Thermal stability of ZnO thin films fabricated by pulsed laser deposition
Source abstract
Abstract
Abstract This paper shows the results of investigation of stability of resistivity of polycrystalline and nanocrystalline ZnO thin films obtained by pulsed laser deposition (PLD) under thermal cycling in the range from 30 °C to 300 °C. The results show that stability of resistivity during thermal cycling depends on PLD modes, post-growth annealing, and composition of the target used in PLD process. It was established that increasing annealing temperature to 750 °C allows fabricating ZnO thin films with high stability of temperature-resistivity dependence. The films obtained by ablation of ZnO target with post-growth annealing in oxygen (annealing temperature 750 °C, 10 h) possess better stability parameter ( R stab =0.99), which proves the possibility of formation of ZnO thin films with high stability of temperature-resistivity dependence under thermal cycling.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: ZnO doping and properties · Gas Sensing Nanomaterials and Sensors · Transition Metal Oxide Nanomaterials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (19)
Show source-provided references
1. Solid state gas sensor Research in Germany — a status Report10.3390/s90604323 ↗
2. Recent advances in wide bandgap semiconductor biological and gas sensors10.1016/j.pmatsci.2009.08.003 ↗
3. Metal oxide semi–conductor gas sensors in environmental monitoring10.3390/s100605469 ↗
4. metal and metal oxide nanoparticles in chemiresistors: does the Nanoscale matter10.1002/smll.200500261 ↗
5. Metal oxide gas sensors: sensitivity and influencing factors10.3390/s100302088 ↗
6. Gas response control through structural and chemical modification of metal oxide films: state of the art and approaches10.1016/j.snb.2004.10.006 ↗
7. The role of morphology and crystallographic structure of metal oxides in response of conductometric–type gas sensors10.1016/j.mser.2008.02.001 ↗
8. Role of low O2 pressure and growth temperature on electrical transport of PLD grown ZnO thin films on Si substrates10.1016/j.sse.2006.04.025 ↗
9. The influence of substrate temperature on ZnO thin films prepared by PLD technique10.1016/j.jcrysgro.2007.07.025 ↗
10. Application of pulsed laser deposited zinc oxide films to thin film transistor device10.1016/j.tsf.2007.06.068 ↗
11. Comparative study of ZnO thin film prepared by pulsed laser deposition – Comparison of influence of different ablative lasers
12. Effect of oxygen partial pressure on structural and optical properties of pulsed laser deposited CaBi4Ti4O15 thin films10.1016/j.apsusc.2016.11.068 ↗
13. Nanocrystalline ZnO films grown by PLD for NO2 and NH3 sensor
14. Selective growth of epitaxial Sr2IrO4 by controlling plume dimensions in pulsed laser deposition10.1063/1.4967450 ↗
15. Pulsed Laser Deposition (PLD)
16. Instability of metal oxide—based conductometric gas sensors and approaches to stability improvement (short survey)10.1016/j.snb.2011.02.024 ↗
17. Thermal stability study of La0.9Sr0.1Ga0.8Mg0.2O2.85—(Li/Na)2CO3 composite electrolytes for low—temperature solid oxide fuel cells10.1016/j.ijhydene.2014.02.094 ↗
18. Effects of transition metal additives on redox stability and high-temperature electrical conductivity of (Fe, Mg)3O4 spinels10.1016/j.jeurceramsoc.2014.02.016 ↗
19. Resistivity of atomic layer deposition grown ZnO: the influence of deposition temperature and post-annealing10.1016/j.tsf.2016.02.060 ↗