journal article·2009-10

Effect of Precipitates on the Development of P Orientation {011}$$ \left\langle {566} \right\rangle $$ in a Recrystallized Continuous Cast AA 3004 Aluminum Alloy after Cold Rolling

Q. Zeng, X. Wen, T. Zhai

Publisher page

Abstract

The as-received hot band (2.54-mm thick) of a continuous cast (CC) AA 3004 Al alloy was cold rolled at reductions, ranging from 25 to 90 pct, and subsequently annealed at 510 °C for 4 hours. Some of these specimens had been annealed at 420 °C for 3 hours with a heating rate of 1 °C/min prior to cold rolling. It was found that the sample with the prior heat treatment exhibited a P orientation ({011}\( \left\langle {566} \right\rangle \)) of 28 pct in volume fraction, stronger than that (23 pct) in the sample without the prior heat treatment, after 90 pct cold rolling and final recrystallization. The transmission electron microscopy (TEM) observations revealed that the prior heat treatment generated very densely distributed Al6(Mn,Fe) precipitates, which could pin dislocations and grain boundaries in the alloy. The formation of stronger P texture in the sample with the prior heat treatment revealed that the P texture could also be developed due to dislocations pinned by the existing fine Al6(Mn,Fe) precipitates during recrystallization in the CC Al alloys that contained Mn.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Aluminum Alloy Microstructure Properties · Aluminum Alloys Composites Properties · Microstructure and mechanical properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (39)

