Enhancing overall performances of Cu/Ag/AZO multilayer films for transparent heaters via laser/furnace step-by-step annealing mode
Source abstract
Abstract
Four different step-by-step annealing modes based on furnace and/or laser annealing (i.e. F + L, F + F, L + F and L + L) were developed and compared with one-step furnace or laser annealing mode (i.e. F and L), with an aim to enhance overall performances of Cu/Ag/AZO (CAA) multilayer films applied to transparent heaters. It was found that the L + F step-by-step annealing mode improved the transmittance and conductivity of the CAA film to the greatest extent, and therefore the resulting sample L + F achieved the best overall performance with a figure of merit of 4.26 × 10 −2 Ω −1 . These results should be ascribed to that laser annealing for the AZO layer in the first step facilitated growth and recrystallization of AZO grains to provide better nucleation sites for overlying Ag and Cu grains, and furnace annealing of the whole CAA film in the second step promoted the melting of the surface Ag and Cu grains to re-aggregate with the nearby AZO grains. The transparent heater prepared from the sample L + F exhibited a high steady-state temperature of 127.1 °C within a short response time of 80 s under an input voltage of 3 V, as well as good heating stability and effective deicing function.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: ZnO doping and properties · Copper-based nanomaterials and applications · Nanomaterials and Printing Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (60)
Show source-provided references
1. High-performance flexible transparent conductive thin films on PET substrates with a CuM/AZO structure10.1007/s10854-019-01690-6 ↗
2. Transparent heaters: a review10.1002/adfm.201910225 ↗
3. Properties of transparent and conductive Al:ZnO/Au/Al:ZnO multilayers on flexible PET substrates10.1016/j.mseb.2015.06.008 ↗
4. AZO/Ag/AZO transparent flexible electrodes on mica substrates for high temperature application10.1016/j.ceramint.2017.08.089 ↗
5. Characteristics of transparent conductive Al-doped ZnO and Ag–Ti tri-layer thin films prepared by multi-target magnetron sputtering10.1016/j.surfcoat.2013.01.017 ↗
6. Preparation of RF sputtered AZO/Cu/AZO multilayer films and the investigation of Cu thickness and substrate effects on their microstructural and optoelectronic properties10.1016/j.jallcom.2020.158470 ↗
7. High photoelectric performance of Cu-based AZO multilayer films deposited via TiO2 barrier layer and oxygen-containing atmosphere10.1016/j.ceramint.2019.08.144 ↗
8. Diffusion-induced doping effects of Ga in ZnO/Ga/ZnO and AZO/Ga/AZO multilayer thin films10.1016/j.apsusc.2018.04.082 ↗
9. Effect of RF sputtering power and vacuum annealing on the properties of AZO thin films prepared from ceramic target in confocal configuration10.1016/j.mssp.2020.105217 ↗
10. AZO/Ag/AZO transparent flexible electrodes on mica substrates for high temperature application10.1016/j.ceramint.2017.08.089 ↗
11. Enhancing optical and electrical properties of Al-doped ZnO coated polyethylene terephthalate substrates by laser annealing using overlap rate controlling strategy10.1016/j.ceramint.2016.01.118 ↗
12. Morphology, structure and photoelectric properties of F-doped SnO2 films under flexible PET mask reinforced laser annealing10.1016/j.mssp.2021.105853 ↗
13. Effect of annealing on the structural, optical and electrical properties of (F, Zn) double doped SnO2 nanoparticles obtained by the laser pyrolysis method
14. Resistive switching behaviors of cobalt oxide films with structural change by post-thermal annealing10.1016/j.mssp.2022.107295 ↗
15. Achievement of high electrochromic performance of TiO2 thin films prepared via spray pyrolysis method, influence of annealing process
16. Surface morphology and photoelectric properties of FTO ceramic thin films under a simple transparent cover-assisted laser annealing10.1016/j.materresbull.2018.09.002 ↗
17. Excimer laser annealing: an alternative route and its optimisation to effectively activate Si dopants in AlN films grown by plasma assisted molecular beam epitaxy10.1016/j.materresbull.2017.09.016 ↗
18. Property change during nanosecond pulse laser annealing of amorphous NiTi thin film10.1007/s12034-012-0293-7 ↗
19. Considering the effectiveness of a unique combined annealing-based postprocessing method on the optoelectronic properties of MAPbBr3-based light emitting diodes10.1016/j.ssc.2022.114965 ↗
20. Highly transparent AgGaS2 single crystals, a compound for mid-IR laser sources, using a combined static/dynamic vacuum annealing method10.1016/j.matchemphys.2009.08.043 ↗
21. Rapid low-temperature processing of metal-oxide thin film transistors with combined far ultraviolet and thermal annealing10.1063/1.4895830 ↗
22. Improvement in overall photoelectric properties of Ag/FTO bilayer thin films using furnace/laser dual annealing10.1016/j.matlet.2013.11.079 ↗
23. Two-step optical annealing effects on spin-coated InAl-doped ZnO thin films10.1016/j.jallcom.2014.07.023 ↗
24. Preparation of AZO-based multilayer thin films with high comprehensive properties by introducing Cu/Ag bimetallic layers10.1007/s10854-023-10206-2 ↗
