Mechanical Behavior and Strengthening Mechanisms in Precipitation-Strengthened Aluminum Alloy with Gradient Structure Induced by Sliding Friction Treatment
Source abstract
Abstract
The flat surfaces of a 7075 aluminum (Al) alloy plate were processed by sliding friction treatment (SFT), which is a technique for surface nanocrystallization of metals and alloys. The aim of this study was to investigate the microstructural evolution, mechanical behavior and strengthening mechanisms in this SFTed precipitation-strengthened Al alloy. The SFT resulted in a gradient structure (GS) with an effective depth of ~ 800 µm, and a nanostructured layer was formed within a depth of ~ 30 µm from the surface. Increasing boundary spacing and decreasing misorientation angle between boundaries were found with increasing depth from the surface, which was accompanied by a decrease in hardness from ~ 2436 MPa in the topmost surface layer to ~ 1568 MPa in the undeformed coarse grain (CG) matrix. Moreover, the GS revealed a prominent precipitate redistribution induced by the SFT. The GS revealed higher strength and especially exhibited a higher work-hardening rate at low strain (e < 0.026) than the CG, attributed to a novel coupling of dislocations, boundaries and precipitates. Grain boundary strengthening, dislocation strengthening, precipitation strengthening and synergetic strengthening in the GS were quantitatively evaluated based on sufficient discussion.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Surface Treatment and Residual Stress · Microstructure and mechanical properties · Aluminum Alloys Composites Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (46)
Show source-provided references
1. [1] W. Sun, Y. Zhu, R. Marceau, L. Wang, Q. Zhang, X. Gao, C. Hutchinson: Science, 2019, vol. 363, pp. 972-75.10.1126/science.aav7086 ↗
2. [2] M. Kumar, C. Poletti, H.P. Degischer: Mater. Sci. Eng. A, 2013, vol. 561, pp. 362-70.10.1016/j.msea.2012.10.031 ↗
3. [3] A.J. Ardell: Metall. Trans. A, 1985, vol. 16A, pp. 2131-65.10.1007/BF02670416 ↗
4. [4] A. Deschamps, F. Livet, Y. Bréchet: Acta Mater., 1999, vol. 47(1), pp. 281-92.10.1016/S1359-6454(98)00293-6 ↗
5. [5] A. Deschamps, Y. Bréchet: Acta Mater., 1999, vol. 47(1), pp. 293-305.10.1016/S1359-6454(98)00296-1 ↗
6. [6] R. Ferragut, A. Somoza, A. Tolley: Acta Mater., 1999, vol. 47(17), pp. 4355-64.10.1016/S1359-6454(99)00315-8 ↗
7. [7] L.K. Berg, J. Gjønnes, V. Hansen, X.Z. Li, M. Knutson-Wedel, G. Waterloo, D. Scheyvers, L.R. Wallenberg: Acta Mater., 2001, vol. 49, pp. 3443-51.10.1016/S1359-6454(01)00251-8 ↗
8. [8] G. Sha, A. Cerezo: Acta Mater., 2004, vol. 52, pp. 4503-16.10.1016/j.actamat.2004.06.025 ↗
9. [9] W. Huo, L. Hou, H. Cui, L. Zhuang, J. Zhang: Mater. Sci. Eng. A, 2014, vol. 618, pp. 244-53.10.1016/j.msea.2014.09.026 ↗
10. [10] Y. Zhang, S. Jin, P.W. Trimby, X. Liao, M.Y. Murashkin, R.Z. Valiev, J. Liu, J.M. Cairney, S.P. Ringer, G. Sha: Acta Mater., 2019, vol. 162, pp. 19-32.10.1016/j.actamat.2018.09.060 ↗
11. [11] K. Ma, H. Wen, T. Hu, T.D. Topping, D. Isheim, D.N. Seidman, E.J. Lavernia, J.M. Schoenung: Acta Mater., 2014, vol. 62, pp. 141-55.10.1016/j.actamat.2013.09.042 ↗
12. [12] K. Ma, T. Hu, H. Yang, T. Topping, A. Yousefiani, E.J. Lavernia, J.M. Schoenung: Acta Mater., 2016, vol. 103, pp. 153-64.10.1016/j.actamat.2015.09.017 ↗
13. [13] X. Yin, Y. Pi, J. Zhang, W. Deng: J. Mater. Res., 2018, vol. 33(20), pp. 3449-57.10.1557/jmr.2018.313 ↗
14. [14] K. Lu: Science, 2014, vol. 345, pp. 1455-56.10.1126/science.1255940 ↗
15. [15] K. Lu, J. Lu: Mater. Sci. Eng. A, 2004, vol. 375-377, pp. 38-45.10.1016/j.msea.2003.10.261 ↗
