journal article·2018-01

Reverse Transformation Behavior of Ti-6Al-4V After Deformation in the Two-Phase Region

Baoqi Guo, Clodualdo Aranas, Binhan Sun, Xiankun Ji, John J. Jonas

Publisher page

Abstract

Isothermal holding experiments were performed on a Ti-6Al-4V alloy after compression in the two-phase region. The forward transformation took place during compression while the reverse transformation was diffusion controlled when the samples were held after unloading at 940 °C, 970 °C, and 1000 °C. Time-temperature-reverse transformation (TTRT) curves are derived, which indicate that the rate of reverse transformation is independent of temperature when the holding time is 18 seconds. By contrast, it depends on temperature when the holding time is increased to 180 and 1800 seconds.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Titanium Alloys Microstructure and Properties · Microstructure and Mechanical Properties of Steels · Intermetallics and Advanced Alloy Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (16)

Show source-provided references
1. Y. Matsumura and H. Yada: ISIJ Int., 1987, vol. 27, pp. 492-98.10.2355/isijinternational1966.27.492 ↗
2. J. Koike, Y. Shimoyama, I. Ohnuma, T. Okamura, R. Kainuma, K. Ishida and K. Maruyama: Acta Mater., 2000, vol. 48, pp. 2059-69.10.1016/S1359-6454(00)00049-5 ↗
3. H. Yang, G. Gurewitz and A. Mukherjee: Mater. Tran., JIM, 1991, vol. 32, pp. 465-7210.2320/matertrans1989.32.465 ↗
4. T. Zhang, Y. Liu, D.G. Sanders, B. Liu, W. Zhang and C. Zhou: Mater. Sci. Eng., A, 2014, vol. 608, pp. 265-72.10.1016/j.msea.2014.04.098 ↗
5. H. Matsumoto, K. Yoshida, S.-H. Lee, Y. Ono and A. Chiba: Mater. Lett., 2013, vol. 98, pp. 209-12.10.1016/j.matlet.2013.02.033 ↗
6. B.H. Prada, J. Mukhopadhyay and A.K. Mukherjee: Mater. Trans. JIM, 1990, vol. 31, pp. 200-06.10.2320/matertrans1989.31.200 ↗
7. J.J. Jonas, C. Aranas, A. Fall and M. Jahazi: Mater. Des., 2016, vol. 113, pp. 305-10.10.1016/j.matdes.2016.10.039 ↗
8. C. Aranas, S.F. Rodrigues, Y.J. Shen, Z. Zhang and J.J. Jonas: Steel Res. Int., 2017, vol. 88(10), pp. 1-7.10.1002/srin.201700006 ↗
9. C. Ghosh, C. Aranas and J.J. Jonas: Prog. Mater Sci., 2016, vol. 82, pp. 151-233.10.1016/j.pmatsci.2016.04.004 ↗
10. S. Semiatin, B. Kirby and G. Salishchev: Metall. Mater. Trans. A, 2004, vol. 35, pp. 2809-19.10.1007/s11661-004-0228-z ↗
11. S. Semiatin, M. Corbett, P. Fagin, G. Salishchev and C. Lee: Metall. Mater. Trans. A, 2006, vol. 37, pp. 1125-36.10.1007/s11661-006-1091-x ↗
12. C. Aranas and J.J. Jonas: Acta Mater., 2015, vol. 82, pp. 1-10.10.1016/j.actamat.2014.08.060 ↗
13. Kelly AA, Knowles KM (2012) Crystallography and crystal defects, Wiley, New York10.1002/9781119961468 ↗
14. J. Henderson and H. Groot: Thermophysical properties of titanium alloys, Thermophysical Properties Research Laboratory, Purdue University, West Lafayette, 1993.
15. S. Semiatin, F. Zhang, R. Larsen, L. Chapman and D. Furrer: Integrating Materials and Manufacturing Innovation, 2016, vol. 5, pp. 3.10.1186/s40192-016-0046-3 ↗
16. J.J. Jonas and C. Ghosh: Acta Mater., 2013, vol. 61, pp. 6125-31.10.1016/j.actamat.2013.06.054 ↗