Enhance of thermoelectric properties of flexible β-Cu2+xSe/Cu2S multilayer films by layer interface
Source abstract
Abstract
In this study, the β-Cu 2+xSe/Cu 2S multilayer films were prepared by magnetron sputtering and the microstructure, thermoelectric properties, flexibility and output properties of thermoelectric generator for deposited β-Cu 2+xSe/Cu 2S multilayer films were studied. Results exhibited that the columnar grain diameter of the individual layer of the multilayer films reduced with decreasing in modulation period. The room temperature carrier concentration, mobility and electrical conductivity of the prepared β-Cu 2+xSe/Cu 2S multilayer films decreased from 3.61 × 10 21 cm −3, 2.22 cm 2 V −1 s −1 and 1.29 × 10 5 S m −1 to 2.28 × 10 21 cm −3, 1.67 cm 2 V −1 s −1 and 5.7 × 10 4 S m −1 with reducing modulation period from 400 to 185 nm, respectively. However, the room temperature Seebeck coefficient increased from 49.27 to 80.01 μV K −1 and the power factor first increased and then decreased with reduction in modulation period from 400 to 185 nm. This is due to the synergistically scattering of the carriers by the layer interface and the grain boundary. The maximum room temperature power factor approximately reached 395.52 μW m⁻ 1 K⁻ 2. Whether compressive or tensile stress bending, the relative electrical conductivity of the films gradually reduced with increase in bending angle. Under same bending angle, the relative electrical conductivity under tensile stress was lower than that under compressive stress. After 1500 repeated bending with a bending radius of 5 mm, the electrical conductivity of S5 film under compressive and tensile stress still retained 94 % and 90.2 %, respectively. The six-leg flexible thermoelectric generator (f-TEG) for S5 film exhibited the maximum output power density of 5.71 and 9.81 W m⁻ 2, corresponding to the standardized power density of 253.77 and 245.25 μW m⁻ 1 K −2 for temperature difference of 30 and 40 K, respectively. The power factor of the β-Cu 2+xSe films was greatly improved by inserting a Cu 2S heterogeneous interface layer and the β-Cu 2+xSe/Cu 2S multilayer films demonstrated excellent flexibility and output property.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced Thermoelectric Materials and Devices · Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (39)
Show source-provided references
1. Structural, morphological and thermoelectric properties of copper deficient and excessive Cu2-xS nanoparticles with (x=0-0.3)
2. Enhanced thermoelectricity in high-temperature β-phase copper (I) selenides embedded with Cu2Te nanoclusters10.1021/acsami.6b02086 ↗
3. Significant enhancement in ther moelectric performance of Mg3Sb2 from bulk to two-dimensional mono layer10.1016/j.nanoen.2019.05.028 ↗
4. Partial indium solubility induces chemical stability and colossal thermoelectric figure of merit in Cu2Se10.1039/C7EE01193H ↗
5. Influence of Si content on thermoelectric properties of Mg2 (Sn, Si) films by sputtering10.1016/j.vacuum.2023.112824 ↗
6. Enhanced thermoelectric performance of Cu2Se alloys by simultaneous engineering of thermal and electrical transport properties through S and Te Co‐doping10.1002/pssr.202400016 ↗
7. Influence of Cu content on the phase composition and thermoelectric properties of deposited Cu-Se films
8. Synergistically optimized electron and phonon transport in high-performance copper sulfides thermoelectric materials via one-pot modulation10.1038/s41467-024-47148-0 ↗
9. Flexible layer-structured Bi2Te3 thermoelectric on a carbon nanotube scaffold10.1038/s41563-018-0217-z ↗
10. Novel thermal diffusion temperature engineering leading to high thermoelectric performance in Bi2Te3‐based flexible thin‐films10.1002/advs.202103547 ↗
