Pulsed DC magnetron sputtering deposition of crystalline photocatalytic titania coatings at elevated process pressures
Source abstract
Abstract
Abstract The use of elevated process pressures is described in the magnetron sputter deposition of titanium dioxide photocatalytic coatings to enable the direct low-temperature formation of the most photoactive titania crystal phase; anatase. Most other works on this subject deal with relatively low ‘conventional’ pressures (0.1–0.5 Pa). However, the present work describes pulsed DC reactive magnetron sputtering deposition of titanium dioxide thin films at process pressures in the range 2–5 Pa in a purpose-built sputtering rig. The influence of the other deposition conditions, such as pulse frequency and duty cycle, is also discussed. Additionally, a series of N-doped titania coatings was produced by using air as the reactive gas. The morphological and compositional properties of the coatings were studied using energy dispersive X-ray spectroscopy (EDX), scanning electron microscopy (SEM), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and atomic force microscopy (AFM). Wettability of the films was studied through measurement of water contact angles under UV light irradiation. Photocatalytic properties of the samples were assessed through the degradation of two model pollutants, methylene blue and stearic acid, under UV light irradiation. The results showed that elevated process pressures (4 Pa and above) allow the direct deposition of anatase titania films, without additional heat treatment, while amorphous titania tends to form at lower process pressures.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced Photocatalysis Techniques · TiO2 Photocatalysis and Solar Cells · Electronic and Structural Properties of Oxides
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (35)
Show source-provided references
1. Photosensitized electrolytic oxidation on semiconducting n-type TiO2 electrode10.1246/nikkashi1898.72.108 ↗
2. Recent developments in titanium oxide-based photocatalysts10.1016/j.apcata.2007.03.013 ↗
3. A review on the visible light active titanium dioxide photocatalysts for environmental applications10.1016/j.apcatb.2012.05.036 ↗
4. Titanium dioxide photocatalysis: present situation and future approaches10.1016/j.crci.2005.02.055 ↗
5. Titanium oxide based visible light photocatalysts: materials design and applications10.1016/j.tsf.2008.11.087 ↗
6. Strategies of making TiO2 and ZnO visible light active10.1016/j.jhazmat.2009.05.064 ↗
7. Enhanced properties of magnetron sputtered photocatalytic coatings via transition metal doping10.1016/j.surfcoat.2012.04.037 ↗
8. Synergistic effect of doping with nitrogen and molybdenum on the photocatalytic properties of thin titania films10.1016/j.vacuum.2014.10.012 ↗
9. Magnetron sputtering: a review of recent developments and applications10.1016/S0042-207X(99)00189-X ↗
10. Optimisation of HiPIMS photocatalytic titania coatings for low temperature deposition10.1016/j.surfcoat.2014.02.020 ↗
11. Deposition of photocatalytic titania coatings on polymeric substrates by HiPIMS10.1016/j.vacuum.2012.05.003 ↗
12. HiPIMS deposition of tungsten-doped titania coatings for photocatalytic applications10.1016/j.vacuum.2013.11.007 ↗
13. Structural formation and photocatalytic activity of magnetron sputtered titania and doped-titania coatings10.3390/molecules191016327 ↗
14. Photocatalytic property of TiO2 thin films sputtered-deposited on unheated substrates10.1016/j.apsusc.2009.05.155 ↗
15. The effect of O2 partial pressure on the structure and photocatalytic property of TiO2 films prepared by sputtering10.1016/j.matchemphys.2004.10.038 ↗
16. The effect of argon pressure on the structural and photocatalytic characteristics of TiO2 thin films deposited by d.c. magnetron sputtering10.1016/j.tsf.2005.12.247 ↗
17. Influences of working pressure on properties for TiO2 films deposited by DC pulse magnetron sputtering10.1016/S1001-0742(08)62334-7 ↗
18. Control of the visible and UV light water splitting and photocatalysis of nitrogen doped TiO2 thin films deposited by reactive magnetron sputtering10.1016/j.apcatb.2013.06.028 ↗
19. Best compromise for photocatalytic activity and hydrophilicity: N-doped TiO2 films under UV light10.1007/s10971-016-4189-7 ↗
20. Effect of substrate roughness and working pressure on photocatalyst of N-doped TiOx films prepared by reactive sputtering with air10.1016/j.apsusc.2014.10.173 ↗
21. Doping TiO2 with p-block elements: effects on photocatalytic activity10.1016/j.jphotochemrev.2012.09.002 ↗
22. Visible-light photocatalysis in nitrogen-doped titanium oxides10.1126/science.1061051 ↗
23. Optical Properties and Electronic Structure of Amorphous Germanium10.1002/pssb.19660150224 ↗
24. Deposition of visible light-active C-doped titania films via magnetron sputtering using CO2 as a source of carbon10.3390/nano7050113 ↗
25. Optimization studies of photocatalytic tungsten-doped titania coatings deposited by reactive magnetron co-sputtering10.3390/coatings3040194 ↗
26. Ti 2p and O 1s core levels and chemical bonding in titanium-bearing oxides10.1016/j.elspec.2006.02.004 ↗
27. Study of the bandgap of synthesized titanium dioxide nanoparticules using the sol-gel method and a hydrothermal treatment10.2174/1874088X01004020009 ↗
28. Low-temperature sputtering of crystalline TiO2 films10.1116/1.2187993 ↗
29. Surface morphology of magnetron sputtered TiO2 films10.1002/ppap.200730906 ↗
30. Nanostructure of photocatalytic TiO2 films sputtered at temperatures below 200°C10.1016/j.apsusc.2007.12.003 ↗
31. The distribution of ion energies at the substrate in an asymmetric bi-polar pulsed DC magnetron discharge10.1088/0963-0252/11/2/307 ↗
32. The influence of pulse frequency and duty on the deposition rate in pulsed magnetron sputtering10.1002/ppap.200600159 ↗
33. Effect of N2 flow rate on the properties of N doped TiO2 films deposited by DC coupled RF magnetron sputtering10.1016/j.jallcom.2016.03.247 ↗
34. Effect of total and oxygen partial pressures on structure of photocatalytic TiO2 films sputtered on unheated substrate10.1016/S0257-8972(01)01553-5 ↗
35. Effect of oxygen and nitrogen concentration of nitrogen doped TiOx film as photocatalyst prepared by reactive sputtering10.1016/j.apcata.2009.10.011 ↗