Effect of Annealing on Hardness and the Modulus of Elasticity in Bulk Nanocrystalline Nickel
Source abstract
Abstract
Experiments on hardness and the modulus of elasticity were conducted at room temperature on samples of electrodeposited (ED) nanocrystalline (nc) Ni that were annealed at temperatures ranging from 323 to 693 K (50 to 420 C). The results showed the presence of three regions: I, II, and III. In region I (300 K (27 C) < T < 350 K (77 C)), the hardness and the elastic modulus remained essentially constant. In region II (350 K (77 C) < T < 500 K (227 C)), both the hardness and the elastic modulus increased. In region III (T > 500 K (227 C)), the hardness dropped and then decreased with increasing grain size, whereas the modulus of elasticity approached a maximum plateau of ~240 GPa. It is suggested that while the increase in hardness in region II can be attributed in part to the formation of annealing twins, which serve as a source of strengthening, the decrease in hardness above 500 K (227 C) is due to the occurrence of significant grain growth. The increase in the modulus of elasticity with increasing temperature in region II was attributed to the preferred orientation along (200) that was observed in the as-received samples and that continuously diminished with increasing temperature. In region III (T > 500 K (227 C)), the preferred orientation disappeared and, a result, the modulus of elasticity approached a constant value of approximately 240 GPa.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Microstructure and mechanical properties · Metal and Thin Film Mechanics · Electrodeposition and Electroless Coatings
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (44)
Show source-provided references
1. M.A. Meyers, A. Mishra, and D.J. Benson: Prog. Mater. Sci., 2006, vol. 51, pp. 427–556.10.1016/j.pmatsci.2005.08.003 ↗
2. F.A. Mohamed and Y. Li: Mater. Sci. Eng., 2001, vol. A298, pp. 1–15.10.1016/S0928-4931(00)00190-9 ↗
3. A.H. Chokshi, A. Rosen, J. Karch, and H. Gleiter: Scripta Metall., 1989, vol. 23, pp. 1679–84.10.1016/0036-9748(89)90342-6 ↗
4. G.W. Nieman, J.R. Weertman, and R.W. Siegel: J. Mater. Res., 1991, vol. 6, pp. 1012–27.10.1557/JMR.1991.1012 ↗
5. J.R. Weertman: Mater. Sci. Eng., 1993, vol. A166, pp. 161–67.10.1016/0921-5093(93)90319-A ↗
6. R.W. Siegel and G.E. Fougere: Nanostruct. Mater., 1995, vol. 6, pp. 205–16.10.1016/0965-9773(95)00044-5 ↗
7. A.M. El-Sherik, U. Erb, G. Palumbo, K.T. Aust: Scripta Metall. Mater., 1992, vol. 27, pp. 1185–88.10.1016/0956-716X(92)90596-7 ↗
8. Y.M. Wang, S. Cheng, Q.M. Wei, E. Ma, T.G. Nieh, and A. Hamza: Scripta Mater., 2004, vol. 51, pp. 1023–28.10.1016/j.scriptamat.2004.08.015 ↗
9. F. Dalla Torre, H. Van Swygenhoven, and M. Victoria: Acta Mater., 2002, vol. 50, pp. 3957–70.10.1016/S1359-6454(02)00198-2 ↗
10. Y. Zhou, U. Erb, K.T. Aust, and G. Palumbo: Scripta Mater., 2003, vol. 48, pp. 825–30.10.1016/S1359-6462(02)00511-0 ↗
11. G.E. Fougere, J.R. Weertman, R.W. Siegel, and S. Kim: Scripta Metall. Mater., 1992, vol. 26, pp. 1879–83.10.1016/0956-716X(92)90052-G ↗
12. W.Y. Chen, S.K. Tien, F.B. Wu, and J.G. Duh: Surf. Coat. Technol., 2004, vol. 182, pp. 85–91.10.1016/S0257-8972(03)00851-X ↗
13. B. Yang and H. Vehoff: Mater. Sci. Eng., 2005, vols. 400–401, pp. 467–70.10.1016/j.msea.2005.01.077 ↗
14. G.E. Fougere, J.R. Weertman, and R.W. Siegel: Nanostruct. Mater., 1995, vol. 5, pp. 127–34.10.1016/0965-9773(95)00021-6 ↗
15. P.G. Sanders, J.A. Eastman, and J.R. Weertman: Acta Mater., 1997, vol. 45, pp. 4019–25.10.1016/S1359-6454(97)00092-X ↗
16. R.M. Spriggs: J. Am. Ceram. Soc., 1961, vol. 44, pp. 628–29.10.1111/j.1151-2916.1961.tb11671.x ↗
17. M. Chauhan and F.A. Mohamed: Mater. Sci. Eng., 2006, vol. A427, pp. 7–15.10.1016/j.msea.2005.10.039 ↗
18. F.A. Mohamed and M. Chauhan: Metall. Mater. Trans. A, 2006, vol. 37A, pp. 3555–67.10.1007/s11661-006-1050-6 ↗
19. T.R. Haasz, K.T. Aust, G. Palumbo, A.M. El-Sherik, and U. Erb: Scripta Metall. Mater., 1995, vol. 32, pp. 423–26.10.1016/S0956-716X(99)80076-4 ↗
