journal article·2018-09Open access

Creep of Single Crystals of Nickel-Based Superalloys at Ultra-High Homologous Temperature

Alexander Epishin, Bernard Fedelich, Gert Nolze, Sina Schriever, Titus Feldmann, Muhammad Farzik Ijaz, Bernard Viguier, Dominique Poquillon, Yann Le Bouar, Antoine Ruffini, Alphonse Finel

Abstract

The creep behavior of single crystals of the nickel-based superalloy CMSX-4 was investigated at 1288 °C, which is the temperature of the hot isostatic pressing treatment applied to this superalloy in the industry. It was found that at this super-solvus temperature, where no γ′-strengthening occurs, the superalloy is very soft and rapidly deforms under stresses between 4 and 16 MPa. The creep resistance was found to be very anisotropic, e.g., the creep rate of [001] crystals was about 11 times higher than that of a [111] crystal. The specimens of different orientations also showed a very different necking behavior. The reduction of the cross-sectional area ψ of [001] crystals reached nearly 100 pct, while for a [111] crystal ψ = 62 pct. The EBSD analysis of deformed specimens showed that despite such a large local strain the [001] crystals did not recrystallize, while a less deformed [111] crystal totally recrystallized within the necking zone. The recrystallization degree was found to be correlated with deformation behavior as well as with dwell time at high temperature. From the analysis of the obtained results (creep anisotropy, stress dependence of the creep rate, traces of shear deformation, and TEM observations), it was concluded that the main strain contribution resulted from 〈 $$ 0 1\bar{1} $$ 〉{111} octahedral slip.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: High Temperature Alloys and Creep · Microstructure and mechanical properties · Microstructure and Mechanical Properties of Steels

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (31)

Show source-provided references
1. A. Epishin, T. Link, U. Brückner, and P.D. Portella: Seventh Liège Conference on Materials for Advanced Power Engineering, 2002, pp. 217–26.
2. K.P.L. Fullagar, R.W. Broomfield, M. Hulands, K. Harris, G.L. Erickson, and S.L. Sikkenga: Trans. of the ASME, 1996, vol. 118, pp. 380-388.
3. K. Harris, G.L. Erickson, S.L. Sikkenga, W.D. Brentnall, J.M. Aurrecoechea, and K.G. Kubarych: Seventh International Symposium on Superalloys, 1992, pp. 297–306.10.7449/1992/Superalloys_1992_297_306 ↗
4. J. Cormier, X. Milhet, and J. Mendez: Acta Mater., 2007, vol. 55, pp. 6250–6259.10.1016/j.actamat.2007.07.048 ↗
5. J.-B. le Graverend, J. Cormier, F. Gallerneau, S. Kruch, and J. Mendez: Mater. Des., 2014, vol. 56, pp. 990–997.10.1016/j.matdes.2013.12.025 ↗
6. A. Epishin, B. Fedelich, T. Link, T. Feldmann, and I.L. Svetlov: Mater. Sci. Eng. A, 2013, vol. 586, pp. 342–349.10.1016/j.msea.2013.08.034 ↗
7. A.I. Epishin, T. Link, B. Fedelich, I.I. Svetlov, and E.R. Golubovskiy: MATEC Web of Conferences, 2014, vol. 14, AN 08003.10.1051/matecconf/20141408003 ↗
8. http://cannonmuskegon.com/products/vacuum-alloys/.
9. B.C. Wilson, J.A. Hickman, and G.E. Fuchs: The Effect of Solution Heat Treatment on a Single-Crystal Ni-Based Superalloy, JOM, 2003, vol. 55, Issue 3, pp. 35-40.10.1007/s11837-003-0158-z ↗
10. R.E. Shalin, I.L. Svetlov, E.B. Kachanov, V.N. Toloraya, and O.S. Gavrilin: Single-crystals of nickel-base superalloys, Mashinostroeniye, Moscow, 1997 (in Russian).
11. U. Bruckner, A. Epishin, and T. Link: Acta Mater., 1997, vol. 45, pp. 5223-5231.10.1016/S1359-6454(97)00163-8 ↗
12. U. Bruckner, A. Epishin, T. Link, and K. Dressel: Mater. Sci. Eng. A, 1991, vol. A247, pp. 23-31.
13. C.K. Bullough, M. Toulios, M. Oehl, and P. Lukas: Sixth Liege Conference on Materials for Advanced Power Engineering, 1998, pp. 861–78.
14. T. Thu and C.-Y. Wang: Phys. Rev. B, 2005, vol. 72, pp. 10-20.
15. S.J. Zaefferer: Appl. Cryst., 2000, vol. 33, pp. 10-25.10.1107/S0021889899010894 ↗
16. S. Zaefferer: Adv. Imag. Electron Phys., 2002, vol. 125, pp. 355-415.10.1016/S1076-5670(02)80019-2 ↗
17. F. Roters, P. Eisenlohr, L. Hantcherli, D.D. Tjahjanto, T.R. Bieler, and D. Raabe: Acta Mater., 2010, vol. 58, pp. 1152–1211.10.1016/j.actamat.2009.10.058 ↗
18. J.R. Rice: J. Mech. Phys. Solids, 1971, vol. 19, pp. 433-455.10.1016/0022-5096(71)90010-X ↗
19. S. Yuana, M. Huanga, Y. Zhua, and Z. Lia: Mech. of Mat., 2018, vol. 118, pp. 44-61.10.1016/j.mechmat.2017.12.009 ↗
20. H. Mehrer: Diffusion in solids. Springer, New York , 2007.10.1007/978-3-540-71488-0 ↗
21. F. Mompiou, L. Bresson, P. Cordier, and D. Caillard: Philos. Mag., 2003, vol. 83, pp. 3133-3157.10.1080/1478643031000155110 ↗
22. L. Agudo Jácome, P. Nörtershäuser, C. Somsen, A. Dlouhý, and G. Eggeler: Acta Mater., 2014, vol. 69, pp. 246–264.10.1016/j.actamat.2014.01.021 ↗
23. W. Schneider, J. Hammer, and H. Mughrabi: Seventh International Symposium on Superalloys, 1992, pp. 589–98.10.7449/1992/Superalloys_1992_589_598 ↗
24. J. Weertman and J. R. Weertman: Physical Metallurgy, North-Holland Physics Publishing, Amsterdam, vol. 2, 1983, Chapter 20, pp. 1309–40.
25. V. Sass and M. Feller-Kniepmeier: Mater. Sci. Eng. A, 1998, vol. 245, pp. 19-28.10.1016/S0921-5093(97)00709-0 ↗
26. D. Bettge and W. Österle: Scripta Mater., 1999, vol. 40, pp. 389-395.10.1016/S1359-6462(98)00446-1 ↗
27. A. Vattré, B. Devincre, and A. Roos: Acta Mater., 2010, vol. 58, pp. 1938-1951.10.1016/j.actamat.2009.11.037 ↗
28. A. Vattré and B. Fedelich: Mech. of Mat., 2011, vol. 43, pp. 930-951.10.1016/j.mechmat.2011.07.007 ↗
29. T. Link, and M. Feller-Kniepmeier: Z. Metallkde, 1988, vol. 79, pp. 381-387.
30. V. Sass, U. Glatzel, and M. Feller-Kniepmeier: Acta Mater., 1996, vol. 44, pp. 1967-1977.10.1016/1359-6454(95)00315-0 ↗
31. A. Epishin and T. Link: Phil. Mag., 2004, vol. 84, pp. 1979- 2000.10.1080/14786430410001663240 ↗