journal article·2020-12

Impact of substrate type on the surface and properties of electrodeposited Cu2O nanostructure films as an absorber layer for solar cell applications

Walid Ismail, Nagi M. El-Shafai, Abdelhamid El-Shaer, Mahmoud Abdelfatah

Publisher page

Abstract

Abstract Low cost electrodeposition method was employed to grow Cu2O nanostructure thin films on different conductive substrates (Au, ITO, and FTO). Here for first time, influence of substrate on morphology, structural, and optical properties of electrodeposited thin films as active layer for solar cell applications were investigated employing scanning electron microscopy, X-ray diffraction, Uv–vis spectroscopy, and photoluminescence. The results indicate single-phase formation of polycrystalline cubic structure of Cu2O thin film on the three substrates. Only the (111) diffraction plane was appeared on ITO and Au substrates demonstrating a good crystal quality. The formed Cu2O on Au substrate have the smallest grain sizes and highest surface area. Optical results show that the fabricated Cu2O films have band gap of 2.03, 2.03 and 1.93 eV for Au, ITO, and FTO substrates respectively. The grown Cu2O crystals on Au substrate have the lowest PL intensity that indicate the higher performance to separate the photogenerated carriers and lowest recombination rate as well as high crystal quality. I–V characteristic curves of the fabricated thin films showed that samples have a non-linear rectification behavior while Cu2O deposited on Au substrate has the highest forward current. I–V results confirmed and supported all the other obtained results from XRD, SEM, and PL techniques. Therefore, the results designate that the electrodeposited Cu2O thin film on Au substrate is the most favorable for solar cell applications.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Copper-based nanomaterials and applications · ZnO doping and properties · Electronic and Structural Properties of Oxides

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (38)

