journal article·2022-06Open access

ICP etching of GaN microstructures in a Cl2–Ar plasma with subnanometer-scale sidewall surface roughness

Clint D. Frye, Catherine E. Reinhardt, Scott B. Donald, Lars F. Voss, Sara E. Harrison

Abstract

Substrate temperature, RF power, and ICP power were investigated for their effects on GaN micropillar sidewall roughness and etch characteristics. Elevated substrate temperature was shown to improve the sidewall etch morphology at low RF powers (reduced physical bombardment) and low ICP powers (lower plasma densities). Increased lateral etching is observed with both increased ICP power and substrate temperature, which both act to increase the chemical component of the etch. Etch conditions with a high chemical driving force resulted in faceting along the a-plane on the sidewalls. This faceting produced extremely smooth surfaces with root-mean-square roughness (R q ) as low as 0.20 nm which is comparable to typical epitaxy-ready surfaces and smaller than the a-plane lattice spacing of 0.3186 nm. The smooth surfaces produced in this study enable possibilities for laser facets or for new device structures that require high quality surfaces for GaN regrowth.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: GaN-based semiconductor devices and materials · Plasma Diagnostics and Applications · Semiconductor materials and devices

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (39)

Show source-provided references
1. The 2018 GaN power electronics roadmap10.1088/1361-6463/aaaf9d ↗
2. Wet etching of GaN, AlN, and SiC: a review10.1016/j.mser.2004.11.002 ↗
3. Plasma etching of wide bandgap and ultrawide bandgap semiconductors10.1116/1.5131343 ↗
4. Demonstration of 1.27 kV etch-then-regrow GaN p-n junctions with low leakage for GaN power electronics10.1109/LED.2019.2941830 ↗
5. Investigation of dry-etch-induced defects in >600 V regrown, vertical, GaN, p-n diodes using deep-level optical spectroscopy10.1063/1.5110521 ↗
6. High-quality nanodisk of InGaN/GaN MQWs fabricated by neutral-beam-etching and GaN regrowth: towards directional micro-LED in top-down structure10.1088/1361-6641/ab8539 ↗
7. Ultradeep electron cyclotron resonance plasma etching of GaN10.1116/1.4994829 ↗
8. Top-down fabrication of large-area GaN micro- and nanopillars10.1116/1.4865908 ↗
9. Suppression of plasma-induced damage on GaN etched by a Cl2 plasma at high temperatures10.7567/JJAP.54.06GB04 ↗
10. Investigation of effects of ion energies on both plasma-induced damage and surface morphologies and optimization of high-temperature Cl2 plasma etching of GaN10.7567/JJAP.56.026502 ↗
11. Thermally enhanced formation of photon-induced damage on GaN films in Cl2 plasma10.7567/JJAP.56.096501 ↗
12. Temperature dependence on plasma-induced damage and chemical reactions in GaN etching processes using chlorine plasma10.7567/JJAP.57.06JD01 ↗
13. Effects of BCl3 addition to Cl2 gas on etching characteristics of GaN at high temperature10.1116/1.5082345 ↗
14. Elevated-temperature etching of gallium nitride (GaN) in dual-frequency capacitively coupled plasma of CH4/H2 at 300–500 °C10.1016/j.vacuum.2018.07.040 ↗
15. Temperature-dependence of Cl2/Ar ICP-RIE of polar, semipolar, and nonpolar GaN and AlN following BCl3/Ar breakthrough plasma
16. High-density plasma etch selectivity for the III–V nitrides10.1016/S0038-1101(98)00224-X ↗
17. Inductively coupled plasma etching of GaN10.1063/1.117077 ↗
18. Inductively coupled plasma etching of GaN and its effect on electrical characteristics10.1116/1.1421543 ↗
19. Characterization of inductively coupled plasma etched surface of GaN using Cl2/BCl3 chemistry10.1116/1.1392400 ↗
20. Characteristics of n-GaN after Cl2/Ar and Cl2/N2 inductively coupled plasma etching10.1143/JJAP.42.6409 ↗
21. Dry etching characteristics of GaN using Cl2/BCl3 inductively coupled plasmas10.1016/j.apsusc.2010.07.088 ↗
22. Deep GaN etching by inductively coupled plasma and induced surface defects10.1116/1.3478674 ↗
23. Low resistivity contacts to plasma etched Mg-doped GaN using very low power inductively coupled plasma etching10.1016/j.tsf.2011.01.276 ↗
24. Cl2/Ar based inductively coupled plasma etching of GaN/AlGaN structure
25. $\hboxBCl_3/\hboxCl_2$-Based inductively coupled plasma etching of GaN/AlGaN using photoresist mask10.1109/TPS.2012.2206831 ↗
26. Effect of BCl3 concentration and process pressure on the GaN mesa sidewalls in BCl3/Cl2 based inductively coupled plasma etching10.1016/j.vacuum.2012.04.018 ↗
27. GaN etch rate and surface roughness evolution in Cl2/Ar based inductively coupled plasma etching10.1016/j.tsf.2012.07.117 ↗
28. Fabrication of GaN hexagonal cones by inductively coupled plasma reactive ion etching10.1116/1.4954986 ↗
29. Implementation of slow and smooth etching of GaN by inductively coupled plasma10.1088/1674-4926/39/11/113002 ↗
30. GaN: processing, defects, and devices10.1063/1.371145 ↗
31. Deep GaN through-substrate via etching using Cl2/BCl3 inductively coupled plasma10.1116/6.0000526 ↗
32. Ultrahigh GaN:SiO2 etch selectivity by in situ surface modification of SiO2 in a Cl2-Ar plasma10.1080/21663831.2020.1847735 ↗
33. Leung · 2016 · 45
34. High temperature isotropic and anisotropic etching of silicon carbide using forming gas10.1116/6.0000533 ↗
35. Substrate trenching mechanism during plasma and magnetically enhanced polysilicon etching10.1149/1.2085726 ↗
36. Molecular-beam study of the plasma-surface kinetics of silicon dioxide and photoresist etching with chlorine10.1116/1.1387452 ↗
37. Exposure of defects in GaN by plasma etching10.1007/s00339-003-2372-5 ↗
38. Dislocation density investigation on MOCVD-grown GaN epitaxial layers using wet and dry defect selective etching10.1007/s00339-016-0143-3 ↗
39. Atomic layer etching of GaN and AlGaN using directional plasma-enhanced approach10.7567/JJAP.56.06HB06 ↗