Study of the effects of NaCl or NaOH as sodium dopant precursors in p-type nanocrystalline Cu2O thin films
Source abstract
Abstract
Abstract The effects of sodium chloride (NaCl) or sodium hydroxide (NaOH) used to control the p-type conductivity of cuprous oxide Cu2O thin films by reactive thermal annealing (ReTA) at 550 °C in low oxygen content applied to NaX/Cu2O (X = Cl or OH) bilayers were studied. NaX nanolayers were deposited by dipping the Cu2O films in their saturated solutions. It has been reported that annealing Cu2O films covered with NaCl powders increased their hole concentration, but the effects of the X− ions on the oxide film had not been clarified. Here we report that the ReTA process applied to NaX/Cu2O bilayers reduces the electrical resistivity and increases the hole mobility, but the surface characteristics were also modified. During the ReTA process, CuXn (n = 1, 2) chemically reactive compounds are produced etching the film surface. The resistivity of the films was reduced by a factor of ten with respect to the as-grown Cu2O films by the Na incorporation and the hole mobility increased by the surface passivation due to the CuXn surfactant compounds produced during the ReTA process. The ReTA process applied during short periods the Cu2O phase was also stabilized according to the experimental results.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Copper-based nanomaterials and applications · ZnO doping and properties · Electronic and Structural Properties of Oxides
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (34)
Show source-provided references
1. High-efficiency oxide solar cells with ZnO/Cu2O heterojunction fabricated on thermally oxidized Cu2O sheets
2. Fabrication and characterization of CuO/ZnO solar cells10.1088/1742-6596/352/1/012022 ↗
3. Structural and electrical properties of CuO films and n-ZnO/p-CuO heterojunctions prepared by chemical bath deposition based technique10.1016/j.solmat.2014.08.023 ↗
4. Probing defects in nitrogen-doped Cu2O10.1038/srep07240 ↗
5. Chlorine doping of Cu2O10.1016/j.solmat.2010.06.022 ↗
6. Fabrication and characterization of Mn-doped Cu2O thin films grown by RF magnetron sputtering10.1016/j.jmmm.2008.06.035 ↗
7. Electrical and structural properties of Ni-doped Cu2O films prepared by pulsed laser deposition10.1016/j.tsf.2004.12.044 ↗
8. Effect of Mg doping on Cu2O thin films and their behavior on the TiO2/Cu2O heterojunction solar cells10.1016/j.solmat.2015.11.041 ↗
9. Control of the growth orientation and electrical properties of polycrystalline Cu2O thin films by group-IV elements doping10.1063/1.1827352 ↗
10. Impact of incorporating sodium into polycrystalline p-type Cu2O for heterojunction solar cell applications10.1063/1.4902879 ↗
11. Studies of structural, optical, and electrical properties associated with defects in sodium-doped copper oxide (CuO/Na) nanostructures10.1007/s10853-018-2179-6 ↗
12. Biccari · 2009
13. Heterojunction solar cell with 6% efficiency based on an n-type aluminum–gallium–oxide thin film and p-type sodium-doped Cu2O sheet
14. Relationship between the electrical properties of the n-oxide and p-Cu2O layers and the photovoltaic properties of Cu2O-based heterojunction solar cells10.1016/j.solmat.2015.11.033 ↗
15. The characteristics IGZO/ZnO/Cu2O: Na thin film solar cells fabricated by DC magnetron sputtering method10.1016/j.jphotochem.2017.09.016 ↗
16. Characterization of single phase nanometric Cu2O films grown by thermal oxidation in the range of 600 to 950 ° C in an atmosphere with low oxygen content
17. On the solubility of sodium chloride in water10.1016/0022-0248(82)90116-6 ↗
18. Byproducts and reaction pathways for integration of the Cu-Cl cycle of hydrogen production10.1016/j.ijhydene.2011.07.103 ↗
19. Evolution of morphology of nano-scale CuO grown on copper metal sheets in 5 wt% NaCl solution of spray fog environment
20. Deliberate and Accidental gas-phase Alkali doping of chalcogenide Semiconductors : Cu ( In, Ga) Se210.1038/srep43266 ↗
21. Evaporation and decomposition of eutectics of cupric chloride and sodium chloride10.1007/s10973-017-6360-y ↗
22. The transformation of Cu(OH)2 into CuO, revisited10.1016/j.solidstatesciences.2003.09.009 ↗
23. Facile synthesis of cupric hydroxide and cupric oxide on copper foil for potential electrochemical applications10.1088/1757-899X/201/1/012050 ↗
24. Soroka · 2016
25. Thermal dissociation of sodium hydroxide upon evacuation10.1007/s11167-005-0296-x ↗
26. Enhanced photoluminescence properties of Cu-doped ZnO thin films deposited by simultaneous RF and DC magnetron sputtering10.1016/j.mssp.2016.03.023 ↗
27. Synthesis of low resistive p type Cu4O3 thin films by DC reactive magnetron sputtering and conversion of Cu4O3 into CuO by laser irradiation10.1088/0022-3727/49/37/375102 ↗
28. Binary copper oxide semiconductors: from materials towards devices10.1002/pssb.201248128 ↗
29. Estudio de la cristalización de Cu2O y su caracterización por difracción de rayos X, espectroscópica Raman y fotoluminiscencia
30. Raman scattering, luminescence, and exciton-phonon coupling in Cu2O10.1103/PhysRevB.6.4753 ↗
31. Engineering crystal orientation of p-Cu2O on heterojunction solar cells10.1080/02670844.2017.1288342 ↗
32. The phase evolution and physical properties of binary copper oxide thin films prepared by reactive magnetron sputtering10.3390/ma11071253 ↗
33. Structure and morphology of Cu-oxides films derived from PLD processes
34. Impurity solubility limits in Ionic crystals, with application to Cu2O10.1524/zpch.1998.207.Part_1_2.181 ↗