journal article·2006-11Open access

Yield criteria and strain-rate behavior of Zr57.4Cu16.4Ni8.2Ta8Al10 metallic-glass-matrix composites

R. T. Ott, F. Sansoz, T. Jiao, D. Warner, J. F. Molinari, K. T. Ramesh, T. C. Hufnagel, C. Fan

Abstract

We have examined the yielding and fracture behavior of Zr57.4Cu16.4Ni8.2Ta8Al10 metallic-glass-matrix composites with a small volume fraction (∼4 pct) of ductile crystalline particles under quasi-static uniaxial tension and compression and dynamic uniaxial compression. The yield stress of the composite is the same for quasi-static tension and compression, consistent with a von Mises yield criterion. The measured average angle between the shear bands and the loading axis in quasi-static compression is 47±2 deg, significantly larger than the value of ∼42 deg typically reported for single-phase metallic glasses. Finite element modeling (FEM) shows that the measured value is consistent with both the von Mises criterion (48±4 deg) and the Mohr-Coulomb criterion (46±5 deg). The fracture surface angles, however, are 41±1 deg (compression) and 54±2 deg (tension), in good agreement with observations of single-phase metallic glasses. At low strain rates ( 100 s−1), the failure stress decreases with increasing strain rate, which again is similar to the behavior of single-phase glasses. These results indicate that while the presence of the particles has a significant effect on the yield behavior of the composites, the fracture behavior is largely governed by the properties and behavior of the amorphous matrix.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Metallic Glasses and Amorphous Alloys

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (44)