16. [16] X. Zhang, N. Hansen, Y. Gao, X. Huang: Acta Mater., 2012, vol. 60, pp. 5933-43.10.1016/j.actamat.2012.07.037 ↗
17. [17] S. Bajda, S. Dymek, M. Krzyzanowski, D. Retraint, J. Majta, L. Lisiecki, M. Kwiecień: Mater. Charact., 2018, vol. 145, pp. 250-57.10.1016/j.matchar.2018.08.046 ↗
18. [18] J. Ding, Q. Li, J. Li, S. Xue, Z. Fan, H. Wang, X. Zhang: Acta Mater., 2018, vol. 149, pp. 57-67.10.1016/j.actamat.2018.02.021 ↗
19. [19] S.Q. Deng, A. Godfrey, W. Liu, N. Hansen: Scr. Mater., 2016, vol. 117, pp. 41-45.10.1016/j.scriptamat.2016.02.007 ↗
20. [20] W. Zhang, Y. Du, W. Huo, J. Hu, J. Lu, X. Zhao, L.C. Zhang, Y. Zhang: Metall. Mater. Trans. A, 2019, vol. 50, pp. 5888-95.10.1007/s11661-019-05466-9 ↗
21. [21] Y. Chen, Y. Yang, Z. Feng, G. Zhao, B. Huang, X. Luo, Y. Zhang, W. Zhang: Mater. Charact., 2017, vol. 123, pp. 189-97.10.1016/j.matchar.2016.11.021 ↗
22. [22] W. Zhang, J. Lu, W. Huo, Y. Zhang, Q. Wei: Philos. Mag., 2018, vol. 98, pp. 1576-93.10.1080/14786435.2018.1447701 ↗
23. [23] C.C. Koch, R.O. Scattergood, K.A. Darling, J.E. Semones: J. Mater. Sci., 2008, vol. 43, pp. 7264-72.10.1007/s10853-008-2870-0 ↗
24. K. Lu: Nat. Rev. Mater., 2016, vol. 1, 16019.10.1038/natrevmats.2016.19 ↗
25. [25] H.W. Chang, P.M. Kelly, Y.N. Shi, M.X. Zhang: Mater. Sci. Eng. A, 2011, vol. 530, pp. 304-14.10.1016/j.msea.2011.09.090 ↗
26. B. Yang, Y.T. Zhou, D. Chen, X.L. Ma: Sci. Rep., 2013, vol. 3, 1039.10.1038/srep01039 ↗
27. [27] W. Huo, J. Hu, H. Cao, Y. Du, W. Zhang, Y. Zhang: J. Alloys Compd., 2019, vol. 781, pp. 680-88.10.1016/j.jallcom.2018.12.024 ↗
28. [28] D.A. Hughes, N. Hansen: Acta Mater., 1997, vol. 45(9), pp. 3871-86.10.1016/S1359-6454(97)00027-X ↗
29. [29] X. Wu, N. Tao, Y. Hong, B. Xu, J. Lu, K. Lu: Acta Mater., 2002, vol. 50, pp. 2075-84.10.1016/S1359-6454(02)00051-4 ↗
30. [30] C.E. Campbell, L.A. Bendersky, W.J. Boettinger, R. Ivester: Mater. Sci. Eng. A, 2006, vol. 430, pp. 15-26.10.1016/j.msea.2006.04.122 ↗
31. [31] E.W. Hart: Acta Metall., 1967, vol. 15, pp. 351-55.10.1016/0001-6160(67)90211-8 ↗
32. [32] Y. Chen, Y. Yang, Z. Feng, B. Huang, X. Luo: J. Alloys Compd., 2017, vol. 726, pp. 367-77.10.1016/j.jallcom.2017.08.018 ↗
33. [33] R.W. Balluffi: Phys. Stat. Sol. A, 1970, vol. 42, pp. 11-34.10.1002/pssb.19700420102 ↗
34. [34] A.M. Brown, M.F. Ashby: Acta Metall., 1980, vol. 28(8), pp. 1085-1101.10.1016/0001-6160(80)90092-9 ↗
35. [35] A. Godfrey, D.A. Hughes: Acta Mater., 2000, vol. 48, pp. 1897-1905.10.1016/S1359-6454(99)00474-7 ↗
36. [36] S. Bahl, S. Suwas, T. Ungàr, K. Chatterjee: Acta Mater., 2017, vol. 122, pp. 138-51.10.1016/j.actamat.2016.09.041 ↗
37. [37] Q. Liu, X. Huang, D.J. Lloyd, N. Hansen: Acta Mater., 2002, vol. 50, pp. 3789-3802.10.1016/S1359-6454(02)00174-X ↗
38. [38] N. Hansen: Scr. Mater., 2004, vol. 51, pp. 801-6.10.1016/j.scriptamat.2004.06.002 ↗
39. [39] M.F. Ashby: Acta Metall., 1972, vol. 20, pp. 887-97.10.1016/0001-6160(72)90082-X ↗
40. [40] C.Y. Barlow, N. Hansen: Acta Metall., 1989, vol. 37, pp. 1313-20.10.1016/0001-6160(89)90161-2 ↗
41. [41] Y. Lin, W. Liu, L. Wang, E.J. Lavernia: Mater. Sci. Eng. A, 2013, vol. 573, pp. 197-204.10.1016/j.msea.2013.02.061 ↗
42. Y. Wei, Y. Li, L. Zhu, Y. Liu, X. Lei, G. Wang, X. Wu, Z. Mi, J. Liu, H. Wang, H. Gao: Nat. Commun., 2014, vol. 5, 3580.10.1038/ncomms4580 ↗
43. [43] Z.C. Luo, M.X. Huang: Scr. Mater., 2020, vol. 178, pp. 264-68.10.1016/j.scriptamat.2019.11.047 ↗
44. [44] N. Kamikawa, X. Huang, N. Tsuji, N. Hansen: Acta Mater., 2009, vol. 57, pp. 4198-4208.10.1016/j.actamat.2009.05.017 ↗
45. [45] N. Hansen, X. Huang: Acta Mater., 1998, vol. 46(5), pp. 1827-36.10.1016/S1359-6454(97)00365-0 ↗
46. [46] M.F. Ashby: Philos. Mag., 1970, vol. 21, pp. 399-424.10.1080/14786437008238426 ↗