Quantification of Primary Dendritic and Secondary Eutectic Nucleation Undercoolings in Rapidly Solidified Hypo-Eutectic Al-Cu Droplets
Source abstract
Abstract
This paper reports on the quantification of primary dendritic and secondary eutectic nucleation undercoolings during rapid solidification of impulse atomized hypo-eutectic Al-Cu droplets. The procedure consists in determining the eutectic fraction of each investigated droplet from the fraction of intermetallic Al2Cu obtained by Rietveld refinement analysis of neutrons scattering data. The corresponding eutectic nucleation undercooling is then deduced from the metastable phase diagram of the alloy. The primary dendritic nucleation undercooling is subsequently determined using semi-empirical coarsening models of secondary dendrite arms. The two nucleation undercoolings are finally used as input variables to run a microsegregation model for binary alloys. The fractions of eutectic computed by the microsegregation model compare very favorably with the experimental results.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Solidification and crystal growth phenomena · Aluminum Alloy Microstructure Properties · Metallurgical Processes and Thermodynamics
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (29)
Show source-provided references
1. J. Lipton, M. E. Glicksman, and W. Kurz: Materials Science and Engineering, 1984, vol. 65, no.1, pp. 57–6310.1016/0025-5416(84)90199-X ↗
2. R. Heringer, Ch.-A. Gandin, G. Lesoult, and H. Henein: Acta Mater., 2006, vol. 54, no. 17, pp. 4427–40.10.1016/j.actamat.2006.05.015 ↗
3. J. Chen, U. Dahlborg, C. M. Bao, M. Calvo-Dahlborg, and H. Henein: Metall. Mater. Trans. B Process Metall. Mater. Process. Sci., 2011, vol. 42B, pp. 557–67.10.1007/s11663-011-9485-6 ↗
4. Ch.-A. Gandin, S. Mosbah, M. Bellet: Metall.Mater.Trans.A, 2010, vol. 41A, pp. 651–69.
5. M. C. Flemings: Metall. Trans., 1974, vol. 5, no. 10, pp. 2121–34.10.1007/BF02643923 ↗
6. H. Henein: Mater. Sci. Eng. A, 2002, vol. 326, no. 1, pp. 92–100.10.1016/S0921-5093(01)01429-0 ↗
7. J. B. Wiskel, K. Navel, H. Henein, and E. Maire: Canadian Metallurgical Quarterly, 2002, vol. 41, no. 2, pp. 193–204.10.1179/cmq.2002.41.2.193 ↗
8. Ch.-A. Gandin, S. Mosbah, T. Volkmann, and D. M. Herlach: Acta Mater., 2008, vol. 56, no.13, pp. 3023–35.10.1016/j.actamat.2008.02.041 ↗
9. A. Prasad, S. Mosbah, H. Henein, and Ch.-A. Gandin: ISIJ International, 2009, vol. 49, no. 7, pp. 992–99.10.2355/isijinternational.49.992 ↗
10. A. Prasad: Microsegregation studies of rapidly solidified binary Al-Cu alloys, PhD thesis, University of Alberta, 2006.
11. D. Tourret, G. Reinhart, Ch.-A. Gandin, G. N. Iles, U. Dahlborg, M. Calvo-Dahlborg, and C. M. Bao: Acta Mater., 2011, vol. 59, no.17, pp. 6658–69.10.1016/j.actamat.2011.07.023 ↗
12. D. Tourret and Ch.-A. Gandin: Acta Mater.,2009, vol. 57, no.7, pp. 2066–79.10.1016/j.actamat.2009.01.002 ↗
13. D. Tourret, Ch.-A. Gandin, T. Volkmann, and D. M. Herlach: Acta Mater., 2011, vol. 59, no. 11, pp. 4665–77.10.1016/j.actamat.2011.04.013 ↗
14. M. Rappaz and P. Thévoz: Acta Metall., 1987, vol. 35, no.7, pp. 1487–97.10.1016/0001-6160(87)90094-0 ↗
15. M. Rappaz and P. H. Thévoz: Acta Metall., 1987, vol. 35, no. 12, pp. 2929–33.10.1016/0001-6160(87)90292-6 ↗
16. C. Y. Wang and C. Beckermann: Metall. Trans. A, 1993, vol. 24, no. 12, pp. 2787–2802.10.1007/BF02659502 ↗
17. C. Y. Wang and C. Beckermann: Materials Science and Engineering: A, 1993, vol. 171, no.1-2, pp. 199–211, 1993.10.1016/0921-5093(93)90407-6 ↗
18. M.A Martorano, C.Bekckermann and Ch-A.Gandin: Metall.Mater.Trans.A, 2003, vol. 34, pp. 1657–74.10.1007/s11661-003-0311-x ↗
19. D. Ruvalcaba, R. H. Mathiesen, D. G. Eskin, L. Arnberg, and L. Katgerman: Metall. Mater. Trans. B Process Metall. Mater. Process. Sci., 2009, vol. 40B, pp. 312–16.10.1007/s11663-008-9166-2 ↗
20. R. Mathiesen and L. Anberg: Acta Mater, 2005, vol. 53, pp. 947–56.10.1016/j.actamat.2004.10.050 ↗
21. W. Kurz and D. J. Fisher: Fundamentals of Solidification, 1st edition. Trans.Tech. Publications, Lausane, Switzerland, 1984, P.88.
22. T. Z. Kattamis, J. C. Coughlin and M. C. Flemings: Trans. Met. Soc. AIME, 1967, vol. 239, p. 1504.
23. [23] H. E. Roosz, A. Halder and E. Exner: Mater. Sci. Technol., 1986, vol. 2, pp. 1149–55.10.1179/mst.1986.2.11.1149 ↗
24. D. Eskin, Q. Du, D. Ruvalcaba, and L. Katgerman: Mater. Sci. Eng. A, 2005, vol. 405, no.1–2, pp. 1–10.10.1016/j.msea.2005.05.105 ↗
25. A. M. Mullis, L. Farrell, R. F. Cochrane, N. J. Atkins: Met. Mater. Trans. B, 2013, vol. 44, no. 4, pp. 992–9910.1007/s11663-013-9856-2 ↗
26. E. Schleip, R. Willnecker, D. M. Herlach, and G. P. Görler: Mater. Sci. Eng., 1988, vol. 98, pp. 39–42.10.1016/0025-5416(88)90122-X ↗
27. T. E. Quested and A. L. Greer: Acta Mater., 2004, vol. 52, no.13, pp. 3859–68.10.1016/j.actamat.2004.04.035 ↗
28. T. E. Quested and A. L. Greer: Acta Mater., 2005, vol. 53, no.17, pp. 4643–53.10.1016/j.actamat.2005.06.018 ↗
29. D. M. Herlach, P. K. Galenko and D.Holland-Moritz: Metastable solids from undercooled melts., Pergamon MAterials Series ELSEVIER, Oxford, 2007.10.4028/0-87849-428-6.1977 ↗