journal article·2004-05

Monte carlo-method simulation of the deformation-induced ferrite transformation in the Fe-C system

Mingming Tong, Dianzhong Li, Yiyi Li, Jun Ni, Yutuo Zhang

Publisher page

Abstract

A Monte Carlo (MC) technique has been used to model deformation-induced ferrite transformation (DIFT) in an Fe-C binary system on a mesoscale. The effects of strain rate, strain, and recrystallization of the matrix on DIFT are investigated. Increasing the strain rate slightly retards the onset of DIFT. The volume fraction of ferrite increases gradually as the strain increases before the volume fraction of ferrite reaches its saturation value. After the volume fraction of ferrite becomes saturated, it oscillates around its saturation value. The recrystallization of austenite slightly retards the onset of the DIFT. Although the recrystallization of austenite reduces the equilibrium volume fraction of ferrite significantly, it cannot completely suppress DIFT. The stress concentration has been shown to induce the nucleation of ferrite near the grain boundaries and phase boundaries. The significance of the reverse transformation has been investigated. We found that there is a temporal oscillation of the volume fraction of ferrite and the stored energy after they arrive at their saturation values. We conclude that this oscillation and the effect of the strain rate on DIFT are both brought about by the reverse transformation from induced ferrite to undeformed austenite. The diffusion behavior of carbon atoms in the systems is different for different strain rates. The simulation shows that the dynamic recovery of austenite cannot occur in the system during deformation under the present conditions. The results of the simulation show that, other than the oscillation of the equilibrium volume fraction of ferrite and the unusual diffusion behavior of carbon atoms, the simulation agrees well with the corresponding experimental results. The temporal oscillation of the volume fraction of ferrite and stored energy and the unusual diffusion behavior are two new phenomena that have not been reported by other researchers.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Microstructure and Mechanical Properties of Steels · Microstructure and mechanical properties · Metallurgy and Material Forming

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (28)

Show source-provided references
1. R. Priestner: in Thermomechanical Processing of Microalloyed Austenite, A.J. De Ardo, G.A. Ratz, and P.J. Wray, eds., TMS-AIME, Warrendale, PA, 1982, p. 78.
2. B. Mintz, S. Yue, and J.J. Jonas: Int. Mater. Rev., 1991, vol. 36, p. 187.10.1179/imr.1991.36.1.187 ↗
3. H. Yada, Y. Matsumura, and K. Nakajima: U.S. Patent No. 4,466,842, 1984.
4. H. Yada, Y. Matsumura, and T. Senuma: in International Conference on Physical Metallurgy of Thermomechanical Processing of Steels and Other Metals, THERMEC ’88, I. Tamura, ed., ISIJ, Tokyo, Japan, 1988, p. 200.
5. P.J. Hurley and P.D. Hodgson: Mater. Sci. Technol., 2001, vol. 17, p. 1360.10.1179/026708301101509566 ↗
6. C.H.J. Davies: Scripta Metall., 1995, vol. 33, p. 1139; A.D. Rollett, D.J. Srolovitz, and M.P. Anderson: Acta Metall., 1989, vol. 37, p. 1227; Danan Fan and Longqing Chen: Acta Metall., 1997, vol. 45, p. 3297.10.1016/0956-716X(95)00335-S ↗
7. D.J. Srolovitz, M.P. Anderson, G.S. Grest, and P.S. Sahni: Acta Metall., 1984, vol. 32, p. 783; 1984, vol. 32, p. 793; 1984, vol. 32, p. 1429; 1985, vol. 33, p. 509; 1985, vol. 33, p. 2233.10.1016/0001-6160(84)90151-2 ↗
8. B. Radhakrishnan, G.B. Sarma, and T. Zacharia: Acta Metall., 1998, vol. 46, p. 4415.
9. Y. Tsuzuki and Y. Suzuki: Mater. Sci. Forum, 1996, vols. 204–206, p. 23.
10. Y. Tsuzuki and Y. Suzuki: Mater. Sci. Forum, 1996, vols. 204–206, p. 23.
11. A.D. Rollett, M.J. Luton, and D.J. Srolovitz: Acta Metall, 1992, vol. 40, p. 43: P. Peczak, Acta Metall, 1995, vol. 43, p. 1279: D.J. Srolovitz, G.S. Grest, and M.P. Anderson: Acta Metall, 1986, vol. 34, p. 1833: D.J. Srolovitz, G.S. Grest, M.P. Anderson, and A.D. Rollett: Acta Metall., 1988, vol. 36, p. 2115; A.D. Rollett, D.J. Srolovitz, M.P. Anderson, and R.D. Doherty: Acta Metall., 1992, vol. 40, p. 3475.10.1016/0956-7151(92)90198-N ↗
12. D.Y. Li and L.Q. Chen: Acta Metall., 1997, vol. 45, p. 2435.
13. Larry Kaufman, E.V. Glougherty, and R.J. Weiss: Acta Metall., 1963, vol. 11, p. 323.10.1016/0001-6160(63)90157-3 ↗
14. Thermo Calc User’s Guide, Version N, Foundation of Computational Thermodynamics, Stockholm.
15. G.S. Grest, D.J. Srolovitz, and M.P. Anderson: Acta Metall., 1985, vol. 33, p. 509.10.1016/0001-6160(85)90093-8 ↗
16. W.T. Read and W. Shockley: Phys. Rev., 1950, vol. 78, p. 275.10.1103/PhysRev.78.275 ↗
17. P. Peczak and M.J. Luton: Acta Metall., 1993, vol. 41, p. 59.10.1016/0956-7151(93)90339-T ↗
18. B. Mintz, J. Lewis, and J.J. Jonas: Mater. Sci. Technol., 1997, vol. 13, p. 379.10.1179/mst.1997.13.5.379 ↗
19. Yang Ping, Fu Yunyi, Cui Fenger, and Sun Zuqing: Acta Metall. Sinica, 2001, vol. 37, p. 592.
20. P.D. Hodgson, M.R. Hickson, and R.K. Gibbs: Scripta Mater., 1999, vol. 40, p. 1179.10.1016/S1359-6462(98)00411-4 ↗
21. P.J. Hurley, P.D. Hodgson, and B.C. Muddle: Scripta Mater., 1999, vol. 40, p. 433.10.1016/S1359-6462(98)00442-4 ↗
22. P.D. Hodgson, M.R. Hickson, and R.K. Gibbs: Mater. Sci. Forum, 1998, vols. 284–286, p., 63.10.4028/www.scientific.net/MSF.284-286.63 ↗
23. Yang Zhongmin, Zhao Yan, Wang Ruizhen, Ma Yanwen, and Che Yanmin: Acta Metall. Sinica, 2000, vol. 36, p. 818.
24. Yang Zhongmin, Zhao Yan, Wang Ruizhen, Che Yanmin, Ma Yanmin, and Chen Qian: Acta Metall. Sinica, 2000, vol. 36, p. 1061.
25. Yang Ping, Fu Yunyi, Cui Fenge, and Sun Zuqing: Acta Metall. Sinica, 2001, vol. 37, p. 601.
26. Zhongming Yang and Ruizhen Wang: Iron Steel Inst. Jpn. Int., 2003, vol. 43, p. 761.10.2355/isijinternational.43.761 ↗
27. Yang Ping, Hao Guangrui, Cui Feng-e, and Sun Zuqing: Proc. Workshop on New Generation Steel, The Chinese Society for Metals, Beijing, P.R. China, 2001, p. 259.
28. Yang Ping, Cui Feng-e, Fu Yun yi, and Sun Zuqing: Acta Metall. Sinica, 2001, vol. 37, p. 609.