Plastic-Strain-Amplitude Dependence of Dislocation Structures in Cyclically Deformed 〈112〉-Oriented Cu-7 at. pct Al Alloy Single Crystals
Source abstract
Abstract
Dislocation structures in $$ [\overline{1} 12] $$ Cu-7 at. pct Al alloy single crystals cyclically deformed at different plastic strain amplitudes were investigated by transmission electron microscope (TEM) and compared with the results of $$ [\overline{1} 12] $$ Cu single crystals. It is found that the plastic strain amplitude γ pl has an obvious effect on the slip deformation mode, and consequently on the cyclic hardening behavior of $$ [\overline{1} 12] $$ Cu-7 at. pct Al alloy single crystals with an intermediate stacking fault energy. For instance, a high slip planarity (i.e., only formation of planar-slip bands) contributes to the occurrence of a gentle cyclic hardening with a much lower saturation stress at a low γ pl of 4.5 × 10−4. A mixed planar/wavy-slip mode (e.g., persistent Luder’s bands/wall-like microstructures) at an intermediate γ pl of 2.2 × 10−3 causes an obvious cyclic hardening up to a comparable saturation stress to that for the $$ [\overline{1} 12] $$ Cu single crystal. In contrast, the deformation mode is dominated by wavy slip (e.g., ill-defined dislocation cells and walls) at the highest γ pl of 7.2 × 10−3, causing that its cyclic hardening curve is quite similar to that for the $$ [\overline{1} 12] $$ Cu single crystal; in this case, a slightly higher saturation stress level than that for the Cu single crystal is reached due to the additional solid solution strengthening.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Microstructure and mechanical properties · Aluminum Alloy Microstructure Properties · Aluminum Alloys Composites Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (35)
Show source-provided references
1. C. Laird, P. Charsley and H. Mughrabi: Mater. Sci. Eng., 1986, vol. 81, pp. 433–50.10.1016/0025-5416(86)90281-8 ↗
2. Z.S. Basinski and S.J. Basinski: Prog. Mater. Sci., 1992, vol. 36, pp. 89–148.10.1016/0079-6425(92)90006-S ↗
3. S. Suresh: Fatigue of Materials, Cambridge University Press, London, 1998.10.1017/CBO9780511806575 ↗
4. X.W. Li, Z.F. Zhang, Z.G. Wang, S.X. Li and Y. Umakoshi: Defect Diffus. Forum, 2001, vol. 188–199, pp. 153–70.10.4028/www.scientific.net/DDF.188-190.153 ↗
5. X.W. Li, Y. Umakoshi, B. Gong, S.X. Li and Z.G. Wang: Mater. Sci. Eng. A, 2002, vol. 333, pp. 51–9.10.1016/S0921-5093(01)01848-2 ↗
6. K. Mecke and C. Blochwitz: Cryst. Res. Technol., 1982, vol. 17, pp. 743–58.10.1002/crat.2170170610 ↗
7. C. Buque: Int. J. Fatigue, 2001, vol. 23, pp. 671–8.10.1016/S0142-1123(01)00032-9 ↗
8. P. Li, Z.F. Zhang, X.W. Li, S.X. Li and Z.G. Wang: Acta Mater., 2009, vol. 57, pp. 4845–54.10.1016/j.actamat.2009.06.048 ↗
9. P. Li, Z.F. Zhang, S.X. Li and Z.G. Wang: Phil Mag., 2009, vol. 89, pp. 2903–20.10.1080/14786430903130847 ↗
