journal article·2026-06-10

Effect of strain rate and temperature on the compression behavior and dynamic recrystallization of AA3003-F aluminum alloy

Daniel Bedoya, Jérôme Serri, Thierry Mazet, Gaëtan Bergin, Eric Fleury

Publisher page

Abstract

This study examined the thermomechanical response and microstructural evolution of AA3003 aluminum alloy in the as-fabricated F-temper during compression from room temperature to 550°C at strain rates ranging from 5 × 10 − 5 s − 1 to 5 × 10 − 2 s − 1 . The initially heterogeneously deformed microstructure of the F-temper alloy promoted recovery and recrystallization. For temperatures below 250°C, the flow curves exhibited moderate strain hardening followed by softening, whereas above 250°C, especially at low strain rates and near 350°C, the mechanical behavior was characterized by a stabilized flow stress and marked strain-rate sensitivity. Electron backscatter diffraction (EBSD) revealed that continuous dynamic recrystallization (CDRX), i.e., progressive subgrain rotation and boundary-misorientation increase leading to new grains, dominated at high strain rates, whereas a transition toward concurrent CDRX and discontinuous dynamic recrystallization (DDRX), i.e., nucleation and growth of new strain-free grains, occurred at lower strain rates, with an estimated transition Zener–Hollomon value around Z ≈ 2 . 92 × 10 9 s − 1 . These findings provided valuable insight into the interplay between deformation parameters, dynamic softening mechanisms, and microstructural refinement in AA3003-F.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Metallurgy and Material Forming · Metal Forming Simulation Techniques · Microstructure and mechanical properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Université de Lorraine, CNRS, Arts et Métiers Institute of Technology, LEM3

Alfa Laval Golbey, Golbey, France

Funding

ANRT

References (69)

