journal article·2018-03

Effect of post-annealing on the properties of thermally evaporated molybdenum oxide films: Interdependence of work function and oxygen to molybdenum ratio

Baichao Han, Ming Gao, Yazhou Wan, Yong Li, Wenlei Song, Zhongquan Ma

Publisher page

Abstract

Molybdenum oxide (MoO x, x < 3) thin films were deposited on glass and (100) silicon substrates by thermal evaporation technique. Post-annealing of the samples was performed in O 2 by rapid thermal process at 373–673 K. The surface chemical, structural,morphological and optical properties of the samples were investigated. X-ray photoelectron spectra characterization verified the growth of sub-stoichiometric MoO x films as the coexistence of oxidation states of Mo 6+ and Mo 5+. The O/Mo ratio of MoO x films increases from 2.58 to 2.75 when the annealing temperature increases to 473 K, but this ratio rapidly decreases at higher temperatures. The work function of MoO x films is proportional to O/Mo ratio and within the range of 5.40–5.95 eV. This correlation can be ascribed to the variation of Fermi level and surface dipole with oxygen vacancy. The MoO x films are polycrystalline with nanoparticles, and both α- and β-phase MoO 3 are co-existed with the annealing temperature from 373 K to 673 K . The optical band gap of MoO x films is in the scope of 2.72–2.95 eV. The three critical properties of MoO x films, such as work function, optical band gap and transmittance, are well-correlated to the variation of chemical configuration with the annealing temperature.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Transition Metal Oxide Nanomaterials · Semiconductor materials and devices · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (41)

Show source-provided references
1. Alteration of architecture of MoO3 nanostructures on arbitrary substrates: growth kinetics, spectroscopic and gas sensing properties10.1039/C4NR04529G ↗
2. Sol-gel prepared MoO3-WoO3 thin films for O2 gas sensing10.1016/S0925-4005(01)00738-9 ↗
3. Colouration of tungsten oxide films: a model for optically active coatings10.1016/S0927-0248(98)00196-2 ↗
4. Transparent conductive electrodes for electrochromic devices: a review10.1007/BF00331211 ↗
5. Effect of surface species on activity and selectivity of MoO3/SiO2 catalysts in partial oxidation of methane to formaldehyde10.1007/BF00765197 ↗
6. 22.5% efficient silicon heterojunction solar cell with molybdenum oxide hole collector10.1063/1.4928747 ↗
7. Hole selective MoOx contact for silicon solar cells10.1021/nl404389u ↗
8. Silicon heterojunction solar cell with passivated hole selective MoOx contact10.1063/1.4868880 ↗
9. Towards a high efficiency amorphous silicon solar cell using molybdenum oxide as a window layer instead of conventional p-type amorphous silicon carbide10.1063/1.3624591 ↗
10. Transition metal oxides as hole-selective contacts in silicon heterojunctions solar cells10.1016/j.solmat.2015.08.028 ↗
11. Interaction at the silicon/transition metal oxide heterojunction interface and its effect on the photovoltaic performance10.1039/C5CP05309A ↗
12. Low-temperature atomic layer deposition of MoOx for silicon heterojunction solar cells10.1002/pssr.201510117 ↗
13. Investigation of CVD molybdenum oxide films10.1016/S0167-577X(01)00486-4 ↗
14. Preparation of molybdenum oxide thin films by MOCVD10.1016/j.jallcom.2006.08.227 ↗
15. Characterization of reactively sputtered molybdenum oxide films for solar cell application
16. Substrate temperature influenced structural, electrical and optical properties of dc magnetron sputtered MoO3 films10.1016/j.apsusc.2009.11.086 ↗
17. Effect of oxygen partial pressure on the structural and optical properties of dc reactive magnetron sputtered molybdenum oxide films10.1016/j.cap.2009.06.005 ↗
18. Processing and charge state engineering of MoOx10.1063/1.4974880 ↗
19. Transition metal oxides for organic electronics: energetics, device physics and applications10.1002/adma.201201630 ↗
20. Origin of the high work function and high conductivity of MoO310.1063/1.4903538 ↗
21. Transition metal oxide work functions: the influence of cation oxidation state and oxygen vacancies10.1002/adfm.201200615 ↗
22. Silicon heterojunction solar cell with interdigitated back contacts for a photoconversion efficiency over 26%10.1038/nenergy.2017.32 ↗
23. Properties of intrinsic and doped a-Si:H deposited by remote plasma enhanced chemical vapor deposition10.1116/1.575244 ↗
24. Effective passivation and tunneling hybrid a-SiOx(In) layer in ITO/n-Si heterojunction photovoltaic device10.1021/acsami.7b01447 ↗
25. Crist · 2000 · 408
26. Transparent conducting oxides for photovoltaics: manipulation of fermi level, work function and energy band alignment10.3390/ma3114892 ↗
27. Theoretical and experimental study of the electronic structures of MoO3 and MoO210.1021/jp9093172 ↗
28. Exfoliation solvent dependent plasmon resonances in two-dimensional sub-stoichiometric molybdenum oxide nanoflakes10.1021/acsami.5b12076 ↗
29. High-performance field effect transistors using electronic inks of 2D molybdenum oxide nanoflakes10.1002/adfm.201503698 ↗
30. Tunable plasmon resonances in two-dimensional molybdenum oxide nanoflakes10.1002/adma.201306097 ↗
31. Ab initio Fermi surface and conduction-band calculations in oxygen-reduced MoO310.1103/PhysRevB.68.075106 ↗
32. Neamen · 2003 · 284
33. Work function recovery of air exposed molybdenum oxide thin films10.1063/1.4748978 ↗
34. Fast recovery of the high work function of tungsten and molybdenum oxides via microwave exposure for efficient organic photovoltaics10.1021/jz500612p ↗
35. Characterization of molybdenum oxide films prepared by bias magnetron sputtering
36. Characteristics of molybdenum trioxide nanobelts prepared by thermal evaporation technique10.1016/j.matchemphys.2008.10.018 ↗
37. Impact of Dy on structural, dielectric and magnetic properties of Li-Tb-nanoferrites synthesized by micro-emulsion method10.1016/j.ceramint.2017.01.075 ↗
38. Β-MoO3: a Metastable analogue of WoO310.1039/C39860000336 ↗
39. Pankove · 1971 · 34
40. Optical absorption studies in molybdenum trioxide10.1002/pssa.2211480114 ↗
41. Effect of the oxygen sub-stoichiometry and of hydrogen insertion on the formation of intermediate bands within the gap of disordered molybdenum oxide films10.1021/jp407354j ↗