journal article·2017-11

Influence of Cu doping on physical properties of sol-gel processed SnS thin films

Purusottam Reddy Bommireddy, Chandra Sekhar Musalikunta, Chalapathi Uppala, Si-Hyun Park

Publisher page

Abstract

Abstract Copper-doped tin sulfide thin films (Cu-SnS) with different Cu doping concentrations were prepared by using the spin coating technique and their structural, electrical, and optical properties were studied. All the prepared films were polycrystalline and exhibited diffraction peaks corresponding to orthorhombic SnS with the preferred (111) orientation. The XRD spectra revealed improvement in the preferential orientation and crystalline quality with up to 4% Cu doping concentration, whereas Cu doping concentrations above 4% deteriorate the preferential orientation and crystalline quality. It has been observed that upon Cu doping the band gap decreased significantly from 1.46 eV (pure SnS) to 1.37 eV (4% of Cu-doped SnS). Hall measurements revealed the p-type semiconducting nature of the SnS thin films. The observations revealed that doping of SnS with Cu causes a noticeable drop in the room-temperature resistivity value from 105 Ω-cm for pure SnS to 103 Ω-cm for 4% Cu-doped SnS.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (27)

Show source-provided references
1. An efficient way to assemble ZnS nanobelts as ultraviolet-light sensors with enhanced photocurrent and stability10.1002/adfm.200901878 ↗
2. ZnS thin films for visible-light active photoelectrodes: Effect of film morphology and crystal structure10.1021/acs.cgd.5b01590 ↗
3. Copper sulphide (CuxS) as an ammonia gas sensor working at room temperature10.1016/j.snb.2008.02.015 ↗
4. Highly selective and sensitive CdS thin film sensors for detection of NO2 gas10.1039/C4RA06531J ↗
5. Surface spectroscopy study of CdSe and CdS thin-film oxygen sensors10.1016/0925-4005(94)87020-9 ↗
6. One-step solvothermal synthesis of different morphologies CuS nanosheets compared as supercapacitor electrode materials10.1016/j.jallcom.2014.11.137 ↗
7. Yousefi · 2014 · 189
8. One-pot synthesis of SnS nanorods and their lithium storage properties10.1007/s11581-013-1018-7 ↗
9. Cubic and orthorhombic SnS thin-film absorbers for tin sulfide solar cells10.1002/pssa.201532426 ↗
10. A. Yago, S. Sasagawa, Y. Akaki, S. Nakamura, H. Oomae, H. Katagiri, H. Araki, Comparison of buffer layers on SnS thin-film solar cells prepared by co-evaporation, physica status solidi c 1600194-n/a, 2017.10.1002/pssc.201600194 ↗
11. A review of tin (II) monosulfide and its potential as a photovoltaic absorber10.1016/j.solmat.2015.12.001 ↗
12. R.E. Banai, H. Lee, N.J. Tanen, R.E. Urena, J.J. Cordell, M.W. Horn, J.R.S. Brownson, Investigation of RF-sputtered tin sulfide thin films with in situ heating for photovoltaic applications, 2014 IEEE Proceedings of the 40th Photovoltaic Specialist Conference (PVSC), 2014, pp. 0290–0294.10.1109/PVSC.2014.6924916 ↗
13. Organotin Dithiocarbamates: single-source Precursors for tin sulfide thin films by aerosol-assisted chemical vapor deposition (AACVD)10.1021/cm301660n ↗
14. Improved mobility of sol-gel method processed transparent tin sulfide thin films10.1016/j.matlet.2016.04.203 ↗
15. Broad spectral response of Se-Doped SnS nanorods synthesized through electrodeposition10.1002/celc.201600826 ↗
16. Annealing of RF-magnetron sputtered SnS2 precursors as a new route for single phase SnS thin films10.1016/j.jallcom.2013.12.200 ↗
17. Effect of Sb dopant on the structural, optical and electrical properties of SnS thin films by spray pyrolysis technique10.1016/j.saa.2013.06.112 ↗
18. Antimony-Doped Tin(II) sulfide thin films10.1021/cm3024988 ↗
19. Thermally evaporated SnS:Cu thin films for solar cells10.1049/mnl.2011.0121 ↗
20. Physical properties of spray pyrolyzed Ag-doped SnS thin films for opto-electronic applications10.1016/j.matlet.2014.05.186 ↗
21. Effect of doping concentration on the properties of bismuth doped tin sulfide thin films prepared by spray pyrolysis10.1016/j.mssp.2013.09.012 ↗
22. Enhanced photovoltaic performance of tin sulfide nanoparticles by indium doping10.1557/mrc.2016.48 ↗
23. Investigation of the characteristics of the boron doped MnO films deposited by spray pyrolysis method10.12693/APhysPolA.129.1159 ↗
24. Hall–Petch relation and boundary strengthening10.1016/j.scriptamat.2004.06.002 ↗
25. Effect of copper doping on physical properties of nanocrystallized SnS zinc blend thin films grown by chemical bath deposition10.1007/s10853-011-5912-y ↗
26. Review on Tin (II) Sulfide (SnS) Material: synthesis, Properties, and Applications10.1080/10408436.2015.1053601 ↗
27. SnS nanosheet films deposited via thermal evaporation: the effects of buffer layers on photovoltaic performance10.1016/j.solmat.2016.04.006 ↗