Brown and C.N. Tome: Acta Mater., 2006, Vol. 54, pp. 4841-4852.10.1016/j.actamat.2006.06.020 ↗
32. Y.H. Duan, Y. Sun, M.J. Peng, Z.Z. Guo: Solid Sta. Sci., 2011, Vol. 13, pp. 455−459.10.1016/j.solidstatesciences.2010.12.011 ↗
33. F. Wang, S. Sun, B. Yu, F. Zhang, P. Mao, Z. Liu: Trans. Nonferrous Met. Soc. China, 2016, Vol. 26, pp. 203−12.10.1016/S1003-6326(16)64107-9 ↗
34. W.C. Hu, Y. Liu, X.W. Hu, D.J. Li, X.Q. Zeng, X. Yang, Y.X. Xu, X.S. Zeng, K.G. Wang, B.L Huang (2015) Philos. Mag., Vol. 95, pp. 1626-1645.10.1080/14786435.2015.1040098 ↗
35. Z.W. Huang, Y.H. Zhao, H. Hou and P.D. Han, Physica B, 2012, Vol. 407, pp.1075-1081.10.1016/j.physb.2011.12.132 ↗
36. D.W. Zhou, J.S. Liu, S.H. Xu and P. Peng: Physica B, 2010, Vol. 405, pp. 2863-2868.10.1016/j.physb.2010.04.013 ↗
37. H. Zhang, S.L. Shang, Y. Wang, A. Saengdeejing, L.Q. Chen, Z.K. Liu: Acta Mater., 2010, Vol. 58, pp. 4012-4018.10.1016/j.actamat.2010.03.020 ↗
38. G. Requena, D. Canelo-Yubero, J. Corrochano, J. Repper and G. Garces: Composites A, 2012, Vol. 43, pp. 1981-1988.10.1016/j.compositesa.2012.07.004 ↗
39. G. Garcés, E. Oñorbe, P. Pérez, I. A. Denks and P. Adeva: Mater. Sci. Eng. A, 2009, Vol. 523, pp. 21-26.10.1016/j.msea.2009.06.026 ↗
40. G. Garcés, K. Máthis, P. Pérez, J. Čapek and P. Adeva: Mater. Sci. Eng. A, 2016, Vol. 666, pp. 48-53.10.1016/j.msea.2016.04.028 ↗
41. P. Withers, M. Preuss, A. Steuwer and J. Pang: J. Appl. Crystallogr, 2007, Vol. 40, pp. 891–904.10.1107/S0021889807030269 ↗
42. R. Jenkins, R. Snyder: Introduction to X-ray powder diffractometry, 1996, Wiley, New York.10.1002/9781118520994 ↗
43. Y.H. Zhao, H.W. Sheng, K. Lu: Acta Mater., 2001, Vol. 49, pp. 365-375.10.1016/S1359-6454(00)00310-4 ↗
44. G. Garces, J. Medina, P. Pérez, K. Máthis, K. Horváth, A. Stark, N. Schell and P. Adeva: Acta Mater., 2018, Vol. 151, pp. 271-281.10.1016/j.actamat.2018.03.060 ↗
45. R.M. Wang, A. Eliezer, E. Gutman: Mater. Sci. Eng. A, 2002, Vol. 344, pp. 279-287.10.1016/S0921-5093(02)00413-6 ↗
46. C.R. Hutchinson, J.F. Nie, S. Grosse: Metall. Mater. Trans. A., 2005, Vol. 36, pp. 2093-2105.10.1007/s11661-005-0330-x ↗
47. S. Si, J. WI. P. Jones, Y.L. Chiu: Philos. Mag., https://doi.org/10.1080/14786435.2020.1802077.10.1080/14786435.2020.1802077 ↗
48. X. Ma, Q.J. Laszlo, J. Kecskes, J. A. El-Awady, T. P. Weihs (2020) Acta Mater. 189, 35-46.10.1016/j.actamat.2020.02.037 ↗