10. Z.G. Wang, Z.F. Zhang, X.W. Li, W.P. Jia and S.X. Li: Mater. Sci. Eng. A, 2001, vol. 319–321, pp. 63–73.10.1016/S0921-5093(01)01055-3 ↗
11. F. Ackermann, L.P. Kubin, J. Lepinoux and H. Mughrabi: Acta Metall., 1984, vol. 32, pp. 715–25.10.1016/0001-6160(84)90145-7 ↗
12. X.W. Li, Y.M. Hu and Z.G. Wang: Mater. Sci. Eng. A, 1998, vol. 248, pp. 299–303.10.1016/S0921-5093(98)00501-2 ↗
13. B.D. Yan, A.S. Cheng, L. Bauchinger, S. Stanzl and C. Laird: Mater. Sci. Eng., 1986, vol. 80, pp. 129–42.10.1016/0025-5416(86)90192-8 ↗
14. L. Buchinger, A.S. Cheng, S. Stanzl and C. Laird: Mater. Sci. Eng., 1986, vol. 80, pp. 155–67.10.1016/0025-5416(86)90194-1 ↗
15. S.I. Hong and C. Laird: Mater. Sci. Eng. A, 1990, vol. 128, pp. 155–69.10.1016/0921-5093(90)90224-Q ↗
16. H. Inui, S.I. Hong and C. Laird: Acta Metall. Mater., 1990, vol. 38, pp. 2261–74.10.1016/0956-7151(90)90093-V ↗
17. X.W. Li, X.M. Wu, Z.G. Wang and Y. Umakoshi: Phys. Stat. Sol. (a), 2002, vol 192, pp. R1–R3.10.1002/1521-396X(200207)192:1<R1::AID-PSSA99991>3.0.CO;2-Z ↗
18. X.W. Li, X.M. Wu, Z.G. Wang and Y. Umakoshi: Metall. Mater. Trans. A, 2003, vol. 34A, pp. 307–18.10.1007/s11661-003-0332-5 ↗
19. A. Abel, M. Wilhelm and V. Gerold: Mater. Sci. Eng., 1979, vol. 37, pp. 187–200.10.1016/0025-5416(79)90084-3 ↗
20. S.I. Hong: Scripta Mater., 2001, vol. 44, pp. 995–1001.10.1016/S1359-6462(00)00700-4 ↗
21. X.M. Wu, Z.G. Wang and G.Y. Li: Mater. Sci. Eng. A, 2001, vol. 314, pp. 39–47.10.1016/S0921-5093(00)01927-4 ↗
22. X.W. Li, Z.G. Wang and S.X. Li: Mater. Sci. Eng. A, 1999, vol. 269, pp. 166–74.10.1016/S0921-5093(99)00154-9 ↗
23. B. Gong, Z. Wang and Z.G. Wang: Acta Mater., 1999, vol. 47, pp. 317–24.10.1016/S1359-6454(98)00304-8 ↗
24. T.S. Byum: Acta Mater., 2003, vol. 51, pp. 3063–71.10.1016/S1359-6454(03)00117-4 ↗
25. M. Niewczas and G. Saada: Phil. Mag. A, 2002, vol. 82, pp. 167–91.
26. Z.R. Wang: Phil. Mag., 2004, vol. 84, pp. 351–79.10.1080/14786430310001639824 ↗
27. A.T. Winter: Phil. Mag., 1974, vol. 30, pp. 719–38.10.1080/14786437408207230 ↗
28. S.I. Hong and C. Laird: Acta Metall. Mater., 1990, vol. 38, pp. 1581–94.10.1016/0956-7151(90)90126-2 ↗
29. V. Gerold and H.P. Karnthaler: Acta Metall., 1989, vol 37, pp. 2177–83.10.1016/0001-6160(89)90143-0 ↗
30. Z. Wang, B. Gong and Z.G. Wang: Acta Mater., 1999, vol. 47, pp. 307–15.10.1016/S1359-6454(98)00302-4 ↗
31. C.E. Feltner and C. Laird: Trans. Am. Inst. Min. Metall. Eng., 1968, vol. 242, pp. 1253–57.
32. C.S. Pande and P.M. Hazzledine: Phil. Mag., 1971, vol. 24, pp. 1393–410.10.1080/14786437108217420 ↗
33. P.J. Woods: Phil. Mag., 1973, vol. 28, pp. 155–91.10.1080/14786437308217440 ↗
34. J.S. Ha and S.I. Hong: Mater. Sci. Eng. A, 2013, vol. 565, pp. 9–12.10.1016/j.msea.2012.12.044 ↗
35. C. Laird: in Dislocation in Solids, vol. 6, F.R.N. Nabarro, ed., North-Holland, Amsterdam, 1983, pp. 55–120.