journal article·2006-05

Microstructural changes during wear by plastic deformation of cemented carbide and cermet cutting inserts

Gustaf Östberg, Hans-Olof Andrén

Publisher page

Abstract

The microstructure of one WC-Co and two Ti(C,N)-WC-Co cutting inserts has been studied before and after plastic deformation, caused by high-speed turning. It was found that after deformation, the binder phase had infiltrated some of the grain boundaries and formed lamellae between the hard phase grains. The infiltration of grain boundaries was assumed to occur by a stress-induced dissolution along the grain boundaries of the hard phase grains as a wide front of binder phase, rather than gradually by Co grain boundary diffusion. Some localized dissolution of the hard phase could also be seen as faceting of grains in WC-Co and at triple points in cermets. It was concluded that the plastic deformation occurs by grain boundary infiltration with simultaneous grain boundary sliding. The rate of deformation is controlled by grain boundary infiltration through dissolution of the hard phase grains.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advanced materials and composites · Metal Alloys Wear and Properties · Tunneling and Rock Mechanics

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (43)

Show source-provided references
1. J. Lin and C.-Y. Liu: Meas. Sci. Technol., 2001, vol. 12 (8), pp. 1243–49.10.1088/0957-0233/12/8/335 ↗
2. Y.-C. Yen, J. Sohner, B. Lilly, and T. Altan: J. Mater. Processing Technol., 2004, vol. 146 (1), pp. 82–91.10.1016/S0924-0136(03)00847-1 ↗
3. S. Bolognini: in Advances in Mechanical Behaviour, Plasticity and Damage, Elsevier Science, Oxford, United Kingdom, 2000.
4. S. Bolognini, G. Feusier, D. Mari, T. Viatte, and W. Benoit: Int. J. Refract. Met. Hard Mater., 1998, vol. 16 (6), pp. 257–68.10.1016/S0263-4368(98)00033-X ↗
5. S. Bolognini, G. Feusier, D. Mari, T. Viatte, and W. Benoit: Int. J. Refract. Met. Hard Mater., 2003, vol. 21, pp. 19–29.10.1016/S0263-4368(02)00091-4 ↗
6. K. Buss: Ph.D. Thesis, EPFL, Lausanne, Switzerland, 2004.
7. K. Buss and D. Mari: Mater. Sci. Eng., 2004, vol. A370, pp. 163–67.10.1016/j.msea.2002.12.004 ↗
8. T. Cutard, S. Bolognini, G. Feusier, C. Verdon, T. Viatte, and W. Benoit: Key Eng. Mater., 1997, vols. 132–136, pp. 747–50.10.4028/www.scientific.net/KEM.132-136.747 ↗
9. T. Cutard, G. Feusier, T. Viatte, and W. Benoit: Mater. Sci. Eng., 1996, vol. A209, pp. 218–27.10.1016/0921-5093(95)10100-4 ↗
10. G. Feusier, T. Cutard, C. Verdon, T. Viatte, and W. Benoit: J. Phys. IV, 1996, vol. 6 (C8), pp. 751–54.
11. D. Mari, S. Bolognini, T. Viatte, and W. Benoit: Int. J. Refractory Met. Hard Mater., 2001, vol. 19 (4–6), pp. 257–65.10.1016/S0263-4368(01)00037-3 ↗
12. T. Viatte, T. Cutard, G. Feusier, and W. Benoit: J. Phys. IV, 1996, vol. 6 (C8), pp. 743–46.
13. J.G. Baldoni and W.S. Williams: Cer. Bull., 1978, vol. 57 (12), pp. 1100–02.
14. I.N. Chaporova, L.E. Pivovarov, V.A. Ivensen, O.N. Éiduk, T.A. Sultanyan, A.V. Varaksina, R.F. Korotkova, and V.A. Chistyakova: Effects of Plastic Deformation on the Structure of WC-Co Alloys, All-Union Scientific-Research Institute of Hard Alloys, 1969, vol. 77 (5), pp. 63–68.
15. M. Fährmann: Int. J. Refract. Met. Hard Mater., 1989, vol. 8 (4), pp. 219–23.
