article·2015-01-01

Influence of drawing ratio on the residual stress in 304 stainless steel cylindrical drawing parts

Xiao Lianghon

Abstract

Longitudinal cracking easily happens in the mouth of 304 stainless steel cylindrical drawing parts,where one of the essential reasons is due to the large residual tensile stress in their outer wall. Combined with finite element analysis,the influence of the drawing ratio on residual stresses in 304 stainless steel cylindrical drawing cups wall was studied in this paper by nanoindentation tests. The main contents and results are as follow: The residual tensile stress in the outer wall of 304 stainless steel cylindrical drawing cup increased first and then decreased from the cup bottom to its mouth. The maximum residual stresses always appeared in the middle of the cylindrical cups wall along the height direction about at 60% wall height from the cup bottom. The maximum residual stresses in the outer wall of cylindrical cups with different drawing ratios of 1.43,1.54,1.67 and 1.82 were391.87,745.30,793.74 and 1 013.1 MPa,respectively,which were tested by nanoindentation.. They increased with the drawing ratio. By analysis and comparison of the reported literatures,the results were correct and reliable.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Metal and Thin Film Mechanics · Surface Treatment and Residual Stress · Metal Forming Simulation Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.