Enhanced thermoelectric transport properties of Bi2Te3 polycrystalline alloys via carrier type change arising from slight Pb doping
Source abstract
Abstract
Herein, thermoelectric transport properties of lightly Pb-doped Bi 2-xPb xTe 3 ( x = 0, 0.0025, 0.005, and 0.01) alloys are investigated. Negative Seebeck coefficient (−169 μV/K) of the pristine Bi 2Te 3 increases to −120 μV/K for x = 0.0025 at 300 K. As Pb further doped, positive Seebeck coefficients of 191 and 157 μV/K are measured for x = 0.005 and 0.01, respectively. P-type power factor increased to 2.32 mW/mK 2 by the Pb doping for x = 0.01 at 300 K, compared with n-type power factor of 1.81 mW/mK 2 of the pristine Bi 2Te 3. The decrease in κ lat was observed for x = 0.01 due to additional phonon scattering by point defects. As results, p-type thermoelectric figure of merit zT of 0.42 for x = 0.01 is achieved compared with n-type zT of 0.35 for Bi 2Te 3 at 300 K. The maximum p-type zT of 0.56 was obtained for Bi 1.99Pb 0.01Te 3 ( x = 0.01). Therefore, a relative high p-type zT value was successfully achieved by the slight Pb doping in Bi 2Te 3 by carrier type change from n-type to p-type.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced Thermoelectric Materials and Devices · Thermal properties of materials · Thermal Radiation and Cooling Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (41)
Show source-provided references
1. Cooling, heating, generating power, and recovering waste heat with thermoelectric systems10.1126/science.1158899 ↗
2. Direct observation of the spin-dependent Peltier effect10.1038/nnano.2012.2 ↗
3. Keynote review of latest advances in thermoelectric generation materials, devices, and technologies 202210.3390/en15197307 ↗
4. Thermoelectric Generators: a comprehensive review of characteristics and applications10.1016/j.applthermaleng.2021.117793 ↗
5. Constructing n-type Ag2Se/CNTs composites toward synergistically enhanced thermoelectric and mechanical performance10.1016/j.actamat.2021.117502 ↗
6. Improved thermoelectric properties of zone-melted p-type bismuth-telluride-based alloys for power generation10.1007/s12598-021-01901-2 ↗
7. Realizing high thermoelectric properties in p-type polycrystalline SnSe by inducing DOS distortion10.1007/s12598-021-01753-w ↗
8. Scherrer · 2006 · 1008
9. Bismuth telluride and its alloys as materials for thermoelectric generation10.3390/ma7042577 ↗
10. Fabrication and thermoelectric performance of textured n-type Bi2(Te,Se)3 by spark plasma sintering10.1016/j.mseb.2005.01.002 ↗
11. Thermoelectric properties of p-type (Bi2Te3)x(Sb2Te3)1−x prepared via bulk mechanical alloying and hot pressing10.1016/S0925-8388(00)01063-X ↗
12. Bi2Te3-based applied thermoelectric materials: research advances and new challenges10.1093/nsr/nwaa259 ↗
13. Thermoelectric properties of n-type (Bi2Se3)x(Bi2Te3)1−x prepared by bulk mechanical alloying and hot pressing10.1016/S0925-8388(00)01159-2 ↗
14. The thermoelectric properties of bismuth telluride10.1002/aelm.201800904 ↗
15. Mott's formula for the thermopower and the Wiedemann-Franz law10.1103/PhysRevB.21.4223 ↗
16. Mediating point defects endows n-type Bi2Te3 with high thermoelectric performance and superior mechanical robustness for power generation application10.1002/smll.202201352 ↗
17. Cold-sintered Bi2Te3-based materials for engineering nanograined thermoelectrics10.1021/acsaem.1c03540 ↗
18. Defect chemistry for thermoelectric materials10.1021/jacs.6b08748 ↗
19. Defect engineering in thermoelectric materials: what have we learned?10.1039/D1CS00347J ↗
20. Design and preparation of high-performance bulk thermoelectric materials with defect structures10.4191/kcers.2017.54.2.10 ↗
21. Concentration‐dependent excess Cu doping behavior and influence on thermoelectric properties in Bi2Te310.1002/er.7366 ↗
22. Roles of Cu in the enhanced thermoelectric properties in Bi0.5Sb1.5Te310.3390/ma10030251 ↗
23. Simultaneous optimization of electrical and thermal transport properties of Bi0.5Sb1.5Te3 thermoelectric alloy by twin boundary engineering10.1016/j.nanoen.2017.05.031 ↗
24. Important role of Cu in suppressing bipolar conduction in Bi-rich (Bi,Sb)2Te310.1016/j.scriptamat.2020.05.039 ↗
25. Phonon scattering in semiconductors from thermal conductivity studies10.1103/PhysRev.134.A471 ↗
26. Point defect engineering: Co‐doping synergy realizing superior performance in n‐type Bi2Te3 thermoelectric materials10.1002/smll.202101328 ↗
27. Role of excess Te in Bi0.5Sb1.5Te3+x(x= 0, 0.01, 0.015 and 0.020) on the optimization of thermoelectric properties10.1016/j.mssp.2020.105292 ↗
28. Effect of substitutional Pb doping on bipolar and lattice thermal conductivity in p-type Bi0.48Sb1.52Te310.3390/ma10070763 ↗
29. Defect structure of Pb-doped Bi2Te3 single crystals10.1080/14786430410001678226 ↗
30. Transition from n- to p-type conduction concomitant with enhancement of figure-of-merit in Pb doped bismuth telluride: material to device development10.1016/j.matdes.2018.08.035 ↗
31. Mills · 1974
32. Micro-Raman spectroscopy of mechanically exfoliated few-quintuple layers of Bi2Te3, Bi2Se3, and Sb2Te3 materials10.1063/1.3690913 ↗
33. Lattice dynamics of Bi2Те3 and vibrational modes in Raman scattering of topological insulators MnBi2Te4·n(Bi2Te3)10.1134/S0021364022600987 ↗
34. Enhanced thermoelectric properties of solution grown Bi2Te3–xSex nanoplatelet composites10.1021/nl2034859 ↗
35. Weighted mobility10.1002/adma.202001537 ↗
36. Approach to determine the density‐of‐states effective mass with carrier concentration‐dependent Seebeck coefficient10.1002/adfm.202203852 ↗
37. Thermoelectric properties of CuGa1−xMnxTe2: power factor enhancement by incorporation of magnetic ions10.1039/C6TA11120C ↗
38. Effect of phonon drag on Seebeck coefficient based on linear response theory: application to FeSb210.7566/JPSJ.88.074601 ↗
39. Magnetism-mediated thermoelectric performance of the Cr-doped bismuth telluride tetradymite
40. Thermoelectric materials and transport physics
41. Characterization of Lorenz number with Seebeck coefficient measurement10.1063/1.4908244 ↗