journal article·2007-09

Low-Cycle Fatigue Behavior of an As-Extruded AM50 Magnesium Alloy

Lijia Chen, Chunyan Wang, Wei Wu, Zheng Liu, Grigoreta M. Stoica, Liang Wu, Peter K. Liaw

Publisher page

Abstract

The low-cycle fatigue behavior of an as-extruded AM50 magnesium alloy has been investigated. The cyclic stress response of the alloy strongly depends on the imposed strain amplitude. It is also noted that at the higher total strain amplitudes, the alloy exhibits a pronounced anisotropic deformation behavior in the direction of tension and compression, where the width of the σ-e hysteresis loop in the compressive direction is greater than that in the tensile direction. At the total strain amplitude of 1.5 pct, a serrated flow can be observed in both tensile and compressive directions of the σ-e hysteresis loop. This means that dynamic strain aging takes place during fatigue deformation. The relation between elastic and plastic strain amplitudes with reversals to failure shows a monotonic linear behavior and can be well described by the Basquin and Coffin–Manson equations, respectively. In addition, crack initiation and propagation modes are suggested, based on scanning electron microscopy observations on the fracture surfaces of fatigued specimens.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Magnesium Alloys: Properties and Applications · Aluminum Alloys Composites Properties · Aluminum Alloy Microstructure Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (30)

Show source-provided references
1. Friedrich H., Schumann S. (2001) J. Mater. Proc. Technol. 117: 276-8110.1016/S0924-0136(01)00780-4 ↗
2. Kevorkijan V. (2003) Mater. Sci. Technol. 19: 1386-9010.1179/026708303225007988 ↗
3. Hu H., Yu A., Li N., Allison J.E. (2003) Mater. Manuf. Processes 18: 687-71710.1081/AMP-120024970 ↗
4. Renner F., Zenner H. (2002) Fatigue Fract. Eng. Mater. Struct. 25: 1157-6810.1046/j.1460-2695.2002.00607.x ↗
5. Lee S.G., Patel G.R., Gokhale A.M. (2005) Scripta Mater. 52: 1063-6810.1016/j.scriptamat.2005.01.007 ↗
6. Mayer H., Papakyriacou M., Zettl B., Stanzl-Tschegg S.E. (2003) Int. J. Fatigue 25: 245-5610.1016/S0142-1123(02)00054-3 ↗
7. Horstemeyer M.F., Yang N., Gall K., McDowell D.L., Fan J., Gullett P. (2002) Fatigue Fract. Eng. Mater. Struct. 25: 1045-5610.1046/j.1460-2695.2002.00594.x ↗
8. Horstemeyer M.F., Yang N., Gall K., McDowell D.L., Fan J., Gullett P. (2004) Acta Mater. 52: 1327-3610.1016/j.actamat.2003.11.018 ↗
9. Potzies C., Kainer K.U. (2004) Adv. Eng. Mater. 6: 281-8910.1002/adem.200400021 ↗
10. Shih T.S., Liu W.S., Chen Y.J. (2002) Mater. Sci. Eng., A, A325: 152-6210.1016/S0921-5093(01)01411-3 ↗
11. Unigovski Y., Eliezer A., Abramov E., Snir Y., Gutman E.M. (2003) Mater. Sci. Eng., A, A360: 132-3910.1016/S0921-5093(03)00409-X ↗
12. Tokaji K., Kamakura M., Ishiizumi Y., Hasegawa N. (2004) Int. J. Fatigue 26: 1217-2410.1016/j.ijfatigue.2004.03.015 ↗
13. Eisenmeier G., Holzwarth B., Höppel H.W., Mughrabi H. (2001) Mater. Sci. Eng. A, A319–A321: 578-8210.1016/S0921-5093(01)01105-4 ↗
14. Srivatsan T.S., Wei L., Chang C.F. (1997) Eng. Fract. Mech. 56: 735-5810.1016/S0013-7944(96)00127-0 ↗
15. Goodenberger D.L., Stephens R.I. (1993) J. Eng. Mater. Technol. 115: 391-9710.1115/1.2904236 ↗
16. Venkateswaran P., Ganesh Sundara Raman S., Pathak S.D., Miyashita Y., Mutoh Y. (2004) Mater. Lett. 58: 2525-2910.1016/j.matlet.2004.03.014 ↗
17. Wolf B., Fleck C., Eifer D. (2004) Int. J. Fatigue 26: 1357-6310.1016/j.ijfatigue.2004.04.005 ↗
18. Gall K., Biallas G., Maier H.J., Gullett P., Horstemeyer M.F., McDowell D.L., Fan J. (2004) Inter. J. Fatigue 26: 59-7010.1016/S0142-1123(03)00079-3 ↗
19. Gall K., Biallas G., Maier H.J., Gullett P., Horstemeyer M.F., McDowell D.L. (2004) Metall. Mater. Trans. A 35A: 321-3110.1007/s11661-004-0133-5 ↗
20. Wang X.S., Lu X., Wang D.H. (2004) Mater. Sci. Eng., A, A364: 11-1610.1016/j.msea.2003.04.001 ↗
21. Zenner H., Renner F. (2002) Int. J. Fatigue 24: 1255-6010.1016/S0142-1123(02)00042-7 ↗
22. Yoo M.H. (1981) Metall. Trans. A, 12A: 409-1810.1007/BF02648537 ↗
23. Staroselsky A., Anand L. (2003) Inter. J. Plasticity 19: 1843-6410.1016/S0749-6419(03)00039-1 ↗
24. J. Enss, T. Everitz, T. Reier, P. Juchmann, S. Schumann, and W. Sebastian: Proc. 2nd Israeli Int. Conf. on Magnesium Science & Technology, 2000, Magnesium Research Institute, Beer-Sheva, Israel, pp. 19-26.
25. Garcés P., Pérez X., Adeva P. (2005) Scripta Mater. 52: 615-1910.1016/j.scriptamat.2004.11.024 ↗
26. Kleiner S., Uggowitzer P.J. (2004) Mater. Sci. Eng., A, 379: 258-6310.1016/j.msea.2004.02.020 ↗
27. Cottrell A.H. (1953) Phil. Mag. 44: 829-3210.1080/14786440808520347 ↗
28. Mulford R.A., Kocks U.F. (1979) Acta Metall. 27: 1125-3410.1016/0001-6160(79)90130-5 ↗
29. Korbel A., Zasadzinski J., Sieklucka Z. (1976) Acta Metall. 24: 919-2310.1016/0001-6160(76)90040-7 ↗
30. Mikuloski B., Korbel A. (1982) Scripta Metall. 16: 1219-2310.1016/0036-9748(82)90470-7 ↗