journal article·2025-09Open access

Effect of Cooling Rate on the Heterogeneity of Grain Boundary η-Phase Precipitates in 7xxx Aluminium Alloys Following Artificial Ageing

Yichao Yao, Ryan Euesden, Matthew Curd, Timothy Burnett, Pratheek Shanthraj, Philip B. Prangnell

Abstract

Abstract The mechanical and stress corrosion behaviour of 7xxx aluminium thick-plate alloys are strongly influenced by a dual distribution of η-phase quench-induced and age-induced grain boundary precipitates (Q-GBPs and A-GBPs) that nucleate independently during cooling from solution treatment and artificial ageing, respectively. A novel cold intergranular fracture technique has been used to allow the interaction between these two precipitate distributions, formed on GB faces, in two alloys with different quench sensitivities, AA7050 and AA7085, to be more rigorously compared than previously possible. After a full T76 heat treatment, large widely spaced Q-GBPs are observed, between which high-density patches of small A-GBPs nucleate during subsequent artificial ageing. The A-GBP patches are separated from the Q-GBPs by distinct GB precipitate-free areas. Their respective distributions vary in a non-intuitive way with cooling rate. As the rate increases, the A-GBPs and patch area fractions reduce to a minima before rapidly increasing at very high cooling rates as Q-GBP nucleation becomes fully suppressed. This occurs because, although the size of the Q-GBPS GBPs reduces with cooling rate, there is a more dramatic increase in their nucleation density, which leads to a minima in the GB area where sufficient solute supersaturation is retained for precipitation during ageing. The same relative effects are seen in both alloys, but the Q-GBPs formed in AA7085 are significantly smaller and the density higher due to the lower solvus temperature.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Aluminum Alloy Microstructure Properties · Metallurgy and Material Forming · Microstructure and mechanical properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (32)

