The changes of free surface shape of TiAl-based melt during induction melting with cold crucible
Source abstract
Abstract
By applying the cold crucible inductive melting(CCIM) to TiAl-based alloys,the qualities of the melt are able to be improved.Especially during the melting,the parameters for melting the molten metal should be optimized and thus controlled.This paper performs the melting procedure of Ti48Al(at%) alloy in a water cooling cold crucible based on an induction melting furnace.The free surface shapes of several batches for Ti48Al and a pure Ti have been measured by socking thin sheets of non-ferrite steel with cross interlock shape.Then the free surface heights are calculated and the empirical relations are put forward regressively about the free surface shape with respect to input power,charge mass and charge density respectively.The results show that increasing the input power and lowering down the charge mass will increase the free surface height of the melt.The free surface height of Ti48Al melt will be higher than that of a pure Ti melt with approximately same quantity in molten volume.As a result,the free surface of a molten TiAl-based alloy will become instability during cold crucible inductive melting when the input power is increased or the charge mass is decreased.This is due to the large differences present in physical parameters between TiAl-based alloys and a pure Ti,where the TiAl-based alloy usually occupies a lower density and a higher electrical conductivity.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Induction Heating and Inverter Technology · Aluminum Alloy Microstructure Properties · Aluminum Alloys Composites Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References
Reference metadata was not supplied for this record.