11. Optimized strategies for advancing n-type PbTe thermoelectrics: a review10.1021/acsami.0c15730 ↗
12. Giant enhancement in thermoelectric performance of copper selenide by incorporation of different nanoscale dimensional defect features10.1016/j.nanoen.2015.02.008 ↗
13. Ultrahigh thermoelectric performance in Cu2 Se-based hybrid materials with highly dispersed molecular CNTs10.1039/C7EE01737E ↗
14. Realizing high thermoelectric performance in highly (0l0)-textured flexible Cu2Se thin film for wearable energy harvesting
15. Thermoelectric properties of β-(Cu, Mn)2Se films with high (111) preferred orientation10.1016/j.vacuum.2021.110845 ↗
16. Morphology and texture engineering enhancing thermoelectric performance of solvothermal synthesized ultra-large SnS microcrystal
17. Significantly enhanced chemical stability in interface-controlled Cu2+xSe- reduced graphene oxide composites and related thermoelectric performances10.1016/j.jeurceramsoc.2020.08.023 ↗
18. Enhanced thermoelectric performance of Bi-Sb-Te/Sb2O3 nanocomposites by energy filtering effect10.1039/C8TA08238C ↗
19. Influence of carrier density and energy barrier scattering on a high Seebeck coefficient and power factor in transparent thermoelectric copper iodide10.1021/acsaem.0c01724 ↗
20. Enhancement of the thermoelectric properties in β-Cu2+xSe/a-C nano-multilayer films by heterogeneous interfaces10.1016/j.jallcom.2022.167432 ↗
21. Influence of modulation period for β-Cu2+xSe/SiC nano-multilayer films on their thermoelectric properties10.1016/j.pnsc.2022.09.010 ↗
22. Harvesting waste heat with flexible Bi2Te3 thermoelectric thin film10.1038/s41893-022-01003-6 ↗
23. Structural behaviour of β-Cu2-δSe (δ=0, 0.15, 0.25) in dependence on temperature studied by synchrotron powder diffraction10.1016/j.jallcom.2005.10.079 ↗
24. The effect of SPS sintering temperatures on the structure, thermoelectric properties, and scattering mechanism of Cu2Se10.1016/j.jmrt.2023.10.108 ↗
25. Directional thermal diffusion realizing inorganic Sb2Te3/Te hybrid thin films with high thermoelectric performance and flexibility10.1002/adfm.202207903 ↗
26. Band engineering of the second phase to reach high thermoelectric performance in Cu2Se‐based composite material10.1002/adma.202210345 ↗
27. Flexible power generators by Ag2Se thin films with record-high thermoelectric performance10.1038/s41467-024-45092-7 ↗
28. Enhanced thermoelectric properties of SnSe thin films grown by pulsed laser glancing-angle deposition10.1016/j.jmat.2017.05.001 ↗
29. Enhanced thermoelectric efficiency of Cu2−xSe–Cu2S composite by incorporating Cu2S nanoparticles10.1016/j.ceramint.2016.02.055 ↗
30. High thermoelectric performance in non‐toxic earth‐abundant copper sulfide10.1002/adma.201400515 ↗
31. Preparation and characterization of the Ag2Se flexible films tuned by PVP for wearable thermoelectric generator10.1007/s10854-021-06535-9 ↗
32. High-performance, thin-film thermoelectric generator with self-healing ability for body-heat harvesting
33. Exceptional power factor of flexible Ag/Ag2Se thermoelectric composite films10.1016/j.cej.2022.134739 ↗
34. Good performance and flexible PEDOT: PSS/Cu2Se nanowire thermoelectric composite films10.1021/acsami.9b01718 ↗
35. Enhanced- performance PEDOT: PSS/Cu2Se-based composite films for wearable thermoelectric power generators10.1021/acsami.0c18577 ↗
36. High-performance copper selenide thermoelectric thin films for flexible thermoelectric application
37. Largely enhanced performance of Cu2Se film by doping sulfur for flexible thermoelectric generators
38. Staggered-layer-boosted flexible Bi2Te3 films with high thermoelectric performance10.1038/s41565-023-01457-5 ↗
39. Ultrahigh performance polyvinylpyrrolidone/Ag2Se composite thermoelectric film for flexible energy harvesting10.1016/j.nanoen.2020.105488 ↗