Defect formation and control of tungsten-based alloy forward extrusion bars during solvent debinding process
Source abstract
Abstract
Power Extrusion Molding(PEM) is one of the most effective way to fabricate tungsten heavy alloy rod with large aspect ratio.The debinding process affects the defect control of sample and the improvemnet of mechanical properties of alloy.In this paper,the formation and control of defects in forward extrusion rods(Φ12 mm and Φ15 mm) during solvent debinding process were discussed.Constant temperature controlling device was used to control solvent debinding rate,the surface and the microstructure of extrusion rods were observed by digital camera and Scanning Electron Microscope(SEM),respectively.The results showed that there was big residual stress in tungsten-based alloy extrusion rods,which was the major factor leading to the cracking of green rods extruded during solvent debinding process.The residual stress of the green rods could be relieved by an annealing process(at 40 ℃ annealing temperature),and it could effectively avoid the cracks.Under annealing at 40 ℃ and solvent debinding at 30 ℃ for 12 h,the rods structures were uniform with no defects,and the debinding efficiency levels of Φ12 mm and Φ15 mm could reach 40% and 30% respectively.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Advanced materials and composites · Aluminum Alloys Composites Properties · Microstructure and mechanical properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References
Reference metadata was not supplied for this record.