Show source-provided references
1. J.C. Williams and E.A. Starke Jr.: Acta Mater., 2003, vol. 51, pp. 5775–99. https://doi.org/10.1016/j.actamat.2003.08.023.10.1016/j.actamat.2003.08.023 ↗
2. B. Zhou, B. Liu, and S. Zhang: Metals, 2021, vol. 11, p. 718. https://doi.org/10.3390/met11050718.10.3390/met11050718 ↗
3. A.U. Rao, V. Vasu, M. Govindaraju, and K.V. Sai Srinadh: Trans. Nonferrous Metals Soc. China, 2016, vol. 26, pp. 1447–71. https://doi.org/10.1016/S1003-6326(16)64220-6.10.1016/S1003-6326(16)64220-6 ↗
4. D. Godard, P. Archambault, E. Aeby-Gautier, and G. Lapasset: Acta Mater., 2002, vol. 50, pp. 2319–29. https://doi.org/10.1016/S1359-6454(02)00063-0.10.1016/S1359-6454(02)00063-0 ↗
5. D. Dumont, A. Deschamps, and Y. Brechet: Mater. Sci. Eng. A, 2003, vol. 356, pp. 326–36. https://doi.org/10.1016/S0921-5093(03)00145-X.10.1016/S0921-5093(03)00145-X ↗
6. D. Dumont, A. Deschamps, Y. Bréchet, C. Sigli, and J.C. Ehrström: Mater. Sci. Technol., 2004, vol. 20, pp. 567–76. https://doi.org/10.1179/026708304225016662.10.1179/026708304225016662 ↗
7. P.-Y. Li, B.-Q. Xiong, Y.-A. Zhang, Z.-H. Li, B.-H. Zhu, W. Feng, and H.-W. Liu: Trans. Nonferrous Metals Soc. China, 2012, vol. 22, pp. 268–74. https://doi.org/10.1016/S1003-6326(11)61170-9.10.1016/S1003-6326(11)61170-9 ↗
8. A. Bryant: Inst. Metals J, 1966, vol. 94, pp. 94–9.
9. S. Knight, N. Birbilis, B. Muddle, A. Trueman, and S. Lynch: Corr. Sci., 2010, vol. 52, pp. 4073–80. https://doi.org/10.1016/j.corsci.2010.08.024.10.1016/j.corsci.2010.08.024 ↗
10. F. Song, X. Zhang, S. Liu, Q. Tan, and D. Li: Corr. Sci., 2014, vol. 78, pp. 276–86. https://doi.org/10.1016/j.corsci.2013.10.010.10.1016/j.corsci.2013.10.010 ↗
11. D. Chakrabarti, J. Liu, R. Sawtell, and G. Venema: Mater. Forum, 2004, vol. 28, pp. 969–74.
12. J. Boselli, D. Chakrabarti and R. Shuey: Proceedings of the 11th International Conference Aluminium Alloys, Eds. J. Hirsch, B. Skrotzki and G. Gottstein, 2008, vol. 1, pp. 202–8.
13. M. Nicolas and A. Deschamps: Acta Mater., 2003, vol. 51, pp. 6077–94. https://doi.org/10.1016/S1359-6454(03)00429-4.10.1016/S1359-6454(03)00429-4 ↗
14. M. Dumont, W. Lefebvre, B. Doisneau-Cottignies, and A. Deschamps: Acta Mater., 2005, vol. 53, pp. 2881–92. https://doi.org/10.1016/j.actamat.2005.03.004.10.1016/j.actamat.2005.03.004 ↗
15. T.-F. Chung, Y.-L. Yang, M. Shiojiri, C.N. Hsiao, W.-C. Li, C.-S. Tsao, Z. Shi, J. Lin, and J.-R. Yang: Acta Mater., 2019, vol. 174, pp. 351–68. https://doi.org/10.1016/j.actamat.2019.05.041.10.1016/j.actamat.2019.05.041 ↗
16. A. Garner, R. Euesden, Y. Yao, Y. Aboura, H. Zhao, J. Donoghue, M. Curioni, B. Gault, P. Shanthraj, Z. Barrett, C. Engel, T.L. Burnett, and P.B. Prangnell: Acta Mater., 2021, vol. 202, pp. 190–210. https://doi.org/10.1016/j.actamat.2020.10.021.10.1016/j.actamat.2020.10.021 ↗
17. Y. Yao, R. Euesden, T.L. Burnett, P. Shanthraj, and P.B. Prangnell: Mater. Metall. Trans. A, 2025, vol. 56, pp. 1230–51. https://doi.org/10.1007/s11661-024-07647-7.10.1007/s11661-024-07647-7 ↗
18. Y. Yao, R. Euesden, M.E. Curd, C. Liu, A. Garner, T.L. Burnett, P. Shanthraj, and P.B. Prangnell: Acta Mater., 2023, vol. 262, 119443. https://doi.org/10.1016/j.actamat.2023.119443.10.1016/j.actamat.2023.119443 ↗
19. T. Marlaud, A. Deschamps, F. Bley, W. Lefebvre, and B. Baroux: Acta Mater., 2010, vol. 58, pp. 248–60. https://doi.org/10.1016/j.actamat.2009.09.003.10.1016/j.actamat.2009.09.003 ↗
20. M. Song and K. Chen: J. Mater. Sci., 2008, vol. 43, pp. 5265–73. https://doi.org/10.1007/s10853-008-2773-0.10.1007/s10853-008-2773-0 ↗
21. D. Yuan, K. Chen, S. Chen, L. Zhou, J. Chang, L. Huang, and Y. Yi: Mater. Design, 2019, vol. 164, 107558. https://doi.org/10.1016/j.matdes.2018.107558.10.1016/j.matdes.2018.107558 ↗
22. E. Schwarzenböck, E. Ollivier, A. Garner, A. Cassell, T. Hack, Z. Barrett, C. Engel, T.L. Burnett, N.H. Holroyd, J.D. Robson, T.L. Burnett, and P.B. Prangnell: Corr. Sci., 2020, vol. 171, 108701. https://doi.org/10.1016/j.corsci.2020.108701.10.1016/j.corsci.2020.108701 ↗
23. T.L. Burnett, P.B. Prangnell, Y. Al Aboura, R.T. Euesden, C. Grant, Y. Yao, M.E. Curd, A.J. Garner, H. Holroyd, Z. Barrett, and C. Engel: Corrosion, 2023, vol. 79, pp. 831–49. https://doi.org/10.5006/4336.10.5006/4336 ↗
24. R.T. Euesden, Y. Aboura, A.J. Garner, T. Jailin, C. Grant, Z. Barrett, C. Engel, P. Shanthraj, N.J.H. Holroyd, P.B. Prangnell, and T.L. Burnett: Corr. Sci., 2023, vol. 216, 111051. https://doi.org/10.1016/j.corsci.2023.111051.10.1016/j.corsci.2023.111051 ↗
25. D.J. Chakrabarti, J. Liu, J.H. Goodman, G.B Venema, R.R. Sawtell, C.M. Krist and R.W. Weesterlund: Aluminum Alloy Products Having Improved Property Combination and Method of Artificially Ageing the Same. US Patent 6,972,100, 6 December 2005.
26. I. Arganda-Carreras, V. Kaynig, C. Rueden, K.W. Eliceiri, J. Schindelin, A. Cardona, and H. Sebastian Seung: Bioinformatics, 2017, vol. 33, pp. 2424–26. https://doi.org/10.1093/bioinformatics/btx180.10.1093/bioinformatics/btx180 ↗
27. D.A. Porter, K.E. Easterling, and M.Y. Sherif: Phase Transformations in Metals and Alloys, 4th ed. Taylor & Francis, 2021, pp. 270–301. https://doi.org/10.1201/9781003011804.10.1201/9781003011804 ↗
28. D. Vaughan: Acta Metall., 1968, vol. 16, pp. 563–77. https://doi.org/10.1016/0001-6160(68)90131-4.10.1016/0001-6160(68)90131-4 ↗
29. X. Fan, Z. Guo, X. Wang, J. Yang, and J. Zou: Mater. Character., 2018, vol. 139, pp. 382–89. https://doi.org/10.1016/j.matchar.2018.02.038.10.1016/j.matchar.2018.02.038 ↗
30. H. Yang, Y. Zhang, A. Zhang, F. Stein, Z. Xu, Z. Tang, D. Ren, and J. Zeng: Materials, 2023, vol. 16, p. 2691. https://doi.org/10.3390/ma16072691.10.3390/ma16072691 ↗
31. A. Deschamps, G. Texier, S. Ringeval, and L. Delfaut-Durut: Mater. Sci. Eng. A, 2009, vol. 501A, pp. 133–39. https://doi.org/10.1016/j.msea.2008.09.067.10.1016/j.msea.2008.09.067 ↗
32. H. Zhao, F. De Geuser, A.K. da Silva, A. Szczepaniak, B. Gault, D. Ponge, and D. Raabe: Acta Mater., 2018, vol. 156, pp. 318–29. https://doi.org/10.1016/j.actamat.2018.07.003.10.1016/j.actamat.2018.07.003 ↗