journal article·2011-08Open access

Effects of Aging Temperature on Electrical Conductivity and Hardness of Cu-3 at. pct Ti Alloy Aged in a Hydrogen Atmosphere

Satoshi Semboshi, Tomoya Nishida, Hiroshi Numakura, Tala’at Al-Kassab, Reiner Kirchheim

Abstract

To improve the balance of the electrical conductivity and mechanical strength for dilute Cu-Ti alloys by aging in a hydrogen atmosphere, the influence of aging temperature ranging from 673 K to 773 K (400 °C to 500 °C) on the properties of Cu-3 at. pct Ti alloy was studied. The Vickers hardness increases steadily with aging time and starts to fall at 3 hours at 773 K (500 °C), 10 hours at 723 K (450 °C), or over 620 hours at 673 K (400 °C), which is the same as the case of conventional aging in vacuum. The maximum hardness increases from 220 to 236 with the decrease of aging temperature, which is slightly lower than aging at the same temperature in vacuum. The electrical conductivity at the maximum hardness also increases from 18 to 32 pct of pure copper with the decrease of the temperature, which is enhanced by a factor of 1.3 to 1.5 in comparison to aging in vacuum. Thus, aging at 673 K (400 °C) in a hydrogen atmosphere renders fairly good balance of strength and conductivity, although it takes nearly a month to achieve. The microstructural changes during aging were examined by transmission electron microscopy (TEM) and atom-probe tomography (APT), and it was confirmed that precipitation of the Cu 4 Ti phase occurs first and then particles of TiH 2 form as the third phase, thereby efficiently removing the Ti solutes in the matrix.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Microstructure and mechanical properties · Aluminum Alloy Microstructure Properties · Advanced materials and composites

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (23)

Show source-provided references
1. A. Datta and W.A. Soffa: Acta Metall., 1976, vol. 24, pp. 987–1001.10.1016/0001-6160(76)90129-2 ↗
2. S. Nagarjuna, M. Srinvivas, K. Balasubramanian, and D.S. Sarma: Acta Metall., 1996, vol. 44, pp. 2285–93.
3. S. Nagarjuna, K. Balasubramanian, and D.S. Sarma: J. Mater. Sci., 1997, vol. 32, pp. 3375–85.10.1023/A:1018608430443 ↗
4. S. Nagarjuna, M. Srinvivas, K. Balasubramanian, and D.S. Sarma: Scripta Mater., 1998, vol. 38, pp. 1469–74.10.1016/S1359-6462(98)00044-X ↗
5. S. Nagarjuna, M. Srinvivas, K. Balasubramanian, and D.S. Sarma: Mater. Sci. Eng. A, 1999, vol. 259, pp. 34–42.10.1016/S0921-5093(98)00882-X ↗
6. W.A. Soffa and D.E. Laughlin: Prog. Mater. Sci., 2004, vol. 49, pp. 347–66.10.1016/S0079-6425(03)00029-X ↗
7. S. Nagarjuna and M. Srinvivas: Mater. Sci. Eng. A, 2005, vol. 406, pp. 185–94.10.1016/j.msea.2005.06.064 ↗
8. S. Nagarjuna, U.C. Babu, and P. Ghosal: Mater. Sci. Eng. A, 2008, vol. 491, pp. 331–37.10.1016/j.msea.2008.02.014 ↗
9. S. Nagarjuna, K. Balasubramanian, and D.S. Sarma: Mater. Sci. Eng. A, 1997, vol. 225, pp. 118–24.10.1016/S0921-5093(96)10578-5 ↗
10. S. Suzuki, K. Hirabayashi, H. Shibata, K. Mimura, M. Isshiki, and Y. Waseda: Scripta Mater., 2003, vol. 48, pp. 431–35.10.1016/S1359-6462(02)00441-4 ↗
11. S. Semboshi and T.J. Konno: J. Mater. Res., 2008, vol. 23, pp. 473–77.10.1557/JMR.2008.0050 ↗
12. S. Semboshi, T. Nishida, and H. Numakura: Mater. Sci. Eng. A, 2009, vol. 517, pp. 105–13.10.1016/j.msea.2009.03.047 ↗
13. Y. Fukai: The Metal-Hydrogen System, 2nd ed., Springer, Berlin, 2004, pp. 14–27.
14. M.K. Miller: Atom Probe Tomography: Analysis at the Atomic Level, Kluwer Academic/Plenum Publishers, New York, NY, 2000, pp. 121–56.10.1007/978-1-4615-4281-0_5 ↗
15. J. Miyake and M.E. Fine: Acta Metall., 1992, vol. 40, pp. 733–41.10.1016/0956-7151(92)90015-7 ↗
16. J.Y. Brun, S.J. Hamar-Thibault, and C.H. Allibert: Z. Metallkd., 1983, vol. 74, pp. 525–29.
17. U. Zwicker: Z. Metallkd., 1962, vol. 53, pp. 709–12.
18. R. Nishio, T.J. Konno, and S. Semboshi: Mater. Sci. Forum, 2005, vol. 502, pp. 163–68.10.4028/www.scientific.net/MSF.502.163 ↗
19. T.J. Konno, R. Nishio, S. Semboshi, T. Ohsuna, and E. Okunishi: J. Mater. Sci., 2008, vol. 43, pp. 3761–68.10.1007/s10853-007-2233-2 ↗
20. S.B. Qadri, E.F. Skelton, M. Nagumo, A.W. Webb, F.E. Lynch, and R.W. Marmaro: Phys. Rev. B, 1992, vol. 49, pp. 1193–94.10.1103/PhysRevB.46.1193 ↗
21. W.E. Wang: J. Alloys Compd., 1996, vol. 238, pp. 6–12.10.1016/0925-8388(96)02264-5 ↗
22. D. Wolde-Giorgis, T. Al-Kassab, and R. Kirchheim: Mater. Sci. Eng. A, 2003, vol. 353, pp. 152–57.10.1016/S0921-5093(02)00682-2 ↗
23. S. Semboshi, T. Al-Kassab, R. Gemma, and R. Kirchheim: Ultramicroscopy, 2009, vol. 109, pp. 593–98.10.1016/j.ultramic.2008.10.015 ↗