20. W.C. Oliver and G.M. Pharr: J. Mater. Res., 1992, vol. 7, pp.1564–83.10.1557/JMR.1992.1564 ↗
21. K.P. Kulg and L.E. Alexander: X-Ray Diffraction Procedures, John Wiley & Sons, New York, NY, 1974.
22. F.A. Mohamed: Metall. Mater. Trans. A, 2007, vol. 38A, pp. 340–47.10.1007/s11661-006-9057-6 ↗
23. E.O. Hall: Proc. Phys. Soc., 1951, vol. 64, pp. 747–53.10.1088/0370-1301/64/9/303 ↗
24. N.J. Petch: J. Iron Steel Inst., 1953, vol. 174, pp. 25–28.
25. M. Chauhan and F.A. Mohamed: University of California-Irvine, Irvine, CA, unpublished research, 2007.
26. F. Ebrahimi, G.R. Bourne, M.S. Kelly, and T.E. Matthews: Nanostruct. Mater., 1991, vol. 11, pp. 343–50.10.1016/S0965-9773(99)00050-1 ↗
27. F. Dalla Torre, H. Van Swygenhoven, R. Schaublin, P. Spätig, and M. Victoria: Scripta Mater., 2005, vol. 53, pp. 23–27.10.1016/j.scriptamat.2005.03.026 ↗
28. A.M. El-Sherik, U. Erb, and J. Page: Surf. Coat. Technol., 1996, vol. 88, pp. 70–78.10.1016/S0257-8972(96)02928-3 ↗
29. U. Klement, U. Erb, and K.T. Aust: Nanostruct. Mater., 1995, vol. 6, pp. 581–84.10.1016/0965-9773(95)00125-5 ↗
30. Z. Zhang, F. Zhou, and E.J. Lavernia: Metall. Mater. Trans. A, 2003, vol. 34A, pp. 1349–55.10.1007/s11661-003-0246-2 ↗
31. H.G. Jiang, M. Rühle, and E.J. Lavernia: J. Mater. Res., 1999, vol. 14, pp. 549–59.10.1557/JMR.1999.0079 ↗
32. T.H. De Keijser, J.I. Langford, E.J. Mittemeijer, and A.B.P. Vogels: J. Appl. Cryst., 1982, vol. 15, pp. 308–14.10.1107/S0021889882012035 ↗
33. M. Chauhan and F.A. Mohamed: J. Mater. Sci., 2007, vol. 42, pp. 1606–14.10.1007/s10853-006-0823-z ↗
34. R. Mitra, T. Ungar, and J.R. Weertman: Trans. Indian Inst. Met., 2005, vol. 58, pp.1125–32.
35. J. He, J. Ye, E.J. Lavernia, D. Matejcztk, C. Bampton, and J.M. Schoenung: J. Mater. Sci., 2004, vol. 39, pp. 6957–64.10.1023/B:JMSC.0000047538.95825.ad ↗
36. A. Hasnaoui, H. Van Swygenhoven, and P.M. Derlet: Acta Mater., 2002, vol. 50, pp. 3927–39.10.1016/S1359-6454(02)00195-7 ↗
37. C.J. Youngdahl, J.R. Weertman, R.C. Hugo, and H.H. Kung: Scripta Mater., 2001, vol. 33, pp. 1475–78.10.1016/S1359-6462(01)00712-6 ↗
38. L. Lu, Y. Shen, X. Chen, L. Qian, and K. Lu: Science, 2004, vol. 304, pp. 422–26.10.1126/science.1092905 ↗
39. R.J. Asaro and S. Suresh: Acta Mater., 2005, vol. 53, pp. 3369–82.10.1016/j.actamat.2005.03.047 ↗
40. C.S. Smith and L. Guttman: Trans. AIME, 1953, vol. 197, pp. 81–87.
41. G. Grimvall: Thermophysical Properties of Materials, North Holland/Elsevier, Amsterdam, The Netherlands, 1999.
42. G.A. Alers, J.R. Neighbours, and H. Sato: J. Phys. Chem. Solids, 1960, vol. 13, pp. 40–55.10.1016/0022-3697(60)90125-6 ↗
43. H.B. Huntington: Solid State Phys., 1958, vol. 7, pp. 213–351.10.1016/S0081-1947(08)60553-6 ↗
44. M.A. Meyers and K.K. Chawla: Mechanical Behavior of Materials, Prentice Hall, Upper Saddle River, NJ, 1998.