journal article·2020-08

Solar cell fabrication from semiconducting Cu3SbS3 on n-Si: Parameters evolution

Shiamaa A. Zaki, M.I. Abd-Elrahman, A.A. Abu-Sehly, N.M. Shaalan, M.M. Hafiz

Publisher page

Abstract

Abstract Cu3SbS3 (CAS) thin films are synthesized by the conventional thermal evaporation technique. The induced effects in optical and morphological properties of these films upon the annealing process in temperature range 473–623 K are studied. X-ray diffraction (XRD) analyses reveal the amorphous nature of the as-deposited film which crystallizes in monoclinic crystal structure after annealing. The absorption coefficient, refractive index and film thickness are calculated by Swanipoel's method. The observed optical band gap (Eg) shows a decrease in its value from 1.88 to 1.61 eV after annealing which is consistent with the detected red shift of absorption edge in the transmission spectra. The fabrication and the current-voltage (J-V) characteristics of Al/n-Si/p-CAS/Ag junction at different annealing temperatures are investigated. Dark measurements reveal good rectification behavior ≈ 102. Under illumination, the best performance is achieved for annealed cell at 523 K with short circuit current (Jsc) = 6.65 mAcm2, open circuit voltage (Voc) = 0.3 V, fill factor (FF) = 30% and conversion efficiency (η) = 1.49%.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (45)

Show source-provided references
1. Outlook on the Indian scenario of solar energy strategies: Policies and challenges10.1016/j.esr.2019.04.005 ↗
2. High efficiency silicon solar cells10.1016/j.egypro.2013.05.033 ↗
3. Sarkar · 2018
4. Solution processable wurtzite CuInS2 inverted type solar cell10.1016/j.solmat.2017.02.004 ↗
5. Efficiency Enhancement of Solid-State CuInS2 Quantum Dot- Sensitized solar cells by Improving the charge Recombination
6. Cu2SnS3 as a potential absorber for thin film solar cells
7. Influence of annealing temperature on the properties and solar cell performance of Cu2SnS3 (CTS) thin film prepared using sputtering method10.1016/j.jallcom.2016.06.264 ↗
8. Fabrication and characterization of cost-efficient CuSbS2 thin film solar cells using hybrid inks10.1016/j.solmat.2016.02.013 ↗
9. CuSbS2 as a Promising Earth-Abundant photovoltaic absorber material: a Combined Theoretical and Experimental study10.1021/cm500516v ↗
10. Accelerated development of CuSbS2 thin film photovoltaic device prototypes10.1002/pip.2735 ↗
11. Synthesis and characterization of famatinite copper antimony sulfide nanocrystals10.1039/c2jm32094k ↗
12. Selective Nanocrystal Synthesis and Calculated Electronic Structure of All Four Phases of copper–antimony–sulfide10.1021/cm5005642 ↗
13. Structural, optical and charge generation properties of chalcostibite and tetrahedrite copper antimony sulfide thin films prepared from metal xanthates10.1039/C5TA05777A ↗
14. Synthesis, characterization, and surface-enhanced Raman scattering of near infrared absorbing Cu3SbS3 nanocrystals10.1039/c3ce41861h ↗
15. Thin films of copper antimony sulfide: a photovoltaic absorber material10.1016/j.materresbull.2014.10.027 ↗
16. Two-stage co-evaporated CuSbS2 thin films for solar cells10.1016/j.jallcom.2016.04.193 ↗
17. Chalcogenisation of Cu–Sb metallic precursors into Cu3Sb(SexS1−x)310.1016/j.solmat.2013.02.016 ↗
18. CuS-based thin films for architectural glazing applications produced by co-evaporation: Morphology, optical and electrical properties10.1016/j.surfcoat.2009.08.037 ↗
19. Sputtered molybdenum bilayer back contact for copper indium diselenide-based polycrystalline thin-film solar cells10.1016/0040-6090(94)06462-8 ↗
20. Structural, optical and electrical properties of copper antimony sulfide thin films grown by a citrate-assisted single chemical bath deposition10.1016/j.apsusc.2017.08.027 ↗
21. Gale · 2004
22. Characterization of vacuum-evaporated ZnSe thin films10.1016/j.physb.2006.12.047 ↗
23. Effect of annealing temperature on thermally evaporated Cu3SbS3 thin films10.1007/s10854-018-8954-y ↗
24. Fabrication of sputtered deposited Cu2SnS3 (CTS) thin film solar cell with power conversion efficiency of 2.39 %10.1016/j.jallcom.2017.01.191 ↗
25. Determination of thin film refractive index and thickness by means of film phase thickness
26. Determination of the thickness and optical constants of amorphous silicon10.1088/0022-3735/16/12/023 ↗
27. The optical constants determination of thin-films
28. Direct calculation of the optical constants for a thin film using a midpoint envelope10.1364/AO.46.004660 ↗
29. Calculation of thin-film optical constants by transmittance-spectra fitting10.1364/JOSAA.15.001852 ↗
30. Thermal annealing of SnS thin film induced mixed tin sulfide oxides-Sn2S3 for gas sensing: optical and electrical properties10.1016/j.mssp.2017.11.034 ↗
31. Optical and structural properties of CuSbS2 thin films grown by thermal evaporation method10.1016/j.tsf.2008.11.021 ↗
32. Vacuum coated Sb2S3 thin films: thermal treatment and the evolution of its physical properties10.1016/j.materresbull.2017.03.013 ↗
33. Variation of optical gap of thick amorphous selenium film on heat treatment10.1016/0022-3093(83)90092-3 ↗
34. Development and study of chalcogenide Se60Te30S10 thin film coated by carbon film: structural and optical properties10.1016/j.mssp.2014.08.033 ↗
35. Sze · 1981
36. Anomalous dark current ideality factor (n > 2) in thin-film solar cells: the role of grain-boundary defects
37. Electrical and photovoltaic properties of SnSe/Si heterojunction10.1016/j.mssp.2013.10.003 ↗
38. Extraction of Schottky diode parameters from forward current‐voltage characteristics10.1063/1.97359 ↗
39. Effect of Pretreatment and annealing on Aluminum Coating prepared by physical Vapor deposition on AZ91D Magnesium Alloys10.20964/2016.07.57 ↗
40. Annealing effects on microstructure and mechanical properties of chromium oxide coatings10.1016/j.tsf.2007.08.083 ↗
41. Study the effect of thermal annealing on adhesion strength of Silver-Tantalum Oxide thin film deposited by reactive magnetron sputtering10.1080/01694243.2018.1549770 ↗
42. Effect of thermal annealing in vacuum on the photovoltaic properties of electrodeposited Cu2O-absorber solar cell10.1051/epjpv/2014005 ↗
43. Properties of thin films for solar cells
44. Microstructural Characterisations of Perovskite solar cells – from Grains to Interfaces: Techniques, Features, and challenges10.1002/aenm.201700912 ↗
45. High open‐circuit voltage CuSbS2 solar cells achieved through the formation of epitaxial growth of CdS/CuSbS2 hetero‐interface by post‐annealing treatment