Show source-provided references
1. H. Kimura and T. Masumoto:Acta Metall., 1980, vol. 28, pp. 1663–75.10.1016/0001-6160(80)90020-6 ↗
2. P.E. Donovan:Acta Metall., 1989, vol. 37, pp. 445–56.10.1016/0001-6160(89)90228-9 ↗
3. Z.F. Zhang, J. Eckert, and L. Schultz:Acta Mater., 2003, vol. 51, pp. 1167–79.10.1016/S1359-6454(02)00521-9 ↗
4. J.J. Lewandowski and P. Lowhaphandu:Philos. Mag. A, 2002, vol. 82, pp. 3427–41.10.1080/0141861021000014821 ↗
5. R. Vaidyanathan, M. Dao, G. Ravichandran, and S. Suresh:Acta Mater., 2001, vol. 49, pp. 3781–89.10.1016/S1359-6454(01)00263-4 ↗
6. C.A. Schuh and T.G. Nieh:J. Mater. Res., 2004, vol. 19, pp. 46–57.10.1557/jmr.2004.19.1.46 ↗
7. C.A. Schuh and A.C. Lund:Nat. Mater., 2003, vol. 2, pp. 449–52.10.1038/nmat918 ↗
8. A.C. Lund and C.A. Schuh:Acta Mater., 2003, vol. 51, pp. 5399–41.10.1016/S1359-6454(03)00396-3 ↗
9. A.C. Lund and C.A. Schuh:Intermetallics, 2004, vol. 12, pp. 1159–65.10.1016/j.intermet.2004.07.001 ↗
10. Z.F. Zhang and J. Eckert:Phys. Rev. Lett., 2005, vol. 94, p. 094301.10.1103/PhysRevLett.94.094301 ↗
11. F. Szuecs, C.P. Kim, and W.L. Johnson:Acta Mater., 2001, vol. 49, pp. 1507–13.10.1016/S1359-6454(01)00068-4 ↗
12. M.L. Lee, Y. Li, and C.A. Schuh:Acta Mater., 2004, vol. 52, pp. 4121–31.10.1016/j.actamat.2004.05.025 ↗
13. J.C. Lee, Y.C. Kim, J.P. Ahn, and H.S. Kim:Acta Mater., 2005, vol. 53, pp. 129–39.10.1016/j.actamat.2004.09.010 ↗
14. C. Fan, R.T. Ott, and T.C. Hufnagel:Appl. Phys. Lett., 2002, vol. 81, pp. 1020–22.10.1063/1.1498864 ↗
15. R.S. Coates and K.T. Ramesh:Mater. Sci. Eng., A, 1991, vol. 145, pp. 159–66.10.1016/0921-5093(91)90245-I ↗
16. R.T. Ott, F. Sansoz, J.F. Molinari, J. Almer, K.T. Ramesh, and T.C. Hufnagel:Acta Mater., 2005, vol. 53, pp. 1883–93.10.1016/j.actamat.2004.12.037 ↗
17. ppm2oof, software, http://www.ctcms.nist.gov/oof.
18. R.D. Conner, R.B. Dandliker, and W.L. Johnson:Acta Mater., 1998, vol. 46, pp. 6089.10.1016/S1359-6454(98)00275-4 ↗
19. H. Choi-Yim, R.D. Conner, F. Szuecs, and W.L. Johnson:Acta Mater., 2002, vol. 50, pp. 2737–45.10.1016/S1359-6454(02)00113-1 ↗
20. G. He, J. Lu, Z. Bian, D. Chen, G. Chen, G. Tu, and C. Chen:Mater. Trans., JIM, 2001, vol. 42, pp. 356–64.10.2320/matertrans.42.356 ↗
21. W.J. Wright, R. Saha, and W.D. Nix:Mater. Trans., JIM, 2001, vol. 42, pp. 642–49.10.2320/matertrans.42.642 ↗
22. P. Wesseling, P. Lowhaphandu, and J.J. Lewandowski:Mater. Res. Soc. Proc., 2003.
23. T. Mukai, T.G. Nieh, Y. Kawamura, A. Inoue, and K. Higashi:Scripta Mater., 2002, vol. 46, pp. 43–47.10.1016/S1359-6462(01)01193-9 ↗
24. Z.F. Zhang, J. Eckert, and L. Schultz:J. Mater. Res., 2003, vol. 18, pp. 456–65.10.1557/JMR.2003.0058 ↗
25. C.T. Liu, L. Heatherly, D.S. Easton, C.A. Carmichael, J.H. Schneibel, C.H. Chen, J.L. Wright, M.H. Yoo, J.A. Horton, and A. Inoue:Metall. Mater. Trans. A, 1998, vol. 29, pp. 1811–20.10.1007/s11661-998-0004-6 ↗
26. T. Mukai, T.G. Nieh, Y. Kawamura, A. Inoue, and K. Higashi:Intermetallics, 2002, vol. 10, pp. 1071–77.10.1016/S0966-9795(02)00137-1 ↗
27. P.E. Donovan and W.M. Stobbs:Acta Metall., 1981, vol. 29, pp. 1419–36.10.1016/0001-6160(81)90177-2 ↗
28. J. Li, F. Spaepen, and T.C. Hufnagel:Philos. Mag. A, 2002, vol. 82, pp. 2623–30.10.1080/01418610210152792 ↗
29. T. Jiao, L.J. Kecskes, T.C. Hufnagel, and K.T. Ramesh:Metall. Mater. Trans. A, 2004, vol. 35, pp. 3439–44.10.1007/s11661-004-0180-y ↗
30. T. Erturk and A.S. Argon:J. Mater. Sci., 1987, vol. 22, pp. 1365–73.10.1007/BF01233135 ↗
31. T.C. Hufnagel, T. Jiao, Y. Li, L.Q. Xing, and K.T. Ramesh:J. Mater. Res., 2002, vol. 17, pp. 1441–45.10.1557/JMR.2002.0214 ↗
32. H.A. Bruck, A.J. Rosakis, and W.L. Johnson:J. Mater. Res., 1996, vol. 11, pp. 503–11.10.1557/JMR.1996.0060 ↗
33. A.V. Sergueeva, N.A. Mara, J.D. Kuntz, E.J. Lavernia, and K.A. Mukherjee:Philos. Mag., 2005, vol. 83, pp. 2671–87.10.1080/14786430500154059 ↗
34. H. Li, G. Subhash, X.-L. Gao, L.J. Kecskes, and R.J. Dowding:Scripta Mater., 2003, vol. 49, pp. 1087–92.10.1016/j.scriptamat.2003.08.012 ↗
35. T. Masumoto and R. Maddin:Acta Metall., 1971, vol. 19, pp. 725–41.10.1016/0001-6160(71)90028-9 ↗
36. H.J. Leamy, H.S. Chen, and T.T. Wang:Metall. Trans., 1972, vol. 3, pp. 699–708.10.1007/BF02642754 ↗
37. T. Murata, T. Masumoto, and M. Sakai:Rapidly Quenched Metals II, The Metals Society, London, 1978, pp. 401–04.
38. S. Takayama:Scripta Metall., 1979, vol. 13, pp. 463–67.10.1016/0036-9748(79)90070-X ↗
39. H. Kimura and T. Masumoto:Amorphous Metallic Alloys, Butterworths and Co., London, 1983. pp. 187–230.10.1016/B978-0-408-11030-3.50017-0 ↗
40. P.E. Donovan:Mater. Sci. Eng., 1988, vol. 98, pp. 487–90.10.1016/0025-5416(88)90213-3 ↗
41. C.A. Pampillo and D.E. Polk:Acta Metall., 1974, vol. 22, pp. 741–49.10.1016/0001-6160(74)90084-4 ↗
42. Handbook of Elastic Properties of Solids: Liquids, and Gases, Academic Press, San Diego, CA, 2001.
43. S.R. Chen and G.T. Gray III:Metall. Mater. Trans. A, 1996, vol. 27, pp. 2994–3006.10.1007/BF02663849 ↗
44. A.S. Khan and R. Liang:Int. J. Plast., 1999, vol. 15, pp. 1089–109.10.1016/S0749-6419(99)00030-3 ↗