Optimization of Solution Treatment of Cast Al-7Si-0.3Mg and Al-8Si-3Cu-0.5Mg Alloys
Source abstract
Abstract
The influence of solidification rate on the solution-treatment response has been investigated for an Al-7Si-0.3Mg alloy and an Al-8Si-3Cu-0.5Mg alloy. The concentrations of Mg, Cu, and Si in the matrix after different solution-treatment times were measured using a wavelength dispersive spectrometer. All Mg dissolves into the matrix for the Al-Si-Mg alloy when solution treated at 803 K (530 °C) because the π-Fe phase is unstable and transforms into short β-Fe plates which release Mg. The Q-Al5Mg8Cu2Si6 phase do not dissolve completely at 768 K (495 °C) in the Al-Si-Cu-Mg alloy and the concentration in the matrix reached 0.22 to 0.25 wt pct Mg. The distance between π-Fe phases and Al2Cu phases was found to determine the solution-treatment time needed for dissolution and homogenization for the Al-Si-Mg alloy and Al-Si-Cu-Mg alloy, respectively. From the distance between the phases, a dimensionless diffusion time was calculated which can be used to estimate the solution-treatment times needed for different coarsenesses of the microstructure. A model was developed to describe the dissolution and homogenization processes.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Aluminum Alloy Microstructure Properties · Aluminum Alloys Composites Properties · Microstructure and mechanical properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (30)
Show source-provided references
1. J.A. Taylor, D.H. John, J. Barresi, and M.J. Couper: Mater. Sci. Forum, 2000, vol. 331–337, pp. 277–82.10.4028/www.scientific.net/MSF.331-337.277 ↗
2. H. De La Sablonnière and F. H. Samuel: Int. J. Cast Met. Res., 1996, vol. 9, pp. 195-211.10.1080/13640461.1996.11819661 ↗
3. E. H. Samuel, A. M. Samuel and H. W. Doty: AFS Trans., 1996, vol. 30, pp. 893-901.
4. A. M. Samuel, P. Ouellet, F. H. Samuel and H. W. Doty: AFS Trans., 1997, vol. 105, pp. 951-62.
5. D. Yang: Master Thesis, Université du Quebec á Chicoutimi, Canada, 2006, pp. 62–64. http://bibvir.uqac.ca/theses/24625307/24625307.pdf. Accessed 20 Jan 2010.
6. S. Shivkumar, S. Ricci Jr, C. Keller and D. Apelian: J. Heat Treating, 1990, vol. 8, pp. 63-70.10.1007/BF02833067 ↗
7. P. A. Rometsch, L. Arnberg and D. L. Zhang: Int. J. Cast Metal. Res., 1999, vol. 12, pp. 1-8.10.1080/13640461.1999.11819338 ↗
8. A. L. Dons, L. Pedersen and S. Brusethaug: Aluminium, 2000, vol. 76, pp. 294-7.
9. P. A. Rometsch, G. B. Schaffer and J. A. Taylor: Int. J. Cast Metal. Res., 2001, vol. 14, pp. 59-69.10.1080/13640461.2001.11819426 ↗
10. Q. G. Wang and C. J. Davidson: J. Mater. Sci., 2001, vol. 36, pp. 739-50.10.1023/A:1004801327556 ↗
11. F. H. Samuel: J. Mater. Sci., 1998, vol. 33, pp. 2283-97.10.1023/A:1004383203476 ↗
12. F. H. Samuel, A. M. Samuel and H. Liu: J. Mater. Sci., 1995, vol. 30, pp. 2531-40.10.1007/BF00362130 ↗
13. L. Lasa and J. M. Rodriguez-Ibabe: J. Mater. Sci., 2004, vol. 39, pp. 1343-55.10.1023/B:JMSC.0000013895.72084.c9 ↗
14. Y. M. Han, A. M. Samuel, F. H. Samuel and H. W. Doty: Int. J. Cast Met. Res., 2008, vol. 21, pp. 387-93.10.1179/136404608X347662 ↗
15. L.J. Colley, M.A. Wells, R. MacKay, and W. Kasprzak: ASM Heat Treat. Soc. 26 th Conf. Exposition: Gearing Up for Success, 2011, pp. 189–98.
16. G. Wang, X. Bian, W. Wang and J. Zhang: Mater. Lett., 2003, vol. 57, pp. 4083-7.10.1016/S0167-577X(03)00270-2 ↗
17. Y. Ma, J. Fang, F. Yi, K. Song, H. D. Brody and J. E. Morral: Materials Science and Technology Conference and Exhibition 2009, 2009, pp. 2410-21.
18. C. T. Wu, S. L. Lee, M. H. Hsieh and J. C. Lin: Mater. Charact., 2010, vol. 61, pp. 1074-9.10.1016/j.matchar.2010.06.022 ↗
19. D. Apelian, S. Shivkumar and G. Sigworth: AFS Trans., 1989, vol. 137, pp. 727-42.
20. S. Seifeddine: Ph.D. Thesis, Department of Mechanical Engineering/Component Technology: Castings, Jönköping University, Jönköping, Sweden, 2006, p. 11.
21. B. Sundman, B. Jansson and J. O. Andersson: Calphad, 1985, vol. 9, pp. 153-90.10.1016/0364-5916(85)90021-5 ↗
22. L. Pedersen and L. Arnberg: Mater. Sci. Eng. A, 1998, vol. 241, pp. 285-9.10.1016/S0921-5093(97)00490-5 ↗
23. A. L. Dons, L. Pedersen and L. Arnberg: Mater. Sci. Eng. A, 1999, vol. 271, pp. 91-4.10.1016/S0921-5093(99)00273-7 ↗
24. E. Sjölander and S. Seifeddine: Mater. Des., 2010, vol. 31, pp. S44-S9.10.1016/j.matdes.2009.10.035 ↗
25. A. L. Dons: J. Light Met., 2001, vol. 1, pp. 133-49.10.1016/S1471-5317(01)00007-4 ↗
26. F. Vermolen and K. Vuikh: J. Comput. Appl. Math., 1998, vol. 93, pp. 123-43.10.1016/S0377-0427(98)00076-4 ↗
27. F. J. Vermolen and S. Van Der Zwaag: Mater. Sci. Eng. A, 1996, vol. 220, pp. 140-6.10.1016/S0921-5093(96)10441-X ↗
28. Y. Du, Y. A. Chang, B. Huang, W. Gong, Z. Jin, H. Xu, Z. Yuan, Y. Liu, Y. He and F. Y. Xie: Mater. Sci. Eng. A, 2003, vol. 363, pp. 140-51.10.1016/S0921-5093(03)00624-5 ↗
29. D. L. Zhang, L. H. Zheng and D. H. StJohn: J. Light Met., 2002, vol. 2, pp. 27-36.10.1016/S1471-5317(02)00010-X ↗
30. D. Zhang, J. Peng and T. Liu: Mater. Sci. Eng. A, 2006, vol. 425, pp. 78-82.10.1016/j.msea.2006.03.019 ↗