16. R. Gero, L. Borukhin, and I. Pikus: Mater. Sci. Eng., 2001, vol. A302, pp. 162–67.10.1016/S0921-5093(00)01369-1 ↗
17. V. Jayaram, A. Kronenberg, S.H. Kirby, D.J. Rowcliffe, and R. Sinclair: Scripta Metall., 1986, vol. 20, pp. 701–05.10.1016/0036-9748(86)90495-3 ↗
18. S. Lay, P. Delavignette, and J. Vicens: Phys. Status Solidi., 1985, vol. 90, pp. 53–68.10.1002/pssa.2210900103 ↗
19. S. Lay, J. Vicens, and F. Osterstock: J. Mater. Sci., 1987, vol. 22, pp. 1310–22.10.1007/BF01233127 ↗
20. L. Manlang, H. Xiaoying, D. Shitian, S. Daqin, C. Yumei, and Y. Zhenmei: Int. J. Refract. Met. Hard Mater., 1983, vol. 2 (3), pp. 129–32.
21. Y.V. Milman, S. Luyckx, V.A. Goncharuck, and J.T. Northrop: Int. J. Refract. Met. Hard Mater., 2002, vol. 20, pp. 71–79.10.1016/S0263-4368(01)00072-5 ↗
22. H.S. Mohand, G. Fantozzi, G. Orange, and J. Dubois: Rev. Int. Hautes. Tempér. Refract., 1982, vol. 19, pp. 311–23.
23. B. Roebuck and E.A. Almond: Int. Mater. Rev., 1988, vol. 33 (2), pp. 90–110.10.1179/imr.1988.33.1.90 ↗
24. D.J. Rowcliffe, V. Jayaram, M.K. Hibbs, and R. Sinclair: Mater. Sci. Eng., 1988, vol. A105 (106), pp. 299–303.10.1016/0025-5416(88)90710-0 ↗
25. T. Sakuma: Key Eng. Mater., 1995, vols. 108–110, pp. 435–48.10.4028/www.scientific.net/KEM.108-110.435 ↗
26. T. Sakuma and H. Hondo: Mater. Sci. Eng., 1992, vol. A156, pp. 125–30.10.1016/0921-5093(92)90144-P ↗
27. H. Suzuki, K. Hayashi, Y. Taniguchi, and H. Matsubara: Trans. Jpn. Inst. Met., 1982, vol. 23 (2), pp. 77–84.10.2320/matertrans1960.23.77 ↗
28. G. Wirmark, G.L. Dunlop, and C. Chatfield: Int. J. Refract. Met. Hard Mater., 1986, vol. 5 (3), pp. 153–57.
29. J. Vicens, S. Hagege, F. Osterstock, G. Nouet, and J.L. Chermant: Rev. Int. Hautes. Tempér. Refract., 1982, vol. 19, pp. 359–71.
30. G.E. Hollox and R.E. Smallman: J. Appl. Phys., 1966, vol. 37 (2), pp. 818–23.10.1063/1.1708264 ↗
31. M. Rettenmayr, H.E. Exner, and W. Mader: Mater. Sci. Technol., 1988, vol. 4, pp. 984–90.10.1179/mst.1988.4.11.984 ↗
32. C.H. Vasel, A.D. Krawitz, E.F. Drake, and E.A. Kenik: Metall. Trans. A, 1985, vol. 16A, pp. 2309–17.10.1007/BF02670431 ↗
33. W.S. Williams and R.D. Schaal: J. Appl. Phys., 1962, vol. 33 (3), pp. 955–62.10.1063/1.1777197 ↗
34. G. Östberg and H.-O. Andrén: Chalmers University of Technology, Göteborg, 2005, unpublished research.
35. H.-O. Andrén and H. Nordén: Scand. J. Metall., 1979, vol. 8, pp. 147–52.
36. D.J. Larson, D.T. Foord, A.K. Petford-Long, H. Liew, M.G. Blamire, A. Cerezo, and G.D.W. Smith: Ultramicroscopy, 1999, vol. 79 (1–4), pp. 287–93.10.1016/S0304-3991(99)00055-8 ↗
37. G. Östberg: Chalmers University of Technology, Göteborg, unpublished research.
38. A. Henjered, M. Hellsing, H.-O. Andrén, and H. Nordén: Mater. Sci. Technol., 1986, vol. 2, pp. 847–55.10.1179/mst.1986.2.8.847 ↗
39. G. Östberg, K. Buss, M. Christensen, S. Norgren, H.-O. Andrén, D. Mari, and I. Reineck: Int. J. Refract. Met. Hard Mater., 2006, vol. 24 (1–2), pp. 135–44.10.1016/j.ijrmhm.2005.04.009 ↗
40. G. Östberg, B. Jansson, and H.-O. Andrén: Scripta Mater., 2005, vol. 54, pp. 595–58.10.1016/j.scriptamat.2005.10.040 ↗
41. R.C. Gifkins: J. Mater. Sci., 1978, vol. 13, pp. 1926–36.10.1007/BF00552899 ↗
42. M. Christensen and G. Wahnström: Phys. Rev. B, 2003, vol. 67, pp. 115415-1-115415-11.
43. R.W. Hertzberg: in Deformation and Fracture Mechanics of Engineering Materials, John Wiley & Sons, Singapore, 1989, pp. 271–324.