journal article·2018-02

Cu 2 O thin films obtained from sol-gel cuo films using a simple argon/dry-air microwave plasma

M.A. Badillo-Ávila, R. Castanedo-Pérez, G. Torres-Delgado, J. Márquez-Marín, O. Zelaya-Ángel

Publisher page

Abstract

Abstract Cu2O thin films were obtained from CuO films using an argon/dry-air plasma treatment (PT) for times less than 30 s. CuO films were dip-coated on glass at a withdrawal speed of 8 cm/min from a sol-gel precursor solution. The as-prepared CuO samples were air-annealed conventionally at different temperatures, from 300 to 550 °C, to fabricate the CuO film-targets. An argon/dry-air PT was later applied to film-targets for 15, 20, 25 and 30 s in a modified microwave oven made with simple components. Cu2O mixed with a low amount of Cu was identified by X-ray diffraction in films treated for 20 s or less. Films only constituted of Cu2O were produced for most of the samples treated for 25 and 30 s. Depending on plasma processing time and CuO film-target annealing temperature, the crystallite size of Cu2O was largely changed (from 6 to 25 nm). Bigger Cu2O crystallite sizes were observed for targets with annealing of 400 °C. SEM studies showed surface morphology to depend on time of PT: grains grew, formed agglomerates and granules with longer exposure. These last caused a decrease in Cu2O film transparency below 800 nm for 30 s of treatment, but not for larger wavelengths nor for shorter times. Band gap value for CuO was 1.20 eV, and around 2.35 eV for Cu2O films below 25 s of plasma-treatment. However, 2.16 eV was calculated for the biggest crystallite size obtained at 30 s. Thickness and resistivity measurements were also performed. A strategic experiment showed that CuO films are reduced to metastable metallic copper with PT. This metallic copper readily oxidizes to Cu2O in open atmosphere. The biggest advantage of this plasma processing lies in the simplicity, short time of treatment and, low cost of the home-made equipment.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Copper-based nanomaterials and applications · ZnO doping and properties · Electronic and Structural Properties of Oxides

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (21)

Show source-provided references
1. Revived interest on yellow-exciton series in Cu2O: an experimental aspect10.1016/0038-1098(95)00601-X ↗
2. Formation of colloidal CuO nanocrystallites and their spherical aggregation and reductive transformation to hollow Cu2O nanospheres10.1021/la047671l ↗
3. Nanostructured copper oxide semiconductors: a perspective on materials, synthesis methods and applications10.1039/C4TC00345D ↗
4. Bi2S3/TiO2 and CdS/TiO2 heterojunctions as an available configuration for photocatalytic degradation of organic pollutant10.1016/j.jphotochem.2004.02.006 ↗
5. Efficient surface enhanced Raman scattering from Cu2O porous nanowires transformed from CuO nanowires by plasma treatments10.1016/j.matchemphys.2012.07.039 ↗
6. Facet-dependent electrical conductivity properties of Cu2O crystals10.1021/acs.nanolett.5b00150 ↗
7. Facet-dependent photocatalytic properties of Cu2O crystals probed by using electron, hole and radical scavengers10.1039/C7TA03848H ↗
8. Cuprous oxide thin films obtained by dip-coating method using rapid thermal annealing treatments10.1016/j.mssp.2017.06.017 ↗
9. Formation of cuprous oxide films via oxygen plasma10.1016/j.tsf.2010.03.102 ↗
10. Preparation of Cu2O nanowires by thermal oxidation-plasma reduction method10.1007/s00339-012-6859-9 ↗
11. Low temperature growth technique for nanocrystalline cuprous oxide thin films using microwave plasma oxidation of copper10.1016/j.matlet.2011.12.044 ↗
12. Characterization of Cu2O and Cu2O/Ag2O thin films synthesized by plasma oxidation10.1016/j.vacuum.2015.02.010 ↗
13. Oxide solar cells fabricated using zinc oxide and plasma-oxidized cuprous oxide10.7567/JJAP.51.125502 ↗
14. Characterization of cuprous oxide films prepared by post-annealing of cupric oxide using an atmospheric nitrogen pressure plasma torch10.1016/j.tsf.2008.04.104 ↗
15. H. Chen, J. Mai, Preparation and characterization of cuprous oxide thin films by an atmospheric pressure plasma annealing, in: Proceedings of the 22nd International Symposium on Plasma Chemistry, 2015, pp. 9–10.
16. J.M. Criado, M.J. Diánez, L.A.Pérez. Maqueda, Modificación de un horno doméstico de microondas para el tratamiento de materiales a alta temperatura bajo atmósfera controlada, in Congreso Conamet/SAM, 2008.
17. High-rate reduction of copper oxide using atmospheric-pressure inductively coupled plasma microjets10.1016/j.tsf.2011.01.219 ↗
18. Relation between surface roughness and specular reflectance at normal incidence10.1364/JOSA.51.000123 ↗
19. Size effects on the magnetic and optical properties of CuO nanoparticles10.1007/s11051-010-0143-8 ↗
20. Synthesis of ultrasmall Cu2O nanocubes and octahedra with tunable sizes for facet-dependent optical property examination10.1002/smll.201600064 ↗
21. Preparation, characteristics and photovoltaic properties of cuprous oxide – a review10.1016/0038-1101(86)90191-7 ↗