Show source-provided references
1. Self-assembly of porphyrin on graphene oxide in aqueous medium: fabrication, characterization, and photocatalytic studies10.1039/c9pp00088g ↗
2. Template-free hydrothermal synthesis of CuO/Cu2O composite hollow microspheres10.1021/cm070386d ↗
3. Effect of oxygen partial pressure on the tuning of copper oxide thin films by reactive sputtering for solar light driven photocatalysis10.1016/j.solener.2019.05.057 ↗
4. Fabrication and characterization of low cost Cu2O/ZnO: Al solar cells for sustainable photovoltaics with earth abundant materials10.1016/j.solmat.2015.11.015 ↗
5. Fabrication and characterization of flexible solar cell from electrodeposited Cu2O thin film on plastic substrate10.1016/j.solener.2015.11.002 ↗
6. Potentiostatic electrodeposition under light irradiation for preparation of highly photoactive Cu2O for water splitting applications10.1016/j.apsusc.2018.05.225 ↗
7. Electrodeposition and characterization of Cu2O thin films using sodium thiosulfate as an additive for photovoltaic solar cells10.1016/j.cjche.2017.06.023 ↗
8. Effect of potentiostatic and galvanostatic electrodeposition modes on the basic parameters of solar cells based on Cu2O thin films10.1149/2.0191606jss ↗
9. Temperature dependence on p-Cu2O thin film electrochemically deposited onto copper substrate10.1016/j.apsusc.2014.02.085 ↗
10. Effect of deposition parameters on electrodeposited cuprous oxide thin films
11. Controlled growth of Cu2O thin films by electrodeposition approach10.1016/j.mssp.2017.02.012 ↗
12. Fabrication of TiO2/Cu2O heterojunction solar cells by electrophoretic deposition and electrodeposition10.1016/j.mssp.2013.05.004 ↗
13. Towards low cost fabrication of inorganic white light emitting diode based on electrodeposited Cu2O thin film/TiO2 nanorods heterojunction10.1016/j.materresbull.2019.04.005 ↗
14. Low cost inorganic white light emitting diode based on submicron ZnO rod arrays and electrodeposited Cu2O thin film10.1016/j.mssp.2018.03.004 ↗
15. Electronic structure engineering of Cu2O film/ZnO nanorods array all-oxide pn heterostructure for enhanced photoelectrochemical property and self-powered biosensing application10.1038/srep07882 ↗
16. High performance Cu/Cu2O nanohybrid electrocatalyst for nonenzymatic glucose detection10.1039/C6TB01158F ↗
17. Synergy effect over electrodeposited submicron Cu2O films in photocatalytic degradation of methylene blue10.1016/j.apsusc.2012.01.122 ↗
18. Controllable preparation, characterization and performance of Cu2O thin film and photocatalytic degradation of methylene blue using response surface methodology10.1016/j.materresbull.2015.01.009 ↗
19. Homogeneous Cu2O pn junction photocathodes for solar water splitting10.1016/j.apcatb.2017.12.022 ↗
20. Facile synthesis of Cu2O microstructures and their morphology dependent electrochemical supercapacitor properties10.1039/C5RA20331G ↗
21. Synthesis of hierarchical Cu2O octahedra@ Ni(OH)2 nanosheets core-shell heterostructures for high-performance supercapacitor10.1016/j.mssp.2018.11.004 ↗
22. Solution‐Processed high‐quality Cu2O thin films as hole transport layers for pushing the conversion efficiency limit of Cu2O/Si heterojunction solar cells10.1002/solr.201900339 ↗
23. Solution-processed SnO2 interfacial layer for highly efficient Sb2Se3 thin film solar cells10.1016/j.nanoen.2019.04.019 ↗
24. A sputtered CdS buffer layer for co-electrodeposited Cu2ZnSnS4 solar cells with 6.6% efficiency10.1039/C5CC01170A ↗
25. 7.1% efficient co-electroplated Cu2ZnSnS4 thin film solar cells with sputtered CdS buffer layers10.1039/C5GC02057C ↗
26. One-step synthesis of flower-like Cu2O photoelectric materials by hydrothermal method10.1016/j.solener.2019.06.014 ↗
27. Positron annihilation study of the interfacial defects in ZnO nanocrystals: correlation with ferromagnetism
28. Effect of KOH molarity and annealing temperature on ZnO nanostructure properties10.1016/j.cjph.2018.03.015 ↗
29. Effect of conductive substrate on the photoelectrochemical properties of Cu2O film electrodes for methyl viologen reduction10.1016/j.jphotochem.2019.112254 ↗
30. Cu2O-HTM/SiO2-ETM assisted for synthesis engineering improving efficiency and stability with heterojunction planar perovskite thin-film solar cells10.1016/j.solener.2020.04.077 ↗
31. Direct Z-scheme of Cu2O/TiO2 enhanced self-cleaning, antibacterial activity, and UV protection of cotton fiber under sunlight10.1016/j.apsusc.2019.02.169 ↗
32. Automated method for the determination of the band gap energy of pure and mixed powder samples using diffuse reflectance spectroscopy10.1016/j.heliyon.2019.e01505 ↗
33. Magnetite nano-spherical quantum dots decorated graphene oxide nano sheet (GO@Fe3O4): electrochemical properties and applications for removal heavy metals, pesticide and solar cell10.1016/j.apsusc.2019.144896 ↗
34. Correlation between photoluminescence and positron annihilation lifetime spectroscopy to characterize defects in calcined MgO nanoparticles as a first step to explain antibacterial activity10.1016/j.jallcom.2019.152799 ↗
35. Effect of the thickness of the ZnO buffer layer on the properties of electrodeposited p-Cu2O/n-ZnO/n-AZO heterojunctions10.1039/C6RA04834J ↗
36. Three kinds of Cu2O/ZnO heterostructure solar cells fabricated with electrochemical deposition and their structure-related photovoltaic properties10.1039/c1ce05540b ↗
37. Growth and characterization of electrodeposited Cu2O thin films10.1088/0268-1242/28/11/115005 ↗
38. Structural, optical, and electrical properties of Cu2O nanocubes grown on indium-tin-oxide-coated glass substrates by using seed-layer-free electrochemical deposition method10.1016/j.apsusc.2012.04.091 ↗