25. Confocal magnetron sputtering deposition of Cu/AZO bilayer structures: effect of Cu thickness on microstructural and optoelectronic properties10.1007/s10854-022-09338-8 ↗
26. Effect of vacuum annealing on structural and electrical properties of germanium telluride thin films10.1016/j.materresbull.2021.111575 ↗
27. Impact of different annealing conditions on physical properties of ZnSe thin films for ecofriendly buffer layer applications
28. Nanosecond pulsed laser annealing of Cu/Ag/AZO multilayer thin films for performance improvement and transparent heater application10.1016/j.mseb.2023.116539 ↗
29. Enhancement of the conversion efficiency of selective emitter PERC solar cells by post-oxidation10.1016/j.mssp.2022.106882 ↗
30. Investigation of post-annealing effect on Al:ZnO thin films crystallinity and photoluminescence properties10.1016/j.physb.2021.413461 ↗
31. Annealing induced transformation and enhancement in the electronic defect states of Al doped ZnO films and their correlation with the optoelectronic properties10.1016/j.jallcom.2019.03.032 ↗
32. Effects of different annealing atmospheres on the properties of cadmium sulfide thin films10.1016/j.materresbull.2015.03.067 ↗
33. Annealing temperature induced physical characteristics of CuO films grown by magnetron sputtering10.1016/j.mssp.2021.105883 ↗
34. Effect of post-deposition annealing on phase formation and properties of RF magnetron sputtered PLZT thin films10.1016/j.materresbull.2007.02.044 ↗
35. Photoconductivity properties of silver-doped zinc oxide films10.1007/s00339-021-04806-0 ↗
36. Performance optimization of SnO2:F thin films under quasi-vacuum laser annealing with covering a transparent PET sheet: a study using processing map10.1016/j.apsusc.2020.145334 ↗
37. Characterization of AZO and Ag based films prepared by RF magnetron sputtering10.1016/j.jallcom.2014.07.105 ↗
38. Ag thickness and substrate effects on microstructural and optoelectronic properties of AZO/Ag/AZO multilayer structures deposited by confocal RF magnetron sputtering10.1007/s00339-023-06822-8 ↗
39. Growth of AZO/Cu/AZO multilayer structures by confocal RF magnetron sputtering and their microstructural and optoelectronic properties before and after annealing10.1016/j.mseb.2022.115889 ↗
40. Structural and optical properties of ZnO and Ni:ZnO thin films: the trace of post-annealing10.1007/s10854-020-05092-x ↗
41. Structural and optical characterization of ZnO and AZO thin films: the influence of post-annealing10.1007/s10854-015-3804-7 ↗
42. Photoelectric property enhancement of Ag/FTO thin films by fabricating antireflection grating structures using ultrasonic-vibration-assisted laser irradiation10.1016/j.apsusc.2020.148449 ↗
43. Selective laser ablation preparation of Ag grid transparent electrodes with fractal-combined structures and optimization of fractal grid pitch10.1016/j.optlastec.2022.108597 ↗
44. Highly strained and heavily doped germanium thin films by non-equilibrium high-speed CW laser annealing for optoelectronic applications10.1016/j.mssp.2023.107516 ↗
45. Structure, morphology and photoluminescence attributes of Al/Ga co-doped ZnO nanofilms: role of annealing time10.1016/j.materresbull.2017.08.050 ↗
46. Fabrication and performance improvement of Ag grid transparent conducting films using selective laser ablation10.1007/s10854-021-07666-9 ↗
47. Comprehensive characterization of Al-doped ZnO thin films deposited in confocal radio frequency magnetron co-sputtering10.1016/j.tsf.2023.139947 ↗
48. Effects of annealing temperature on ZnO and AZO films prepared by sol–gel technique10.1016/j.apsusc.2012.05.156 ↗
49. The effects of thermal annealing on the structural and electrical properties of zinc tin oxide thin films for transparent conducting electrode applications10.1016/j.physb.2019.01.016 ↗
50. Effect of annealing temperature on the growth of Zn-Sn-O nanocomposite thin films10.1016/j.jallcom.2017.04.230 ↗
51. Effect of laser pulse energy and wavelength on the structure, morphology and optical properties of ZnO nanoparticles10.1016/j.optlastec.2013.10.031 ↗
52. Annealing effected Nb dopant activation and optoelectronic properties in anatase thin films10.1007/s10854-020-05076-x ↗
53. Suppression of grain boundary contributions on carrier mobility in thin Al-doped ZnO epitaxial films
54. Improving optical and electrical performances of aluminum-doped zinc oxide thin films with laser-etched grating structures10.1016/j.ceramint.2020.11.150 ↗
55. Increased thermal stability of Al-doped ZnO-based transparent conducting electrodes employing ultra-thin Au and Cu layers10.1016/j.tsf.2012.03.103 ↗
56. Fabrication and performances of silver grid transparent conducting films and heaters on glass and PET substrates based on fractal periodic grid pattern design
57. Solution processed aluminum-doped ZnO thin films for transparent heater applications10.1016/j.mssp.2021.105735 ↗
58. Flexible multilayered transparent electrodes with less than 50 nm thickness using nitrogen-doped silver layers for flexible heaters10.1016/j.materresbull.2021.111703 ↗
59. Cu2O thin films grown by magnetron sputtering as solar cell absorber layers10.1016/j.mssp.2022.106818 ↗
60. Design and implementation of an ultrathin dielectric/metal/dielectric transparent electrode for Cu2ZnSnS4 thin-film photovoltaics10.1016/j.solmat.2021.111247 ↗