Show source-provided references
1. J. Li, W.C. Liu, T. Zhai, and E.A. Kenik: Scripta Mater., 2005, vol. 52, pp. 163–68.10.1016/j.scriptamat.2004.10.003 ↗
2. J.T. Liu, Y.S. Liu, and J.G. Morris: Mater. Sci. Technol., 2003, vol. 19, pp. 1498–1506.10.1179/026708303225008176 ↗
3. Y.L. Liu, Y. Liu, G. Liao, and J.G. Morris: Alum. Trans., 2000, vol. 2, pp. 97–106.
4. G. Liao, Y. Liu, Y.L. Liu, and J.G. Morris: Alum. Trans., 2000, vol. 2, pp. 319–27.
5. J.T. Liu and J.G. Morris: Metall. Mater. Trans. A, 2003, vol. 34A, pp. 2029–32.10.1007/s11661-003-0169-y ↗
6. O. Engler, P. Yang, and X.W. Kong: Acta Mater., 1996, vol. 44, pp. 3349–69.10.1016/1359-6454(95)00416-5 ↗
7. O. Engler, H.E. Vatne, and E. Nes: Mater. Sci. Eng., 1996, vol. 44, pp. 1389–1411.
8. O. Engler, J. Hirsch, and K. Lucke: Acta Metall. Mater., 1995, vol. 43, pp. 121–38.
9. H.E. Vatne, O. Engler, and E. Nes: Mater. Sci. Technol., 1995, vol. 13, pp. 93–102.10.1179/mst.1997.13.2.93 ↗
10. O. Daaland and E. Nes: Acta Mater., 1996, vol. 44, pp. 1389–411.10.1016/1359-6454(95)00289-8 ↗
11. J.T. Liu, S.W. Banovic, R.J. Fields, and J.G. Morris: Metall. Mater. Trans. A, 2006, vol. 37A, pp. 1887–98.10.1007/s11661-006-0131-x ↗
12. W.C. Liu and J.G. Morris: Scripta Mater., 2007, vol. 56, pp. 217–20.10.1016/j.scriptamat.2006.10.011 ↗
13. J. Hirsch, E. Nes, and K. Lucke: Acta Metall., 1987, vol. 35, pp. 427–38.10.1016/0001-6160(87)90249-5 ↗
14. O. Engler and K. Lucke: Scripta Mater., 1992, vol. 27, pp. 1527–32.10.1016/0956-716X(92)90139-6 ↗
15. O. Daaland and E. Nes: Acta Mater., 1996, vol. 44, pp. 1413–35.10.1016/1359-6454(95)00290-1 ↗
16. W.C. Liu and J.G. Morris: Scripta Mater., 2006, vol. 54, pp. 2095–99.10.1016/j.scriptamat.2006.03.004 ↗
17. O. Engler: Mater. Sci. Technol., 1996, vol. 12, pp. 859–72.10.1179/mst.1996.12.10.859 ↗
18. N.J. Owen, D.J. Field, and E.P. Butler: Mater. Sci. Technol., 1986, vol. 2, pp. 1217–22.10.1179/mst.1986.2.12.1217 ↗
19. Q. Zeng, X. Wen, and T. Zhai: Mater. Sci. Technol., 2009, in press.
20. L.G. Schulz: J. Appl. Phys., 1949, vol. 20, pp. 1033–36.10.1063/1.1698269 ↗
21. M.J. Cai and W.B. Lee: Mater. Sci. Forum, 1994, vols. 157–162, pp. 327–32.10.4028/www.scientific.net/MSF.157-162.327 ↗
22. D.T.L. Alexander and A.L. Greer: Phil. Mag., 2004, vol. 84, pp. 3071–83.10.1080/14786430410001701788 ↗
23. D.T.L. Alexander and A.L. Greer: Mater. Sci. Technol., 2005, vol. 21, pp. 955–60.10.1179/174328405X16270 ↗
24. L. Chen, and J.G. Morris: Scripta Metall., 1984, vol. 18A. pp. 1365–70.10.1016/0036-9748(84)90366-1 ↗
25. S. Saimoto and R.G. Kamat: Mater. Sci. Technol., 1992, vol. 8, pp. 869–74.10.1179/mst.1992.8.10.869 ↗
26. X.F. Xu, Y.M. Zhao, X.Y. Wen, and T. Zhai: Mater. Sci. Eng. A, 2005 vol. 394, pp. 376–84.10.1016/j.msea.2004.11.060 ↗
27. J.X. Li, T. Zhai, M.D. Garratt, and G.H. Bray: Metall. Mater. Trans. A, 2005, vol. 36, pp. 2529–39.10.1007/s11661-005-0126-z ↗
28. J. Li, Q. Zeng, X.Y. Wen, and T. Zhai: Mater. Sci. Technol., 2007, vol. 23 pp. 225–28.10.1179/174328407X154239 ↗
29. J.G. Morris and W.C. Liu: JOM, 2005, vol. 57, pp. 5744–47.10.1007/s11837-005-0026-0 ↗
30. Q. Zeng and T. Zhai: 2009, unpublished research.
31. W.C. Liu and J.G. Morris: Metall. Mater. Trans. A, 2005, vol. 36A, pp. 2829–48.10.1007/s11661-005-0279-9 ↗
32. S. Tangen, K. Sjolatad, E. Nes, T. Furu, and K. Marthinsen: Mater. Sci. Forum, 2002, vols. 396–402, pp. 169–74.
33. O. Engler, X.W. Kong, and K. Lucke: Phil. Mag., 2001, vol. 81, pp. 534–70.10.1080/01418610108212159 ↗
34. O. Engler, X.W. Kong, and K. Lucke: Acta Mater., 2001, vol. 49, pp. 1701–15.10.1016/S1359-6454(01)00087-8 ↗
35. F.J. Humpherys: Acta Metall., 1977, vol. 25, pp. 1323–44.10.1016/0001-6160(77)90109-2 ↗
36. F.J. Humphreys and M. Hatherly: Recrystallization and Related Annealing Phenomena, 2nd ed., Elsevier, New York, NY, 2004.
37. Q. Zeng, E.A. Kenik, and T. Zhai: 2009, unpublished research.
38. P.J. Hurley and F.J. Humphreys: Acta Mater., 2003, vol. 51, pp. 1087–1102.10.1016/S1359-6454(02)00513-X ↗
39. P.J. Hurley, P.S. Bate, and F.J. Humphreys: Acta Mater., 2003, vol. 51, pp. 4737–50.10.1016/S1359-6454(03)00277-5 ↗