journal article·1998-07-01

Hot rolling and superplastic forming response of net shape processed Ti-6AI-4V produced by centrifugal spray deposition

A. L. Dawson, P. Blackwell, M. Jones, J. M. Young, M. A. Duggan

Materials Science and Technology· Volume 14· Issue 7
Publisher page

Abstract

The hot rolling and superplastic forming response of Ti-6Al-4 V deposits, produced using a unique low pressure centrifugal spray deposition (LPCSD) facility, have been examined. Fundamental information has been generated relating to the parameters which govern microstructural development (porosity distribution, grain size, and α/β phase volume fraction) both during the deposition process and following post-spray thermomechanical processing. As sprayed deposits were characterised by relatively coarse transformed β microstructures, with α lath and prior β grain sizes varying from about 0.6 to 1.1 μm and from 70 to 400 μm respectively, depending on the spray forming environment (Ar or vacuum) and the position within the preform. Despite these coarse microstructural features, and relatively high levels of porosity, single and multipass hot rolling reductions of up to 80% were successfully achieved, yielding microstructures and strain rate sensitivity factors (m values) compatible with superplasticforming grade sheet specifications.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Metal and Thin Film Mechanics · Metal Alloys Wear and Properties · High-Velocity Impact and Material Behavior

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (2)

Show source-provided references
1. 1996 · 4 · 317
2. 10.1007/BF0266239610.1007/BF02662396 ↗