Show source-provided references
1. Kaufman JG. Introduction to aluminum alloys and tempers. Materials Park, OH: ASM International, 2000, ISBN 978-0-87170-689-8.
2. Properties of Wrought Aluminum and Aluminum Alloys. In ASM Handbook Committee (ed.) Properties and Selection: Nonferrous Alloys and Special-Purpose Materials. ASM Inter-national. ISBN 978-1-62708-162-7 1990. pp. 62–122. DOI:10.31399/asm.hb.v02.a0001060. URL http://dl.asminternational.org/handbooks/book/14/chapter/ 201862/Properties-of-Wrought-Aluminum-and-Aluminum-Alloys.10.31399/asm.hb.v02.a0001060 ↗
3. Kissell JR Pantelakis SG Haidemenopoulos GN. Aluminum and aluminum alloys. In: Wessel JK (ed.) Handbook of advanced materials. 1 ed. Hoboken NJ: Wiley 2004 pp.321–463. ISBN 978-0-471-45475-5 978-0-471-46518-8. DOI:10.1002/0471465186.ch9. URL https://onlinelibrary.wiley.com/doi/10.1002/0471465186.ch9.10.1002/0471465186.ch9 ↗
4. Aluminum and Aluminum Alloys. In Davis J (ed.) Alloying: Understanding the Basics. ASM International. ISBN 978-1-62708-297-6 2001. p. 0. DOI:10.31399/asm.tb.aub.t61170351. URL https://doi.org/10.31399/asm.tb.aub.t61170351.10.31399/asm.tb.aub.t61170351 ↗
5. Aluminium and aluminium alloys - Wrought products - Temper designations 2023.
6. Alloy and Temper Designation Systems for Aluminum ANSI H35.1 / H35.1(M) 2009.
7. Aluminium and aluminium alloys – Wrought products – Temper designations 2017.
8. ASM handbook. 2: Properties and selection: nonferrous alloys and special-purpose materials. 7. print ed. Materials Park Ohio: ASM International. ISBN 978-0-87170-378-1 2007. Num Pages: 1328.
9. 10.3390/met1402023010.3390/met14020230 ↗
10. 10.3390/met1205077710.3390/met12050777 ↗
11. Morawiec A. On recrystallization nucleation in pure aluminum 2023. DOI:10.48550/ARXIV. 2305.08378. URL https://arxiv.org/abs/2305.08378. Version Number: 1.
12. 10.1016/j.matchar.2020.11043810.1016/j.matchar.2020.110438 ↗
13. 10.1016/j.msea.2020.13952210.1016/j.msea.2020.139522 ↗
14. 10.1016/j.msea.2010.05.05310.1016/j.msea.2010.05.053 ↗
15. 10.1016/j.mtcomm.2020.10096510.1016/j.mtcomm.2020.100965 ↗
16. 10.17222/mit.2017.17610.17222/mit.2017.176 ↗
17. 10.3390/ma1407170110.3390/ma14071701 ↗
18. 10.1016/S0921-5093(97)00424-310.1016/S0921-5093(97)00424-3 ↗
19. 10.1016/S0079-6425(97)00007-810.1016/S0079-6425(97)00007-8 ↗
20. 10.1016/j.jallcom.2003.10.06710.1016/j.jallcom.2003.10.067 ↗
21. 10.1016/S1359-6454(03)00078-810.1016/S1359-6454(03)00078-8 ↗
22. 10.1590/S1516-1439200500030000210.1590/S1516-14392005000300002 ↗
23. Cotterill P, Mould PR. Recrystallization and grain growth in metals. London: Surrey Univ. Press, 1976, ISBN 978-0-903384-11-7.
24. Rollett AD, Humphreys FJ, Rohrer GS, et al. Recrystallization and related annealing phenomena. Third edition ed. Amsterdam: Elsevier, 2017, ISBN 978-0-08-098235-9.
25. 10.1007/s11661-002-0022-810.1007/s11661-002-0022-8 ↗
26. 10.1016/j.ijmachtools.2021.10381510.1016/j.ijmachtools.2021.103815 ↗
27. 10.3390/ma701024410.3390/ma7010244 ↗
28. 10.1016/j.pmatsci.2013.09.00210.1016/j.pmatsci.2013.09.002 ↗
29. 10.1016/j.matdes.2016.09.01210.1016/j.matdes.2016.09.012 ↗
30. 10.1016/S0921-5093(00)00733-410.1016/S0921-5093(00)00733-4 ↗
31. 10.1051/metal:200217410.1051/metal:2002174 ↗
32. 10.1016/j.actamat.2008.10.02110.1016/j.actamat.2008.10.021 ↗
33. 10.1016/j.pnsc.2018.09.00610.1016/j.pnsc.2018.09.006 ↗
34. 10.1016/S1003-6326(11)60733-410.1016/S1003-6326(11)60733-4 ↗
35. 10.1016/j.msea.2018.07.06810.1016/j.msea.2018.07.068 ↗
36. 10.3390/ma1616559010.3390/ma16165590 ↗
37. 10.4028/www.scientific.net/MSF.790-791.35510.4028/www.scientific.net/MSF.790-791.355 ↗
38. 10.1016/j.msea.2005.08.18710.1016/j.msea.2005.08.187 ↗
39. 10.1016/S0921-5093(02)00245-910.1016/S0921-5093(02)00245-9 ↗
40. 10.1016/j.msea.2011.02.03010.1016/j.msea.2011.02.030 ↗
41. 10.1007/s11661-020-05908-910.1007/s11661-020-05908-9 ↗
42. 10.1007/s11665-021-05917-810.1007/s11665-021-05917-8 ↗
43. 10.1007/s11665-025-11561-310.1007/s11665-025-11561-3 ↗
44. 10.1016/j.jallcom.2013.03.02210.1016/j.jallcom.2013.03.022 ↗
45. 10.1016/j.euromechsol.2010.09.00110.1016/j.euromechsol.2010.09.001 ↗
46. 10.1016/j.matpr.2019.12.33210.1016/j.matpr.2019.12.332 ↗
47. 10.1515/htmp-2014-010810.1515/htmp-2014-0108 ↗
48. 10.1016/j.msea.2015.06.02610.1016/j.msea.2015.06.026 ↗
49. 10.1179/mht.2006.00510.1179/mht.2006.005 ↗
50. E28 Committee. Test Methods of Compression Testing of Metallic Materials at Room Temperature. DOI:10.1520/E0009-19. URL http://www.astm.org/cgi-bin/ resolver.cgi?E9-19.
51. E28 Committee. Practice for Compression Tests of Metallic Materials at Elevated Temperatures with Conventional or Rapid Heating Rates and Strain Rates. DOI: 10.1520/E0209-00E01. URL http://www.astm.org/cgi-bin/resolver.cgi? E209-00E1.
52. Beausir B Fundenberger JJ. Analysis Tools for Electron and X-ray diffraction ATEX 2017. URL http://www.atex-software.eu/.
53. Humphreys FJ. Recrystallization and Related Annealing Phenomena. Third edition ed. Amsterdam, Netherlands: Elsevier, 2017, ISBN 978-0-08-098235-9.
54. 10.1016/j.ijplas.2014.10.01310.1016/j.ijplas.2014.10.013 ↗
55. 10.1088/1742-6596/991/1/01201210.1088/1742-6596/991/1/012012 ↗
56. 10.1007/s11661-017-4406-110.1007/s11661-017-4406-1 ↗
57. 10.1016/j.matchar.2013.07.01310.1016/j.matchar.2013.07.013 ↗
58. 10.1016/S0921-5093(02)00555-510.1016/S0921-5093(02)00555-5 ↗
59. 10.1016/S1359-6454(03)00160-510.1016/S1359-6454(03)00160-5 ↗
60. 10.1016/S1003-6326(10)60104-510.1016/S1003-6326(10)60104-5 ↗
61. 10.1016/j.msea.2005.01.05310.1016/j.msea.2005.01.053 ↗
62. 10.3390/met1408088910.3390/met14080889 ↗
63. 10.3390/met1510110010.3390/met15101100 ↗
64. 10.3390/met1404044910.3390/met14040449 ↗
65. 10.1115/1.322588710.1115/1.3225887 ↗
66. 10.4028/www.scientific.net/AMM.66-68.161110.4028/www.scientific.net/AMM.66-68.1611 ↗
67. 10.1515/htmp-2012-010610.1515/htmp-2012-0106 ↗
68. 10.1557/jmr.2016.8110.1557/jmr.2016.81 ↗
69. 10.1016/j.msea.2024.14711710.1016/j.msea.2024.147117 ↗