journal article·2010-07Open access

Influence of the Substrate on the Creep of SN Solder Joints

K.-O. Lee, J.W. Morris, F. Hua

Abstract

The creep rate of Sn solder joints is noticeably affected by joint metallization. Cu|Sn|Cu joints have significantly higher creep rates than Ni|Sn|Cu joints, which, in turn, have higher creep rates than Ni|Sn|Ni joints. Replacing Ni by Cu on both substrates increases the creep rate at 333 K (60 °C) by roughly an order of magnitude. The increased creep rate appears with no apparent change in the dominant creep mechanism; the change in the constitutive equation for creep (the Dorn equation) is in the pre-exponential factor. The decreased creep rate on substituting Ni is accompanied by an increase in the hardness of the polygranular solder but a decrease in the nanohardness of the grain interiors. The source of the strong influence of the Ni substrate appears to be the introduction of an array of Ni 3 Sn 4 intermetallic precipitates along the grain boundaries. These precipitates inhibit grain boundary sliding, boundary reconfiguration, and grain growth during creep. The intermediate creep rate of the asymmetric Ni|Sn|Cu joint has two causes: a decrease in grain boundary mobility due to precipitate decoration and a restriction in the free volume of the joint due to rapid intermetallic growth from the substrate on the Ni side. The sources of this anomalous intermetallic growth are discussed.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Electronic Packaging and Soldering Technologies · Intermetallics and Advanced Alloy Properties · High Temperature Alloys and Creep

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (21)

Show source-provided references
1. H.J. Frost and M.F. Ashby: Deformation-Mechanism Maps, Pergamon, New York, NY, 1982.
2. Y. Kariya and M. Otsuka: J. Electron. Mater., 1998, vol. 27 (11), pp. 1229–35.10.1007/s11664-998-0074-7 ↗
3. C. Kanchanomai, Y. Miyahita, and Y. Mutoh: Int. J. Fatigue, 2002, vol. 24, pp. 671–83.10.1016/S0142-1123(01)00186-4 ↗
4. J. Liang, N. Gollhardt, P.S. Lee, S.A. Schroeder, and W.L. Morris: Fatigue Fract. Eng. Mater. Struct., 1996, vol. 19 (11), pp. 1401–09.10.1111/j.1460-2695.1996.tb00175.x ↗
5. C. Kanchanomai, S. Yamamoto, Y. Miyahsita, Y. Mutoh, and A.J. Mcevily: Int. J. Fatigue, 2002, vol. 24, pp. 57–67.10.1016/S0142-1123(01)00052-4 ↗
6. S. Wen, L.M. Keer, and H. Mavoori: J. Electron. Mater., 2001, vol. 30 (9), pp. 1190–96.10.1007/s11664-001-0149-1 ↗
7. J. Zhao, Y. Mutoh, Y. Miyashita, and S.L. Mannan: J. Electron. Mater., 2002, vol. 31, (8), pp. 879–86.10.1007/s11664-002-0199-z ↗
8. H.G. Song, J.W. Morris, Jr., and F. Hua: JOM, 2002, vol. 54, (6), pp. 30–32.10.1007/BF02701846 ↗
9. D.K. Joo, S.W. Shin, K.O. Lee, and Jin Yu: 52th ECTC, 2002, pp. 1221–25.
10. S.K. Kang, W.K. Choi, D.Y. Shin, P. Lauro, D.W. Henderson, T. Gosselin, and D.N. Leonard: 52th ECTC, 2002, pp. 146–53.
11. S.J. Zaefferer: Appl. Cryst., 2000, vol. 30, pp. 10–25.10.1107/S0021889899010894 ↗
12. J.E. Bird, A.K. Mukherjee, and J.E. Dorn: Quantitative Relation between Properties and Microstructure, D.G. Brandon and A. Rosen, eds., Israel University Press, Jerusalem, Israel, 1969, p. 255.
13. J.W. Morris, Jr. and H.L. Reynolds: in Design and Reliability of Solders and Solder Interconnections, R.K. Mahidhara, D.R. Frear, S.M.L. Sastry, K.L. Murty, P.K. Liaw, and W. Winterbottom, eds., TMS, Warrendale, PA, 1997, p. 49
14. M. Kerr and N. Chawla: Acta Mater., 2004, vol. 52, pp. 4527–35.10.1016/j.actamat.2004.06.010 ↗
15. R. Lagneborg and B. Bergman: Met. Sci., 1976, vol. 10, pp. 10–20.10.1179/030634576790431462 ↗
16. K.O. Lee, J.W. Morris, Jr., and F. Hua: 10th Int. Symp. on Advanced Packaging Materials: Processes, Properties and Interfaces (IEEE Cat. No. 05TH8808), IEEE, Piscataway, NJ, 2005, pp. 17–20.
17. A.U. Telang, T.R. Bieler, D.E. Mason, and K.N. Subramanian: J. Electron. Mater., 2003, vol. 32, pp. 1455–62.10.1007/s11664-003-0115-1 ↗
18. N. Chawla and R.S. Sidhu: J. Mater. Sci., Materials in Electronics, Special Issue on Pb-Free Solders, 2007, vol. 18, pp. 175–89.10.1007/s10854-006-9028-0 ↗
19. S.J. Wang and C.Y. Liu: J. Electron. Mater., 2003, vol. 32, pp. 1303–09.10.1007/s11664-003-0027-0 ↗
20. A.U. Telang, T.R. Bieler, S. Choi, and K.N. Subramanian: J. Mater. Res., 2002, vol. 17, pp. 2294–2306.10.1557/JMR.2002.0337 ↗
21. S. Tosima, S. Harada, and E.O. Johnson: RCA (Radio Corporation of America) Rev., 1984, vol. 45, pp. 90–108.