Blistering-free carbon-doped polysilicon (n+) passivating contact with high surface passivation properties prepared by industrial tube PECVD
Source abstract
Abstract
Tube plasma-enhanced chemical vapor deposition (PECVD) has garnered attention as a promising large-scale production tool for in-situ doped polysilicon due to its high capacity and low equipment cost. In this work, we explore the use of carbon (C)-doped a-Si:H ( n + ), deposited by tube PECVD, for tunnel oxide passivated contact (TOPCon) solar cells. By introducing carbon atoms into polysilicon, blistering-free polysilicon films with excellent passivation properties can be obtained. The optimized sample with C-doped polysilicon ( n + ) exhibits remarkable surface passivation with a single-sided saturation current density ( J 0,s) of 1.25 fA/cm 2, an implied open-circuit voltage ( iV oc ) of 751 mV, and a corresponding effective lifetime exceeding 18 ms at a minority carrier concentration of 1 × 10 15 cm −3. UV Raman measurements reveal that C doping suppresses the crystallization of polysilicon, leading to a significant stress in the film. Despite excessive C doping, the contact resistivity extracted from the TLM method remains below 13.6 mΩ cm 2. As a result, a champion conversion efficiency of 23.64 % was achieved in a small-sized proof-of-concept n-type TOPCon solar cell. This demonstrates the feasibility of fabricating C-doped polysilicon ( n +) prepared by tube PECVD for high-efficiency and low-cost TOPCon solar cells.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Integrated Circuits and Semiconductor Failure Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (41)
Show source-provided references
1. Passivated rear contacts for high-efficiency n-type Si solar cells providing high interface passivation quality and excellent transport characteristics10.1016/j.solmat.2013.09.017 ↗
2. The application of poly-Si/SiOx contacts as passivated top/rear contacts in Si solar10.1016/j.solmat.2016.09.015 ↗
3. Ieee, initial results of monoPoly (TM) silicon solar cells at SERIS
4. Phosphorous-doped silicon carbide as front-side full-area passivating contact for double-side contacted c-Si solar cells10.1109/JPHOTOV.2018.2886234 ↗
5. On the passivation mechanism of poly-silicon and thin silicon oxide on crystal silicon wafers10.1016/j.solener.2019.10.064 ↗
6. Dual-functional carbon-doped polysilicon films for passivating contact solar cells: regulating physical contacts while promoting photoelectrical properties10.1039/D1EE02011K ↗
7. Frigge · 2016
8. Atomic scale controlled tunnel oxide enabled by a novel industrial tube-based PEALD technology with demonstrated commercial TOPCon cell efficiencies > 2410.1002/pip.3627 ↗
9. Ultrathin silicon oxide prepared by in-line plasma-assisted N2O oxidation (PANO) and the application for n-type polysilicon passivated contact10.1016/j.solmat.2019.110389 ↗
10. Laser contact openings for local poly-Si-metal contacts enabling 26.1%-efficient POLO-IBC solar cells10.1016/j.solmat.2018.06.020 ↗
11. Design rules for high-efficiency both-sides-contacted silicon solar cells with balanced charge carrier transport and recombination losses10.1038/s41560-021-00805-w ↗
12. 2023
13. 2023
14. Mass production of industrial tunnel oxide passivated contacts (i-TOPCon) silicon solar cells with average efficiency over 23% and modules over 345 W10.1002/pip.3180 ↗
15. Excellent surface passivation quality on crystalline silicon using industrial-scale direct-plasma TOPCon deposition technology10.1002/solr.201800068 ↗
16. Approaching 23% with large-area monoPoly cells using screen-printed and fired rear passivating contacts fabricated by inline PECVD10.1002/pip.3097 ↗
17. A passivating contact for silicon solar cells formed during a single firing thermal annealing10.1038/s41560-018-0239-4 ↗
18. Formation and suppression of hydrogen blisters in tunnelling oxide passivating contact for crystalline silicon solar cells10.1038/s41598-020-66801-4 ↗
19. Liu · 2023
20. Application of a-Si/mu c-Si hybrid layer in tunnel oxide passivated contact n-type silicon solar cells10.1016/j.solener.2017.01.061 ↗
21. Replacing the amorphous silicon thin layer with microcrystalline silicon thin layer in TOPCon solar cells10.1016/j.solener.2016.06.012 ↗
22. 730 mV implied Voc enabled by tunnel oxide passivated contact with PECVD grown and crystallized n+ polycrystalline Si
23. Highly passivating and blister-free hole selective poly-silicon based contact for large area crystalline silicon solar cells10.1016/j.solmat.2019.109912 ↗
24. Zeng · 2023
25. 24.4% industrial tunnel oxide passivated contact solar cells with ozone-gas oxidation Nano SiOx and tube PECVD prepared in-situ doped polysilicon10.1016/j.solmat.2022.111803 ↗
26. Feldmann · 2019
27. Effect of plasma-assisted N2O/Ar oxidation on TOPCon solar cells10.1016/j.solmat.2023.112489 ↗
28. Ye · 2020
29. Dependence of intrinsic stress in hydrogenated amorphous-silicon on excitation-frequency in a plasma-enhanced chemical vapor-deposition process10.1063/1.351440 ↗
30. Zhang · 2019
31. Improvement of surface passivation of tunnel oxide passivated contact structure by thermal annealing in mixture of water vapor and nitrogen environment10.1002/solr.201900105 ↗
32. UV-Raman scattering of thin film Si with ultrathin silicon oxide tunnel contact for high efficiency crystal silicon solar cells10.1016/j.solmat.2018.12.025 ↗
33. Experimental-determination of the nanocrystalline volume fraction in silicon thin-films from Raman-spectroscopy10.1063/1.99054 ↗
34. An application of Raman spectroscopy on the measurement of residual stress in porous silicon10.1016/j.optlaseng.2004.09.005 ↗
35. Contact resistance and contact resistivity10.1149/1.2404240 ↗
36. Capacitively coupled glow discharges at frequencies above 13.56 MHz10.1063/1.106112 ↗
37. High-temperature diffusion of phosphorus and boron in silicon via vacancies or via self-interstitials?10.1007/BF00894994 ↗
38. Mcintosh · 2013
39. 24.18% efficiency TOPCon solar cells enabled by super hydrophilic carbon-doped polysilicon films combined with plated metal fingers10.1016/j.solmat.2023.112393 ↗
40. A silicon carbide-based highly transparent passivating contact for crystalline silicon solar cells approaching efficiencies of 24%10.1038/s41560-021-00806-9 ↗
41. Surface passivation of crystalline silicon solar cells: present and future10.1016/j.solmat.2018.06.047 ↗